Speco Technologies O8VB1 Manual
Læs gratis den danske manual til Speco Technologies O8VB1 (42 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om Speco Technologies O8VB1, eller vil du spørge andre brugere om produktet?
Side 1/42
User Manual
8MP IP Camera
O8 /O8VD1/O8V VB1 T1
Please read this instrucon carefully before operang the unit and keep it for further reference
Important Safeguards and Warnings
1. Electrical safety
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in device damage!
The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2. Environment
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage and installaon.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature condions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor failure.
Do not block any venlaon openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small quanty of
neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth)
may result in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Dome cover is an opcal device, please don t touch or wipe cover surface directly during installaon and use, please refer ’
to the following methods if dirt is found.
Stained with dirt:
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth
and wipe several mes if it is not clean enough.
Produkt Specifikationer
| Mærke: | Speco Technologies |
| Kategori: | Overvågningskamera |
| Model: | O8VB1 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Speco Technologies O8VB1 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Overvågningskamera Speco Technologies Manualer
12 Januar 2025
11 Januar 2025
3 September 2024
20 August 2024
19 August 2024
18 August 2024
18 August 2024
17 August 2024
17 August 2024
17 August 2024
Overvågningskamera Manualer
- TP-Link
- Aluratek
- Elro
- Summer Infant
- ION
- Strong
- EverFocus
- Bea-fon
- AVerMedia
- TRENDnet
- Topica
- Vivotek
- Videcon
- Approx
- Aritech
Nyeste Overvågningskamera Manualer
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025
5 Juli 2025