Ventev TW-CTEN-P Manual

Ventev Ikke kategoriseret TW-CTEN-P

Læs gratis den danske manual til Ventev TW-CTEN-P (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Ventev TW-CTEN-P, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

1. Prepare the ceiling tile grid for a 1’ x 2’ or

2’ x 2’ installation.

2. Determine the correct mounting height of

the access point (AP) mounting plate.

Use the included standoffs for APs with

integrated antennas (Figure 1). For AP

installations using rubber duck antennas,

do not use the mounting plate standoffs

(Figure 2).

3. Secure the AP mounting plate on the

enclosure mounting plate (Figure 3) with

the appropriate hardware. For most

Cisco APs, the mounting holes are

already pre drilled into the mounting plate. -

For all other APs, use self tapping -

screws.

4. Install the desired door insert.

5. Place the enclosure into the ceiling tile

grid. Pull power and Ethernet

connections through the provided cord

grips as needed.

6. If desired, install the included ceiling tile

insert for a 2’ x 2’ installation.

7. Secure the enclosure to the ceiling

structure if required by local building

codes.

8. Connect the power and Ethernet to the

AP as recommended by the AP

manufacturer.

9. Install the AP onto the mounting plate.

10. Close the enclosure door and turn the

locking mechanism to lock the enclosure

door (Figure 4).

Figure 1

Figure 3

Figure 2

Figure 4

1. The ceiling tile enclosure has four holes in

the back for easy mounting (Figure 1).

2. There are two eyebolts provided along

with nuts, washers and lock washers to

secure the enclosure to your ceiling

structure based on your local building

codes (Figure 2).

3. Secure a nut, lock washer and washer to

the top of the eye bolt (Figure 3) Insert

into the hole of your choice on the back of

the enclosure.

4. Inside the enclosure, secure the bottom of

the eye bolt with a washer, lock washer

and nut (Figure 4).

5. Repeat the first four steps for the second

eye bolt to be placed in the hole of your

choice at the back of the enclosure.

6. Once eye bolts are installed, secure the

enclosure to the ceiling with wire or cable

through the eye bolts to the ceiling

structure per local building codes.

Figure 1

Figure 3

Figure 2

Figure 4

Produkt Specifikationer

Mærke:	Ventev
Kategori:	Ikke kategoriseret
Model:	TW-CTEN-P
Bredde:	305 mm
Dybde:	178 mm
Højde:	610 mm
Vægt:	3402 g
Velegnet til:	Indendørs
Produktfarve:	Hvid
Produkttype:	WLAN-adgangspunktmontering
Materiale:	Acrylonitrilbutadienstyren
Certificering:	RoHS
Installationsmuligheder:	Loftsmonteret
Ventilationstype:	Passiv