Supermicro SuperServer AS-2014TP-HTR Manual

Supermicro Server SuperServer AS-2014TP-HTR

Læs gratis den danske manual til Supermicro SuperServer AS-2014TP-HTR (14 sider) i kategorien Server. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 20 anmeldelser. Har du et spørgsmål om Supermicro SuperServer AS-2014TP-HTR, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/14
Information for Lot 9 of ErP (Ecodesign)
This addendum addresses European Union (EU) Ecodesign requirements for servers and storage
products. All data and ratings within this addendum are in reference only to the Supermicro product(s) in
th toe manual. The below information conforms requirements laid down in Annex II of the Commission
Regulation 2019/424.
3(1)(a): See Section 1.1 of the system manual for the product type.
3(1)(b): See the title page and preface of the system manual for the trademark and
manufacturer’s address.
3(1)(c): See the title page of the system manual for product model number(s).
3(1)(d): See the serial number the physical system to determine the year of manufacture. on
3(1)(e-j): PSU Efficiency and Power Factor Value able) (From 80 Plus report) (T
PSU Model #: PWS-
2K04A- 1R
Watts: 2000W
PSU Efficiency
Power Fact or
% of Rated Load
10 %
20 %
50 %
100 %
50 %
Single Output (AC-DC)
94.06%
95.75%
96.30%
93.84%
0.99
System (EUT) Efficiency in Power (Table)
Idle State
Representative
Configurations
Measured Idle State
Power (W)
Calculated Idle Power
Allowance (W)
High-End Performance
Configuration
511.9
1032.9
Typical Configuration
N/A
N/A
Low-End Performance
Configuration
343.8
847.2
System (EUT) Efficiency in Power (Table)
Active State
Representative
Configurations
Minimum Active State
Efficiency for 2-Socket
Server
High-End Performance
Configuration
Typical Configuration
8.0
Low-End Performance
Configuration
3(1)(k): The operating condition class . is A2
Dry bulb temp C°
Humidity range, non-condensing
Operating
condition
class
Allowable
range
Recom
mended
range
Allowable range
Recommended range
Max dew
point (°C)
Maximum
rate of
change
(°
C/hr)
A1
15 32-
18 27-
–
12 C Dew Point (DP) and°
8 % relative humidity (RH) to
17 80 C DP and ° % RH
–
9 C °DP to
15 C and °DP
60 % RH
17
5/20
A2
10 35-
18 27-
–
12 C and 8 % °DP RH to
21 80 C and °DP % RH
Same as A1
21
5/20
A3
5-40
18 27-
–
12 C and 8 % °DP RH to
24 85 C and °DP % RH
Same as A1
24
5/20
A4
5-45
18 27-
–
12 C and 8 % °DP RH to
24 90 C and °DP % RH
Same as A1
24
5/20
3(1)(l): The idle state power at the higher boundary temperature of the operating conditions
class is . 604W
3(1)(m): The active state efficiency and performance 73.1. is
3(1)(n): There are two methods by which a user can securely delete data from this system. The
user performing secure data deletion should be an IT professional.
The first is with a Unified Extensible Firmware Interface (UEFI) shell utility. This utility
works on X10/X11/H11/H12/M11 motherboard series with onboard SATA/NVMe devices.
Any user may access and download this utility through following link:
https://www.supermicro.com/about/policies/disclaimer.cfm?url=/wftp/utility/Lot9_Secure
_Data_Deletion_Utility/
Download the shell utility package and extract it to a USB flash drive, then plug the drive
into the server for which secure data deletion is necessary. Then turn the system on.
Navigate to the BIOS setup menu, then place the server system into the UEFI shell
environment. Follow the instructions in the README file to invoke the utility and
complete the deletion.
The second method is through the secure data deletion tool provided by the original
manufacturer of the hard drive. This should be used in a scenario where the shell utility
is not applicable. Each manufacturer should have the tool available on their website. If
needed, please look on the hard drive label for the name of the manufacturer and model
information.
3(1)(o): List of recommended combinations of blade servers with chassis: N/A.
3(1)(p): List of all current SKUs within this product family: AS -2014TP-HTR.
3(3)(a): There is no use of cobalt in batteries in this product.

Produkt Specifikationer

Mærke: Supermicro
Kategori: Server
Model: SuperServer AS-2014TP-HTR

Har du brug for hjælp?

Hvis du har brug for hjælp til Supermicro SuperServer AS-2014TP-HTR stil et spørgsmål nedenfor, og andre brugere vil svare dig


Server Supermicro Manualer

Supermicro

Supermicro SuperServer 6028TR-DTR Manual

7 September 2025
Supermicro

Supermicro SuperServer SYS-620BT-DNTR Manual

28 August 2025
Supermicro

Supermicro SuperServer 2029U-E1CR4 Manual

28 August 2025
Supermicro

Supermicro Blade SBI-411E-1G Manual

28 August 2025
Supermicro

Supermicro SuperServer AS-1114S-WN10RT Manual

28 August 2025
Supermicro

Supermicro SuperServer 1029U-TRT Manual

22 August 2025
Supermicro

Supermicro SuperServer AS -2024US-TNR Manual

21 August 2025
Supermicro

Supermicro SuperServer AS-2024US-TRT Manual

21 August 2025
Supermicro

Supermicro SuperServer SYS-221BT-HNC8R Manual

23 Juli 2025
Supermicro

Supermicro SuperServer 1019S-MC0T Manual

6 Juli 2025

Server Manualer

Nyeste Server Manualer

Ibm

Ibm eServer xSeries 346 Manual

13 September 2025
Ibm

Ibm BladeCenter HS23 Manual

13 September 2025
Ibm

Ibm eServer System x3850 X5 Manual

13 September 2025
Ibm

Ibm eServer xSeries 445 Manual

13 September 2025
Ibm

Ibm System x x3690 X5 Manual

13 September 2025
Ibm

Ibm eServer xSeries 206 Manual

13 September 2025
Ibm

Ibm xSeries 365 Manual

13 September 2025
Ibm

Ibm System x x3650 M3 Manual

13 September 2025
Ibm

Ibm System x3650 M3 Manual

13 September 2025
Ibm

Ibm System x x3950 X5 Manual

13 September 2025