
MMS8090 Multimedia Speaker System
Please read carefully the safety mark on the back side
This mark is intended to alert the user from
the non isolated dangerous voltage within the
product that may be of sucient magnitube to
constitute a risk of electric shock to persons.
This mark is intented to alert the user for
important operating and servicing instruction.
oid sustained periods on high-volume use, and
not turn the volume to maximum level while using
h output signal, such as Mobile Phone or DVD,
., as this will cause distortion and may damage the
ease switch o the system from the wall socket,
not open the cover or back panel to avoid
ctrical shock or any other accidents. No user-
viceable parts are inside.
ug the system to the AC outlet with the right voltage
rked on the back panel of the Subwoofer.
ug the system to the AC outlet with the right voltage
rked on the back panel of the Subwoofer.
Care and safety information
Avoid high temperatures, moisture, water and dust
Apparatus should not be exposed to dripping or
• Do not place any source of danger on the Subwoofer,
and satellite (e.g. liquid lled objects lighted candles).
• Do not install near heat sources.
Do not block any ventilation opening
Place the apparatus in a location with adequate
ventilation to prevent internal heat build up. Allow at
least 10cm (4 inches) of free space all around the
apparatus for adequate ventilation.
• At high volume the back cover of Subwoofer becomes
Use a soft cloth slightly moistened to clean the cabinet.
Do not use a solution containing alcohol, spirits,
Item 3.5mm stereo cable Remote control User manual n eFM Ante na cabl
• The product shall not be exposed to dripping or splashing
and that no objects lled with liquids, such as vases, shall
be placed on the product.
• Batteries shall not be exposed to excessive heat such as
sunshine, re or the like.
• Attention should be drawn to the environmental aspects
Top & Back panel operation
1. : Turn on/Stand-by the speaker.
2. : Press “ ” to activate or deactivate mute.
3. 0-9: Numeric keys, with the help of these keys you can select song or
track in USB*. In FM, you can key in frequency, i.e. 927 for 92.7.
4. Source: Select the source- bt for Bluetooth, OP for Optical, AU for
Audio-in, Cd for CD, USb for USB*, 87.5 for FM.
5. Bass+: To increase the bass.
6. Repeat: Press to go for cycle: all cycle - one cyble.(in USB mode.)
7. Bass-: To decrease the bass.
USB*/BT mode: play/pause,
BT mode: press and hold 3 seconds to disconnect BT.
FM mode: press and hold 3 seconds to go to auto search.
OP/AU/CD mode: press once to mute, display ash to remind,
press again to unmute, display not ash.
10. : Play the previous song by pressing “ ” at USB*/BT mode.
Choose previous channel by pressing “ ” at FM mode.
11. : Play the next song by pressing “ ” at USB*/BT mode.
Choose next channel by pressing “ ” at FM mode.
13. Tune-: Each time to search channel step by step (each step-0.1 MHz),
press “Tune-” and hold to search previous channel, it will stop and
play once previous channel been searched.
14. Tune+: Each time to search channel step by step (each step+0.1 MHz),
press “Tune+” and hold to search next channel, it will stop and play
once next channel been searched.
Register you product and get support at
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.
This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited
or one of its aliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.
The subwoofer is recommended to be put
on the oor to get a better acoustic eect.
For best possible surround sound, all the
speakers (except subwoofer) should be
placed at the same distance from the
Place the front left and right speakers at
equal distances from the TV and at an angle
of approximately 45 degrees (horizontal)
from the listening position.
- To avoid magnetic interference, do not position
the speakers, too close to your TV.
Playing the speakers and s wub oofer
Bluet eraooth Op ting Instruction Troubleshooting
2. No sound or distorted sound.
3. The remote control does not
4. Low hum or buzz sound.
5. The content of the USB ash
6. Slow operation of the USB
ash drive / cannot detect USB
8. FM reception not good.
Check if the AC power cord is properly inserted into the AC mains socket.
Adjust the volume / select the correct source to choose the equipment
that you want to hear through the system.
Reduce the distance between the remote control and the system. Replace
the batteries with new ones / Point the remote control directly towards the
IR sensor (located on front panel of the subwoofer) / Check that the batteries
are loaded correctly / Switch o the system for 30 seconds and then rstart.
Place the product as far away as possible from electrical devices that may be
causing interference / Check power supply voltage and consult electrician.
The USB ash drive format is not compatible with the system. Drive is formatted
with a dierent le system which is not supported by this unit (e.g. NTFS).
Big memory size USB ash drive will take longer time to read and play. / Take
out USB drive and insert it again properly.
7. FM not properly tuned. Match with local frequency.
While listening radio turn o TV / DVD or other radiation source.
9. BT not working. Reduce the distance or device is not paired.
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.
Do not open the system as there is a risk of electric shock. If a fault occurs, frist check the points listed
below before taking the system for repair. If you are unable to remedy the problem by following hints
mentioned in below table.
The warranty is not valid in case:
1. Proof of purchase s ot omp ied with this warranty rd. i n acc an ca
2. The warranty card is not completed immediately after purchase.
3. The apparatus is not used according to this user manual.
4. Defects re used due to proper or reckless use. a ca im
5. Any repairs are done by unauthorized personnel.
6. The serial number is tampered with.
7. Defects due to uses beyond ca control like light g, bnormal oltage, ts of od or while nin a v ac G in
tr sit to the purchaser’s residence.an
All onsu bles d parts susceptible to ormal wear d tear re ot overed under this warranty. C ma an n an a n c
Customer’s Name and address:
Always there to help you!
Visit us at www.support.philips.com
Email: india.callcentre@tpv-tech.com
(10 a.m. to 9 p.m. Mondays to Saturdays & 10
a.m. to 6 p.m. on Sundays)
This Philips 2.1 Multimedia Speaker System is warranted against any defect due to defective materials or
workmanship for 12 months from the date of purchase, should a defect develop during the warranty, TPV
Technology India Pvt. Ltd., aliate of MMD Hong Kong Holding Limited. undertake to repair the apparatus FREE
OF CHARGE at any of its Authorized Service Center in India.
Total system power 80W RMS
Sa a r 20W x 2 RMStellite spe ker powe
Audio input socket 3.5mm stereo cable
Audio output socket 3.5mm stereo cable
Frequency range 30Hz - 120Hz
*Specication subject to change without prior notice.
Measured under specic conditions.
D n W Dimensio (mm) x H x
1. Press SOURCE key from subwoofer’s front panel or remote control to Bluetooth mode;
2. When selecting the Bluetooth mode. “.” of “bt.” in display will start blinking and you will hear an audio tone
which indicates Bluetooth pairing mode.
3. For pairing with mobile phone or other Bluetooth devices, search the device named “Philips MMS8090” and
pair it. Once paired, “.” of “bt.” slowly ash and come up with another audio tone. “.” of “bt.” will stop ash
4. Press and hold “ ” for 3 seconds from remote control in order to force disconnect the
Note: While using Bluetooth, if external call comes, then speaker system goes in mute mode in
order to protect privacy of mobile phone user. Operation resumes once the call is disconnected.
1. Source: standby mode, short press “ Source”
button to turn on, after turnning on:
short press “ Source” button to switch to channels,
long press “ Source” button would be standby
USB*/BT mode: play/pause;
FM mode: long press to auto search and store radio
In FM/AUDIO mode, short press to mute.
In FM mode, short press to tune frequency by -0.1MHZ,
long press to go to semi-auto search. After auto-search,
short press to go to previous station.
In USB*/BT mode, press “ ” to play previous song.
In FM mode, short press to tune frequency by +0.1MHZ,
long press to go to semi-auto search. After auto-search,
short press to go to previous station.
In USB*/BT mode, press “ ” to play next song.
***Do not use USB for char ging dev ic es which can
cause damage to your exter nal devi ces. thank you.