Velleman VTTEST 7 Manual

Velleman Ikke kategoriseret VTTEST 7

Læs gratis den danske manual til Velleman VTTEST 7 (16 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 45 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 23 anmeldelser. Har du et spørgsmål om Velleman VTTEST 7, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
VTTEST7 VELLEMAN
1
VTTEST7 - BATTERY TESTER
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Your new is a sensitive and accurate device for testing batteries under charge. You can test standard zinc VTTEST7
carbon, alkaline, mercury, silver oxide, lithium and nickel cadmium batteries.
2. Operation
a) Select the correct battery type and voltage with the recessed range switch. Examples:
- move the range selector to the position labelled "1.5V AA D" if you wish to test AA-C- - - -, C or D batteries of 1.5V.
- select the "9V" tion to test rectangular 9V-posi -batteries.
- select the "BUTTON CELL 1.5V" position to test mercury, silver or alkaline button cells.-
- select the "LITHIUM 3V" position for lithium button cells.-
- -C-select the "1.5V AA D"-position to test nickel cadmium batteries of 1.25V and read the value on the lowest of
the three scales on the analogue display.
The value indicated on the meter is the load current drain placed on the battery during the check.
CAUTION: Selecting the wrong range will yield inaccurate results. You may also damage the device in the process.
b) Place the red probe tip (+) against the positive (+) battery terminal and the black probe tip ( ) against the negative (- -)
battery terminal.
CAUTION : Mind the polarity indications when testing your batteries!
Select the correct range (see above). Use the following procedure to test your batteries:
- Place the battery's negative ( ) terminal against the 's negative ( ) contact and touch the battery's - VTTEST7 -
positive (+) terminal with the red probe tip (+).
- In order to test rectangular 9V-batteries : place the battery's negative ( ) terminal against the 's negative - VTTEST7
(-) contact and place the battery's positive (+) terminal against the 's positive (+) contact.VTTEST7
- In order to test button cell batteries: insert the battery in the slot on the side of the device. Make sure the negative
(-) pole is facing up and press the brown switch on the front panel.
CAUTION : Observe the following safety prescriptions in order to avoid all damage to the button cell being tested:
- Do not push the brown switch when using the probe tips to test a button cell.
- Do not allow the red probe tip (+) to contact the black probe tip ( ) when using the 9V- -contacts to test button cells.
c) Read the analogue display to determine the condition of the battery.
- Use the upper scale ("REGULAR") for measuring regular zinc carbon and alkaline batteries.
- Use the centre scale ("BUTTON CELL LITHIUM") for measuring mercury, silver oxide, alkaline and lithium -
button cells.
- Use the lower scale ("NICKEL CADMIUM") for measuring rechargeable nickel cadmium batteries.
VTTEST7 VELLEMAN
2
d) The battery needs to be replaced (or recharged) if the indicator needle is in the red REPLACE zone. The battery has
sufficient capacity left if the needle ends up in the green GOOD zone. Consider replacing the battery if the needle
comes to rest between the oblique lines of the "REGULAR" scale.
Note that the device can test most battery types. However, you should not use the VTTEST7 to test motorcycle or car
batteries, lead batteries and 6V and batteries for 12V- -lanterns.
e) The needle should be aligned with the black dot on the far left hand side of the upper scale when no batteries are -
being tested. If not, you should adjust the zero position by turning the zero position screw on the front panel with a -
screwdriver.
3. Specifications
Range
Load Current Drain
Min. Voltage for GOOD zone
BUTTON CELL 1.5V
1mA
1.125V ± 0.09V
AAA- N 1.5V
50mA
1.125V ± 0.09V
AA-C- D 1.5V
150mA
1.125V ± 0.09V
LITHIUM 3V
1mA
2.25V ± 0.18V
6V
10mA
4.50V ± 0.36V
9V
10mA
6.75V ± 0.54V
12V
10mA
9.00V ± 0.72V
15V
10mA
11.25V ± 0.90V
22.5V
10mA
16.875V ± 1.35V
4. Maintenance
The VTTEST7 is a precision instrument: handle it with care and keep the following prescriptions in mind:
• Water contains minerals capable of corroding electronic circuits. Therefore, you should not expose the device to
water and wipe it dry immediately if it should get wet.
• Do not store the device in hot locations. Excessive temperatures may damage the device or the tested batteries.
• Do not drop the device in order to prevent permanent damage to the circuit boards and the housing.
• Do not store the device in a dusty or dirty environment in order to prevent premature wear of moving parts.
• Do not use solvents or abrasives to clean the device. Wipe it with a soft cloth moistened with a mild water-and soap -
solution.
• Consult qualified personnel in case of malfunction. Do not open the device yourself, as the does not VTTEST7
contain any parts that are to be serviced by the user.
The information in this manual is subject to change ithout prior notice.w
VTTEST7 - BATTERIJTESTER
1. Inleiding
Aan alle ingezetenen van de Europese Unie
Belangrijke milieu-informatie betreffende dit product
Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt weggeworpen,
dit toestel schade kan toebrengen aan het milieu.
Gooi dit toestel (en eventuele batterijen) niet bij het gewone huishoudelijke afval; het moet bij een
gespecialiseerd bedrijf terechtkomen voor recyclage.
U moet dit toestel naar uw verdeler of naar een lokaal recyclagepunt brengen.
Respecteer de plaatselijke milieuwetgeving.
Hebt u vragen, contacteer dan de plaatselijke autoriteiten inzake verwijdering.

Produkt Specifikationer

Mærke: Velleman
Kategori: Ikke kategoriseret
Model: VTTEST 7

Har du brug for hjælp?

Hvis du har brug for hjælp til Velleman VTTEST 7 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Velleman Manualer

Velleman

Velleman HQPE10011 Manual

10 August 2025
Velleman

Velleman KNS120 Manual

10 August 2025
Velleman

Velleman MK119 Manual

10 August 2025
Velleman

Velleman HAA40GN Manual

7 Juni 2025
Velleman

Velleman HAA272 Manual

7 Juni 2025
Velleman

Velleman HAA100AN Manual

7 Juni 2025
Velleman

Velleman HAA40AN Manual

6 Juni 2025
Velleman

Velleman LABPS1502AN Manual

1 Januar 2025
Velleman

Velleman VMA402 Manual

30 December 2025
Velleman

Velleman IREXT2 Manual

30 December 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Ikea

Ikea GLASÖRT 105.731.02 Manual

23 August 2025
Netgear

Netgear GS752TSB Manual

23 August 2025
Caberg

Caberg Ghost Manual

23 August 2025
Ikea

Ikea KANTSTOLPE 905.693.18 Manual

23 August 2025
Topeak

Topeak Journey Trail TX Axle Kit-P15 Manual

23 August 2025
Samsung

Samsung RR20M2Z4ZR7 Manual

23 August 2025
Candy

Candy H3WS 4105TE/1-S Manual

23 August 2025
XP-PEN

XP-PEN Note Plus Manual

23 August 2025
Generac

Generac 6853 Manual

23 August 2025
Samsung

Samsung RR19T2Y1B6R Manual

23 August 2025