Frame Construction Ceiling Installation
Replace the top cover and tighten the screws.
Insert the speaker through the bottom of the hole in
Loosen the four screws on the front baffle(counter
clockwise) 1/2 turn. Then tighten the screws (clockwise)
until the dog legs clamp the speaker to the ceiling.
Do not over tighten screws.
Connect a secondary support line from the seismic tab to a
secure support point. Set the rotary tap selector and install
Adjusting the Tap Selector
Remove the top cover to access the speaker connector.
Attack the speaker wires to the 4-pole captive screw
connector. Insert the 4-pole captive
screw plug into the connector on back of the speaker.
Install the conduit and secure the connections.
.....................................
2-w ay, ceiling speaker with metal back can
.............................
.................................
Nominal sensitivity.........................
Nominal impedance......................
...........................
70V: 10W, 5W, 2.5W, 1.3W, .63W, 8 ohms
100V: null, 10W, 5W, 2.5W, 1.3W, 8 ohms
Woofer................................................
5.25" (131 mm) polypropylene cone
with moisture resistant coating
Tweeter...............................................
Overload protection.......................
Full range power limiter with the 8 ohm direct
input only, protecting the tweeter, woofer, and
Temperature/humidity ..................
Storage: -40 to +158 °F (-40 to +70 °C) /
10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) /
10% to 90%, noncondensing
Listings................................................
Compliances.....................................
Warranty .............................................
Limited lifetime warranty*
NOTE: All nominal level are at ±10%.
NOTE: Specifications are subject to change without notice.
NOTE: Please see warranty card for full details.
Parallel Hookup Wiring Diagram
Apply 4 pieces of black putty
(supplied),equally spaced 90°
apart, to the upper inside
Take the cutout template from the packaging box and
punch out along the larger perforated circle. Place
the cutout template against the bottom of the ceiling and
trace the inside of it. Carefully cut out the ceiling material
Speaker 1 Speaker 2 Speaker 3
