Viking TVWH360FW Manual

Viking Emhætte TVWH360FW

Læs gratis den danske manual til Viking TVWH360FW (24 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 43 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 22 anmeldelser. Har du et spørgsmål om Viking TVWH360FW, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/24

MODELS G6MD • G8MD • G10MD

Page 1

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

2. Validated performance testing certified for use with BEST,

Broan, and Broan Elite range hoods.

3. This unit is not designed to provide combustion air for fuel-

burning appliances.

4. Do not connect the unit directly to a combustion appliance of

any type.

5. Sufficient air is needed for proper combustion and exhausting

of gases through the flue (chimney) of fuel burning equipment

to prevent backdrafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those

published by the National Fire Protection Association (NFPA),

and the American Society for Heating, Refrigeration and

Air Conditioning Engineers (ASHRAE), and the local code

authorities.

6. Before servicing or cleaning unit, switch power off at service

panel and lock the service disconnecting means to prevent

power from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten a

prominent warning device, such as a tag, to the service panel.

7. When performing installation, servicing or cleaning the unit, it is

recommended to wear safety glasses and gloves.

8. During extreme weather events including snow storms, ensure

that the intake area for the outside air duct is not blocked and

able to provide a clear pathway for outside air to enter the

system.

9. When cutting or drilling into wall or ceiling, do not damage

electrical wiring or other hidden utilities.

10. When notching or drilling into framing including floor supports,

rim joists, and wall studs, comply with code and manufacturer

limitations on allowable modifications to these structural

members.

11. This unit is intended to be installed within the home in a location

protected from moisture.

12. This unit must be in an accessible location which allows for

inspection of the unit.

13. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the address

or telephone number listed in this document.

14. When federal, provincial or state legislation comprises more

restrictive installation and/or certification requirements, the

aforementioned requirements prevail on those of this document

and the installer agrees to conform to these at his own expense.

AUTOMATIC MAKE-UP AIR

DAMPER WITH TRANSFORMER

& PRESSURE SWITCH

READ AND SAVE THESE INSTRUCTIONS

FOR RESIDENTIAL USE ONLY

CAUTION

1. Do not locate outside air inlet near hazardous materials or explosives.

2. Unit shall not be installed to introduce air from crawlspaces, garages,

attics, adjacent dwelling units, or other locations within the building

shell. Unit shall be installed to introduce air directly from outdoors.

3. Do not run the outside air duct directly above or closer than 2 ft to

any furnace or its supply plenum, boiler, or other heat producing

appliance.

4. Any ductwork used in conjunction with the Damper must be installed

in compliance with all local and national codes that are applicable.

5. Do not operate the Damper for fresh air introduction until all system

filters, including the central duct system filter, have been installed per

the system design.

6. Please read the unit specification label on the product for further

information and requirements.

7. The Damper’s outdoor air intake, ducting, and any filters should be

inspected and maintained on a regular basis.

8. Insulate the duct and damper to prevent build-up of condensation in

cold weather climates. Vapor barriers on both sides of insulation are

recommended.

Produkt Specifikationer

Mærke:	Viking
Kategori:	Emhætte
Model:	TVWH360FW

Har du brug for hjælp?

Hvis du har brug for hjælp til Viking TVWH360FW stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Emhætte Viking Manualer

Viking TVHW4842 Manual

28 December 2025

Viking TVHW3630 Manual

28 December 2025

Viking VWH3610LBW Manual

28 December 2025

Viking TVHW6654 Manual

27 December 2025

Viking TVHW3654 Manual

25 December 2025

Viking TVHW6630 Manual

25 December 2025

Viking VCWH56048 Manual

25 December 2025

Viking TVHW4854 Manual

24 December 2025

Viking DIL1200 Manual

24 December 2025

Viking TVHW6642 Manual

24 December 2025

Emhætte Manualer

Nyeste Emhætte Manualer

Neff Z51IXC1X6 Manual

30 December 2026

Neff Z51FXD2N1 Manual

30 December 2026

AEG NBK951DR Manual

30 December 2026

Technika TUM85MB Manual

29 December 2026

AEG NBK651DM Manual

29 December 2026

Whirlpool AKR 5390/1 IX Manual

29 December 2026

Neff Z53XXB1X6 Manual

29 December 2026

Neff Z51BIP1X1 Manual

29 December 2026

Neff Z54TL90X1 Manual

29 December 2026

Gaggenau AA442810 Manual

29 December 2026