Philips HD1125 Manual

Philips Jern HD1125

Læs gratis den danske manual til Philips HD1125 (5 sider) i kategorien Jern. Denne vejledning er vurderet som hjælpsom af 38 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 19.5 anmeldelser. Har du et spørgsmål om Philips HD1125, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

HD1100 Series

A B C D

50-6 0Hz

TY PE H D

220-2 30

V~001 7

11 C1000 W

Ma de in S

in gap ore

2345

ENGLISH

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips offers,

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

Never immerse the iron in water.

Warning

Check if the voltage indicated on the type plate

corresponds to the local mains voltage before you

connect the appliance.

Do not use the appliance if the plug, the mains cord

or the appliance itself shows visible damage, or if the

appliance has been dropped.

If the mains cord is damaged, you must have it

replaced by Philips, a service centre authorised by

Philips or similarly qualied persons in order to avoid

a hazard.

Never leave the appliance unattended when it is

connected to the mains.

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to ensure that they

do not play with the appliance.

Do not let the mains cord come into contact with

the hot soleplate of the iron.

Caution

Only connect the appliance to an earthed wall

socket.

Check the mains cord regularly for possible damage.

Always place and use the iron on a stable, level and

horizontal surface.

The soleplate of the iron can become extremely hot

and may cause burns if touched.

When you have nished ironing, when you clean the

appliance and also when you leave the iron even for

a short while: put the iron on its heel and remove

the mains plug from the wall socket.

The appliance is intended for household use only.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientic

evidence available today.

General description (Fig. 1)

A Temperature dial

B Temperature light

C Mains cord

D Heel

E Type plate

F Soleplate

Before first use

1 Remove any sticker or protective foil from the

soleplate.

2 Let the iron heat up to maximum temperature and

pass the iron over a piece of damp cloth for several

minutes to remove any residues from the soleplate.

Using the appliance

Setting the temperature

1 Put the iron on its heel.

2 To set the required ironing temperature, turn the

temperature dial to the appropriate position (Fig. 2).

Check the laundry care label for the required ironing

temperature:

1 Synthetic fabrics (e.g. acrylic, viscose, polyamide,

polyester)

1 Silk

2 Wool

3 Cotton, linen

If you do not know what kind or kinds of fabric an article

is made of, determine the right ironing temperature by

ironing a part that is not visible when you wear or use

the article.

Silk, woollen and synthetic materials: iron the reverse side

of the fabric to prevent shiny patches.

Start ironing the articles that require the lowest ironing

temperature, such as those made of synthetic bres.

3 Put the mains plug in an earthed wall socket.

Ironing

Note: The iron may give off some smoke when you use it for

the rst time. This stops after a short while.

1 Put the iron on its heel.

2 Put the mains plug in an earthed wall socket.

3 Set the recommended ironing temperature (see

section ‘Setting the temperature’ above) (Fig. 2).

4 Lettheironheatupuntilthetemperaturelightrst

goes out and then goes on again (Fig. 3).

Note: The temperature light goes on from time to time

during ironing.

5 Start ironing.

Tip: Ironing is easier and takes less time if you moisten the

article rst.

Cleaning

1 Put the iron on its heel.

2 Remove the mains plug from the wall socket and let

the iron cool down for at least 30 minutes.

3 Wipe the soleplate with a damp cloth and a non-

abrasive (liquid) cleaning agent.

To keep the soleplate smooth, avoid hard contact with

metal objects. Never use a scouring pad, vinegar or

other chemicals to clean the soleplate.

4 Clean the upper part of the iron with a damp cloth.

Storage

1 Put the iron on its heel.

2 Remove the mains plug from the wall socket and let

the iron cool down for at least 30 minutes.

3 Wind the mains cord round the cord storage

facility (Fig. 4).

4 Store the iron on its heel in a safe and dry

place (Fig. 5).

Environment

Do not throw away the appliance away with the

normal household waste at the end of its life,

but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve the

environment (Fig. 6).

Guarantee & service

If you need service or information or if you have a

problem, please visit the Philips website at www.philips.

com or contact the Philips Consumer Care Centre

in your country (you nd its phone number in the

worldwide guarantee leaet). If there is no Consumer

Care Centre in your country, go to your local Philips

dealer.

Troubleshooting

This chapter summarises the most common problems

you could encounter with the appliance. If you are unable

to solve the problem with the information below, contact

the Consumer Care Centre in your country.

Problem Possible cause Solution

The iron is plugged

in but the soleplate

is cold.

There is a connection problem. Check the mains cord, the plug and the wall socket.

The temperature dial is set to

MIN.

Set the temperature dial to the required position (see

section ‘Setting the temperature’ in chapter ‘Using the

appliance’).

4239.000.6100.2

2/5

Produkt Specifikationer

Mærke:	Philips
Kategori:	Jern
Model:	HD1125

Har du brug for hjælp?

Hvis du har brug for hjælp til Philips HD1125 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Jern Philips Manualer

Philips PerfectCare GC9223 Manual

10 Januar 2025

Philips PerfectCare Silence GC9550 Manual

10 Januar 2025

Philips 5000 Series DST5041 Manual

2 Januar 2025

Philips 5000 Series DST5031 Manual

2 Januar 2025

Philips 2000 Series DST2030 Manual

2 Januar 2025

Philips PerfectCare Xpress GC5020 Manual

2 Januar 2025

Philips GC7020 Manual

1 Januar 2025

Philips 5000 Series DST5010 Manual

21 December 2024

Philips Azur Elite GC5030 Manual

21 December 2024

Philips Azur 7000 Series DST7041 Manual

21 December 2024

Jern Manualer

Nyeste Jern Manualer

Trisa Classic Steam i6112 Manual

25 Februar 2025

Tefal Ultimate Pure FV9849 Manual

12 Februar 2025

Tefal Ultimate Pure FV9847 Manual

12 Februar 2025

Tefal Easygliss Eco FV5782 Manual

12 Februar 2025

Tefal Duo Power JF4031 Manual

12 Februar 2025

Tefal Ultraglide FV4042 Manual

12 Februar 2025

Rowenta Eco Intelligence DW6030 Manual

12 Februar 2025

Tefal Aquaspeed FV5325 Manual

12 Februar 2025

T-fal FV1030 Manual

11 Februar 2025

T-fal Ultraglide FV4026 Manual

11 Februar 2025