Philips Comfort LongLife GC1620 Manual

Philips Strygejern Comfort LongLife GC1620

Læs gratis den danske manual til Philips Comfort LongLife GC1620 (10 sider) i kategorien Strygejern. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Philips Comfort LongLife GC1620, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/10
www.philips.com
Comfort LongLife
GC1630, GC1620, GC1615
1234
5678
9 10 11 12
13 14 15 16
ENGLISH 2 - 4
5 - 7
8 - 10
Comfort LongLife GC1630, GC1620, GC1615ENGLISH24239 000 57961
General description.
A Spray nozzle
B Filling opening
C Spray button T
D Steam control
- = no steamO
- = moderate steamq
- w= maximum steam
- x= Calc-Clean function
E Extra-steam function (GC1630/GC1620)
F Electronic safety shut-off function (GC1630 only)
G Temperature dial
H Temperature light
I Mains cord
J Type plate
K Anti-calc tablet
L Water tank
Important.
Read these instructions for use carefully before using the appliance and save
them for future reference.
◗Check if the voltage indicated on the type plate corresponds to the
local mains voltage before you connect the appliance.
◗Do not use the appliance if the plug, the cord or the appliance itself is
damaged.
◗If the mains cord is damaged, it must be replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to
avoid a hazard.
◗Never leave the iron unattended when it is connected to the mains.
◗Never immerse the iron in water.
◗Infirm persons should not be allowed to use the appliance without
supervision. Keep the appliance out of the reach of children.
◗Do not put perfume, vinegar, starch, descaling agents, ironing aids or
other chemicals in the water tank.
◗The soleplate of the iron can become extremely hot and may cause
burns if touched. Do not allow the cord to come into contact with
the soleplate when it is hot.
◗When you have finished ironing, when you clean the appliance, when
you fill or empty the water tank and also when you leave the iron
even for a short while: set the steam control to position 0, put the
iron on its heel and remove the mains plug from the wall socket.
Before first use.
1Remove any sticker or protective foil from the soleplate.
2Let the iron heat up to maximum temperature and pass the iron over
a piece of damp cloth for several minutes to remove any residues
from the soleplate.
BThe iron may give off some smoke when you use it for the first time. This will
cease after a short while.
Preparing for use.
Filling the water tank
Never immerse the iron in water.
1Make sure the appliance is unplugged.
2Set the steam control to position O (= no steam) (fig. 1).
3Tilt the iron backwards.
4Fill the water tank with tap water up to the maximum level (fig. 2).
Do not fill the tank beyond the MAX indication.
◗If the tap water in your area is very hard, we advise you to mix it with
an equal amount of distilled water or to use distilled water only.
Do not put perfume, vinegar, starch, descaling agents, ironing additives,
chemically descaled water or other chemicals in the water tank.
Setting the temperature
1Put the iron on its heel.
2Set the required ironing temperature by turning the temperature dial
to the appropriate position (fig. 3).
Check the laundry care label for the required ironing temperature:
-1Synthetic fabrics (e.g. acrylic, nylon, polyamide, polyester)
-1Silk
- Wool2
- 3Cotton, linen
If you do not know what kind(s) of fabric(s) an article is made of, determine
the right ironing temperature by ironing a part that will not be visible when
you wear or use the article.
Silk, woollen and synthetic materials: iron the reverse side of the fabric to
prevent shiny patches. Avoid using the spray function to prevent stains.
Start ironing the articles that require the lowest ironing temperature, such
as those made of synthetic fibres.
3Put the mains plug in an earthed wall socket.
4When the temperature light has gone out, wait a while before you
start ironing (fig. 4).
The temperature light will go on from time to time during ironing.
Using the appliance.
Steam ironing
1Make sure that there is enough water in the water tank.
2Select the recommended ironing temperature (see chapter 'Preparing
for use', section 'Setting the temperature').
3After the temperature light has gone out, set the steam control to the
appropriate steam position. Make sure that the steam setting you
select is suitable for the ironing temperature selected: (fig. 5).
-qfor moderate steam (temperature settings 2to MAX)
-wfor maximum steam (temperature settings 3to MAX)
BThe iron will start steaming as soon as the set temperature has been
reached.
Ironing without steam
1Set the steam control to position O (= no steam).
2Select the recommended ironing temperature (see chapter 'Preparing
for use', section 'Setting the temperature').
Features.
Spray function
You can use the spray function to remove stubborn creases at any
temperature.
1Make sure that there is enough water in the water tank.
2Press the spray button several times to moisten the article to be
ironed (fig. 6).
Extra steam (GC1630/GC1620)
This function provides extra steam to remove very stubborn creases.
◗The extra-steam function only works at temperature settings
between and MAX.3
1Set the steam control to position w(= maximum steam) (fig. 7).
2Press and hold the steam control for a maximum of 5 seconds (fig. 8).
3Release the steam control and wait at least 1 minute before using this
function again to prevent water from dripping out of the soleplate.
Electronic safety shut-off function (GC1630 only)
The electronic safety shut-off function automatically switches off the iron if it
has not been moved for a while.
◗The auto-off light starts blinking to indicate that the iron has been
switched off by the safety shut-off function (fig. 9).
- In horizontal position, this will happen after 30 seconds.
- In vertical position, this will happen after 8 minutes.
◗To let the iron heat up again:
- Pick up the iron or move it slightly.
- The auto-off light goes out and the temperature light goes on.
- When the temperature light has gone out and goes on again, the iron is
ready for use.

Produkt Specifikationer

Mærke: Philips
Kategori: Strygejern
Model: Comfort LongLife GC1620

Har du brug for hjælp?

Hvis du har brug for hjælp til Philips Comfort LongLife GC1620 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Strygejern Philips Manualer

Philips

Philips 2000 series PSG2000 Manual

14 August 2025
Philips

Philips GC1442 Manual

14 August 2025
Philips

Philips 1000 Series DST1010 Manual

14 August 2025
Philips

Philips PerfectCare PSG8200 Manual

30 Juli 2025
Philips

Philips PerfectCare 8000 Series PSG8300 Manual

24 Juli 2025
Philips

Philips PerfectCare GC3925 Manual

10 Juli 2025
Philips

Philips PerfectCare Pure GC7610 Manual

10 Juli 2025
Philips

Philips PerfectCare Expert GC9242 Manual

10 Juli 2025
Philips

Philips PerfectCare GC392 Manual

9 Juli 2025
Philips

Philips PerfectCare Elite GC9611 Manual

9 Juli 2025

Strygejern Manualer

Nyeste Strygejern Manualer

Tefal

Tefal Aquaspeed FV5177 Manual

14 August 2025
Tefal

Tefal Express Steam FV2868 Manual

14 August 2025
Tefal

Tefal ECOMASTER FV1750 Manual

14 August 2025
Tefal

Tefal Supergliss FV3825 Manual

14 August 2025
Tefal

Tefal Express Power SV8001E1 Manual

14 August 2025
Tefal

Tefal Steam Essential FV1026 Manual

14 August 2025
Tefal

Tefal Express Compact Anti-Calc GV7095 Manual

13 August 2025
Tefal

Tefal Access FV1534 Manual

13 August 2025
Tefal

Tefal Access Steam Minute DT7005 Manual

13 August 2025
Tefal

Tefal Prima Plus FV3321 Manual

13 August 2025