EN-1
FCC STATEMENT 
This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the
following two conditions:
(1) This device may not cause harmful interference, and
 (2) This device must accept  any interference received, including interference that may
cause undesired operation.
Note:
This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  Class  B  digital
devices,  pursuant  to  Part  15  of  the  FCC  rules.  These  limits  are  designed  to  provide
reasonable  protection  against  harmful  interference  in  a  residential  installation.This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used  in  accordance  with  the  instructions,  may  cause  harmful  interference  to  radio
communications.  However,  there  is  no  guarantee  that  interference  will  not  occur  in  a
particular installation. If this equipment does cause harmful interference to radio or television
reception,  which  can  be  determined  by  turning  the  equipment  off  and  on,  the  user  is
encouraged to try to correct the interference by one or more of the following measures:
  Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect  the  equipment into  an  outlet  on  a  circuit  different  from  that  to  which  the
receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of
the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified
in the manual. If such changes or modifications should be made, you could be required
to stop operation of the equipment.
Notice
If  static  electricity  or  electromagnetism  causes  data  transfer  to  discontinue  midway  (fail),
restart the application or disconnect and connect the communication cable (USB, etc.) again.
 ©2008 by   All rights reserved.
"Polaroid", "Polaroid and Pixel", and "Polaroid PoGo" are trademarks of Polaroid Corporation.
The  ZINK™  Technology  and ZINK™  trademarks  are  owned  by  ZINK  Imaging,  Inc.    Used
under license.
Changes are periodically made to this document. Changes, technical inaccuracies, and
typographic errors will be corrected in subsequent editions.
For service, support and warranty information, visit www.polaroid.com.