Tripp Lite DNET1 Manual

Tripp Lite Ikke kategoriseret DNET1

Læs gratis den danske manual til Tripp Lite DNET1 (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Tripp Lite DNET1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

Owner’s Manual

Network Dataline

Surge Suppressors

Tripp Lite World Headquarters

1111 W. 35th Street, Chicago, IL 60609 USA

(773) 869-1234 • www.tripplite.com

Note: Follow these instructions to ensure proper operation and prevent damage to this device

and its connected equipment.

Data Shield™ by Tripp Lite Network Dataline Surge Suppressors are designed to protect

data and communications equipment against AC transients caused by lightning, electrostatic

discharge and ground surges that can enter equipment from the signal lines or chassis ground.

Data Shield by Tripp Lite Network Dataline Surge Suppressors described here protect

networked equipment using 100Base-T, 10Base-T, 10Base-2 and Ethernet, Token Ring,

RS232, RS422, parallel, dial-up modems, fax, ISDN, DDS, T-1 and other communication

interfaces.

200810167 93-2858.indd 1 12/16/2008 9:58:50 AM

INSTALLATION

1. Make sure the computer, network device or other equipment is logged OFF the network

(if applicable). Turn OFF power to the equipment.

2. Disconnect the cable from the equipment to be protected.

3. Connect the Data Shield by Tripp Lite Network Dataline Surge Suppressor directly to the

equipment. DB9 and DB25 models are reversible, to work with male or female ports. To

change gender, remove the thumbscrews, reverse their direction and re-install.

4. Attach the green ground wire on the surge suppressor directly to the protected

equipment’s chassis. (Except DB9 and DB25 models.)

5. Reconnect the cable to the Data Shield by Tripp Lite Network Dataline Surge

Suppressor.

NOTE!

The Data Shield by Tripp Lite Network Dataline Surge Suppressor must be properly grounded and positioned as close

as possible to the equipment to be protected. For best results, it is required that the length of the signal line and ground

wire (if equipped) between the surge suppressor and the protected equipment be kept as short as possible, not to

exceed 12 inches (12”). It is best to install the surge suppressor directly to the equipment, as noted above.

NOTE!

Installing a typical Data Shield by Tripp Lite Network Dataline Surge Suppressor is equivalent to adding

approximately three feet (3’) of typical data communication cable to a segment.

CAUTION!

The Data Shield by Tripp Lite Network Dataline Surge

Suppressor does not protect the equipment on the opposite end

of the cable. Normally, protection at both ends is recommended.

CAUTION!

Use of this equipment in life support applications where failure

of this equipment can reasonably be expected to cause the

failure of the life support equipment or to signiﬁcantly affect its

safety or effectiveness is not recommended. Do not use this

equipment in the presence of a ﬂammable anesthetic mixture

with air, oxygen or nitrous oxide.

CAUTION!

When properly installed, the Data Shield by Tripp Lite Network

Dataline Surge Suppressor will only protect against surges on

the dataline portion of your installation. Simultaneous AC surge

suppression/power protection in the form of an ISOBAR® surge

suppressor or Tripp Lite UPS system is strongly recommended

for complete system/network protection and can also extend

Ultimate Lifetime Insurance coverage to connected equipment.

200810167 93-2858.indd 2 12/16/2008 9:58:51 AM

Produkt Specifikationer

Mærke:	Tripp Lite
Kategori:	Ikke kategoriseret
Model:	DNET1
Produktfarve:	Hvid
Pakkevægt:	110 g
Pakkedybde:	50.8 mm
Pakkebredde:	76.2 mm
Pakkehøjde:	152.4 mm
Ethernet LAN-porte (RJ-45):	1
Bæredygtighedscertifikater:	RoHS
Hovedkassen højde (udvendigt):	266.7 mm
Hovedkassens længde (udvendigt):	114.3 mm
Hovedkassens bruttovægt (udvendigt):	1270 g
Hovedkassens bredde (udvendigt):	241.3 mm
Oprindelsesland:	Kina
Produkter pr. hovedkasse (udvendigt):	12 stk
Hovedkasse (udvendig) GTIN (EAN/UPC):	10037332011432
Antal RJ-11-porte:	1
Nominel indgangsspænding:	120-230 V
AC udgange, antal:	0 AC stikkontakt(er)
Overspænding energivurdering:	- J
Telefonlinje beskyttelse:	Ja
Netværk linje beskyttelse:	Ja
Nominel udgangsstrøm:	750 A