Tripp Lite APSX1012SW Manual

Tripp Lite Ikke kategoriseret APSX1012SW

Læs gratis den danske manual til Tripp Lite APSX1012SW (48 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 41 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 21 anmeldelser. Har du et spørgsmål om Tripp Lite APSX1012SW, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/48

Owner’s Manual

Sine Wave DC-to-AC Inverter/Chargers

Models: APSX1012SW, APSX2012SW

12VDC to 230VAC

1111 W. 35th Street, Chicago, IL 60609 USA

www.tripplite.com/support

Table of Contents

Important Safety Instructions 2

1. Overview & Features 3

1.1 Overview 3

1.2 Indicators, Controls and Settings 3

1.3 Optional Features 6

2. Battery Charger 6

2.1 Mode of Operation 6

2.2 Transfer Switching Speed 6

3. Battery Installation

and Maintenance 6

3.1 Select Battery Type 6

3.2 Monthly Maintenance 8

3.3 Battery Installation 8

3.4 Battery Connection 8

4. Inverter/Charger

Installation and Operation 10

4.1 Installation 10

4.2 Installation Diagrams and Charts 10

4.3 Installation and Start-Up 11

5. Technical Speciﬁcations 11

6. Troubleshooting 12

7. Service 12

Español 13

Français 25

Ðóññêèé 37

201110117 93-3054.indb 1 11/9/2011 10:57:55 AM

Important Safety Instructions

SAVE THESE INSTRUCTIONS!

This manual contains important instructions and warnings that should be followed during the installation,

operation and storage of all Tripp Lite Inverter/Chargers.

Location Warnings

• Install your Inverter/Charger in a location or compartment that minimizes exposure to heat, dust, direct sunlight and

moisture. Flooding the unit with water will cause it to short-circuit and could cause personal injury due to electric shock.

• For proper ventilation, allow a minimum 2 inches of clearance at front and back of the Inverter/Charger. To avoid overheating

the Inverter, the compartment that houses the Inverter/Charger must be properly ventilated with adequate outside air ﬂow.

The heavier the load of connected equipment, the more heat will be generated by the unit.

• Do not install the Inverter/Charger near magnetic storage media, as this may result in data corruption.

• Do not install the Inverter/Charger near ammable materials, fuel or chemicals.

Battery Connection Warnings

• Multiple battery systems must be comprised of batteries of identical voltage, age, amp-hour capacity and type.

• Because explosive hydrogen gas can accumulate near batteries if they are not well ventilated, do not install batteries in a

“dead air” compartment. The battery compartment should have some ventilation to outside air.

• Sparks may result during nal battery connection. Always observe proper polarity as batteries are connected.

• Do not allow objects to contact the DC input terminals. Do not short or bridge these terminals together. Serious personal

injury or property damage could result.

Ground Connection Warnings

• Safe operation requires connecting the Inverter/Charger’s Main Ground Terminal directly to the frame of the vehicle or

earth ground.

Equipment Connection Warnings

• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause

the failure of the life support equipment or to signicantly affect its safety or effectiveness is not recommended. Do not

use this equipment in the presence of a ammable anesthetic mixture with air, oxygen or nitrous oxide.

• You may experience uneven performance results if you connect a surge suppressor, line conditioner or UPS system to the

output of the Inverter/Charger.

• User must supply proper protection for wire openings in unit panels.

Operation Warnings

• Your Inverter does not require routine maintenance.

• Potentially lethal voltages exist within the Inverter/Charger as long as the battery supply is connected. During any service

work, the battery supply should therefore be disconnected.

• Do not connect or disconnect batteries while the Inverter/Charger is operating from the battery supply. Dangerous arcing

may result.

201110117 93-3054.indb 2 11/9/2011 10:57:55 AM

Produkt Specifikationer

Mærke:	Tripp Lite
Kategori:	Ikke kategoriseret
Model:	APSX1012SW
Tænd-/slukkontakt:	Ja
Bredde:	228.6 mm
Dybde:	457.2 mm
Højde:	184.2 mm
Vægt:	14290 g
Produktfarve:	Grå
Pakkevægt:	16500 g
Pakkedybde:	545.3 mm
Pakkebredde:	320 mm
Pakkehøjde:	330.2 mm
Relativ luftfugtighed ved drift (H-H):	0 - 95 %
Husmateriale:	Stål
Strømforsyningstype:	Indendørs
Udgangseffekt:	1000 W
LED-indikatorer:	Ja
Udgangsspænding:	230 V
Udgangsstrøm:	15 A
Harmoniseret systemkode (HS):	8504.40.9570
Indgangsspænding:	230 V
Hovedkassen højde (udvendigt):	330.2 mm
Hovedkassens længde (udvendigt):	545.3 mm
Hovedkassens bruttovægt (udvendigt):	16500 g
Hovedkassens bredde (udvendigt):	320 mm
Oprindelsesland:	Taiwan
Produkter pr. hovedkasse (udvendigt):	1 stk
Indgangsfrekvens:	50 Hz
Stærkstrøm typen:	AC1-to-AC2
Lydalarmer:	Ja
Strømbeskyttelsesfunktioner:	Overbelastning
Maksimal strøm:	2000 W
Justerbar udgangsspænding:	Ja
Uddgående frekvens:	50/60 Hz