Speco Technologies O4P4X2 Manual


Læs gratis den danske manual til Speco Technologies O4P4X2 (57 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 54 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 27.5 anmeldelser. Har du et spørgsmål om Speco Technologies O4P4X2, eller vil du spørge andre brugere om produktet?

Side 1/57
User Manual
PTZ Network Camera
O4P4X2
Please read this instrucon carefully before operang the unit and keep it for further reference
1. Electrical safety
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in device damage! The
product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2. Environment
Do not expose the unit heavy stress, violent vibraon long-term exposure water humidity during transportaon, to or to and
storage, and/or installaon.
Do not install near sources heat. of
Only install the product environments inside the specicaon operang temperature humidity range. in and
Do not install the camera near power lines, radar equipment other electromagnec radiaon. or
Do not block any venlaon openings any. if
Use all the weatherproong hardware requirement minimize weather intrusion. to
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small quanty of neutral
detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may
result in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Dome cover is an opcal device, please do not touch or wipe cover surface directly during installaon and use, please refer to the
following methods if dirt is found.
Stained with dirt:
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint.
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth and
wipe several mes if it is not clean enough.


Produkt Specifikationer

Mærke: Speco Technologies
Kategori: Overvågningskamera
Model: O4P4X2

Har du brug for hjælp?

Hvis du har brug for hjælp til Speco Technologies O4P4X2 stil et spørgsmål nedenfor, og andre brugere vil svare dig