Ridgid PCB-1375 Manual


Læs gratis den danske manual til Ridgid PCB-1375 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Ridgid PCB-1375, eller vil du spørge andre brugere om produktet?

Side 1/1
Blade Installation
1. Place new blade into cutter so that the roller enters the
blade slot.
Figure 3
2. Reinstall “PC-1375” half of the handle.
3. Reinstall and tighten the three mounting screws.
4. Line up the lower handle hole and blade hole. Reinstall
the blade pin and the retaining ring.
Figure 4
PC-1375 Blade Change Instructions
Ridge Tool Co., Elyria, Ohio, U.S.A.
10/07
Printed in U.S.A. 010-338-222.10
Rev. A
PC-1375 Plastic Pipe and Tubing
Cutter Blade Change Instructions
WARNING
• Always wear safety goggles.
• Blade is sharp. Handle with care.
Blade Removal
1. Unlatch the handles so that they are fully open.
2. Remove retaining ring from the blade pin and remove
the blade pin
3. Lay the cutter on a flat surface with the “PC-1375” logo
facing up and remove the screws.
Figure 1
4. Remove the “PC-1375” half of the cutter handle.
5. Remove the blade.
Figure 2 – Blade Removal
Unlatch
Retaining Ring
and Pin
Screws
Install Blade
Over Roller
Unlatch
Retaining Ring
and Pin
Screws


Produkt Specifikationer

Mærke: Ridgid
Kategori: Ikke kategoriseret
Model: PCB-1375

Har du brug for hjælp?

Hvis du har brug for hjælp til Ridgid PCB-1375 stil et spørgsmål nedenfor, og andre brugere vil svare dig