Signature Hardware 401595 Manual


Læs gratis den danske manual til Signature Hardware 401595 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Signature Hardware 401595, eller vil du spørge andre brugere om produktet?

Side 1/3
1
BEFORE YOU BEGIN
Before installing, read entire outdoor shower installation
Instructions. Observe all local building and safety codes.
For the following installation instructions it is assumed
that the water supply has been installed in the desired
location and is accessible for shower installation.
Unpack and inspect the product for any shipping
damages. If you find damages, do not install. Contact
5. . If you need 1800
assistance or have questions while installing your
shower panel, contact Customer Service.
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures. Signature
Hardware accepts no liability for any damage to the seat
or wall, or for personal injury during installation.
Note: Make sure to winterize your outdoor shower
before cold weather arrives to prevent burst pipes and
protect the shower's hardware.
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
For these instructions, it is assumed that the old
faucet has been completely removed and any
necessary repairs or modifications to the water
supply have been completed.
O U T D O O R S H O W E R
STAINLESS STEEL WITH PULL CHAIN INSTALLATION INSTRUCTIONS
SKU: 401595
REVISED 07/10/2019
TOOLS AND MATERIALS:
Drill
Silicone Sealant
(100% Neutral
Cure)
Damp Cloth
Pencil
Air Compressor
1 855 715 1800. . .
2
INSTALLATION
O U T D O O R S H O W E R
STAINLESS STEEL WITH PULL CHAIN INSTALLATION INSTRUCTIONS
SKU: 401595
1. Apply plumbers tape (included) to the threaded ends of the 6" pipe and attach the pipe directly to the
water supply line.
2. Slide the decorative escutcheon over the pipe.
3. Thread the pull chain valve onto the 6" pipe. Hand tighten and adjust as necessary for proper align-
ment.
4. Slide the support arm onto the shower arm.
5. Wrap plumbers tape around the threaded ends of the shower arm. Attach the shower arm to the pull
chain valve.
6. Hold the support arm in place and mark the location of the mounting holes in the wall flange on the
installation surface.
7. Drill pilot holes in the locations marked in the previous step and install anchors (included). Drive
mounting screws through the flange, into the anchors, to attach the support arm to the installation
surface.
8. Tighten the set screw on the support arm with the provided Allen wrench.
9. Attach the shower head to the shower arm.
10. Turn on the water supply to check for leaks. If no leaks are detected, apply silicone sealant to the
back of the decorative escutcheon and press into place against the installation surface. Wipe away any
excess sealant with a damp cloth. Allow the silicone sealant to dry for 24 hours.
1 855 715 1800. . .


Produkt Specifikationer

Mærke: Signature Hardware
Kategori: Ikke kategoriseret
Model: 401595

Har du brug for hjælp?

Hvis du har brug for hjælp til Signature Hardware 401595 stil et spørgsmål nedenfor, og andre brugere vil svare dig