Before the appliance is used, it must be properly positioned and installed
as described in this manual. To reduce the risk of fire, electric shock or injury,
basic precautions should always be followed:
1. Read all instructions before using the appliance.
2. Plug into a grounded 3-prong outlet, do not remove grounding prong,
do not use an adapter, and do not use an extension cord.
3. Replace all panels before operating.
4. It is recommended that a separate circuit, serving only your appliance be
provided. Use receptacles that cannot be turned off by a switch or pull chain.
5. Never clean appliance parts with flammable fluids. The fumes can create
a fire hazard or explosion. Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other appliance. The fumes
can create a fire hazard or explosion.
6. Before proceeding with cleaning and maintenance operations, make sure
the power line of the unit is disconnected.
7. Do not connect or disconnect the electric plug when your hands are wet.
8. Unplug the appliance or disconnect power before cleaning or servicing.
Failure to do so can result in electrical shock or death.
9. Do not attempt to repair or replace any part of your appliance unless
it is specifically recommended in this manual. All other servicing should
be referred to a qualified technician.
10. Use two or more people to move and install appliance. Failure to do so can
result in back or other injury.
11. To ensure proper ventilation for your appliance, the front of the unit must
be completely unobstructed. Choose a well-ventilated area with temperatures
above 55 °F (13 °C) and below 90 °F (32 °C). This unit must be installed in
an area protected from the elements, such as wind, rain, water spray or drips.
12. The appliance should not be located next to ovens, grills or other sources
13. The appliance must be installed with all electrical, water and drain
connections in accordance with state and local codes. A standard electrical
supply (115 V AC only, 60 Hz), properly grounded in accordance with
the national and local codes and ordinances is required.
14. Do not kink or pinch the power supply cord of appliance.
15. The fuse (or circuit breaker) size should be 15 amperes.
