Vocopro CLUB-3800 Manual


Læs nedenfor 📖 manual på dansk for Vocopro CLUB-3800 (4 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 2 personer og blev bedømt med 4.4 stjerner i gennemsnit af 1.5 brugere

Side 1/4
This quick reference guide is provided to help you set up your
CLUB-3800 system for the first time. It contains instructions
on setting up the products that are included in the
CLUB-
3800. If you are connecting any additional gear that is not
included in the
CLUB-3800, refer to the appropriate manuals
for detailed instructions.
CDG-9000 PRO CD/CDG Player
• [1] Instruction Manual
• [1] Instruction Manual
VP-300 PRO 300W Professional Power Amplifier
• [1] Instruction Manual
VX-15 Vocal Speakers
• [2] VX-15 speakers
Gathering Package Contents
The first step to putting together your new system is unpacking all of the necessary equipment. Remem-CLUB-3800
ber to keep your manuals nearby when setting up, as you may need to reference them. The products listed below are
included in the system: CLUB-3800
SS-88 Speaker Stands
• [2] SS-88 speaker stands
RC-8 Road Case
• [1] RC-8 road case
• [1] Rolling cart
• [2] MARK-38 microphones
• [1] Gooseneck DJ light
• [1] Double RCA to ¼” cable
• [2] MDP to ¼” cable
• Rack-mounting screws
Mounting components into the RC-8
Follow these basic guidelines when mounting:
Always screw in the mounting screws using an “X” forma-
tion.
• If possible, to keep the products cooler, leave some space in
between the components in the rack.
CDG-9000 PRO CONTROLLER
CDG-9000 PRO PLAYER
DA-2200 PRO MIXER
VP-300 PRO AMPLIFIER
Below is one way to configure your CLUB-3800:
1
2
4
3
On the web at www.vocopro.com
or call toll free 1-800-678-5348
Quick Reference Setup Guide
CLUB-3800
Quick Start
Setting up the speakers and speaker stands
1. Setup each SS-88 speaker stand by extending the support
legs to a position that is stable and tighten the tension mecha
-
nism firmly.
2. Place a VX-15 speaker on top of the SS-88 so that the
shaft of the SS-88 fits flush into the mounting cavity on the
bottom of the VX-15.
NOTE: Each end of the SS-88 pole has a particular diameter
fitted for common speakers’ mounting cavities. If the SS-88
shaft does NOT fit flush into the mounting cavity on the VX-15,
loosen the SS-88 pole and reverse it in the stand and then
remount the speaker.
3. Repeat the above steps for each speaker and stand.
Connecting Power
Be sure that each product has a power cord firmly attached. It is recommended that you use a power strip/surge protector
when connecting your CLUB-3800 to a power outlet.
Connecting the components
Once you have mounted all of the components into the RC-8, it is time to connect them. Follow these directions on connect-
ing the components.
NOTE: If you are also connecting components that are not part of the CLUB-3800 system, please refer to the manual of that
product for setup instructions.
MAKE SURE THAT ALL PRODUCTS’ POWER IS
TURNED OFF BEFORE CONNECTING ANYTHING
VX-15 Speaker
SS-88 Stand
CDG-9000 PRO remote unit to the player unit
Connect the Control Interface Connector from “CONNECT TO MAIN UNIT” jack on the rear panel of the remote unit to the
“CONNECT TO REMOTE CONTROLLER” jack on the rear panel of the player unit.
CDG-9000 PRO Controller
CDG-9000 PRO Player
1


Produkt Specifikationer

Mærke: Vocopro
Kategori: Ikke kategoriseret
Model: CLUB-3800

Har du brug for hjælp?

Hvis du har brug for hjælp til Vocopro CLUB-3800 stil et spørgsmål nedenfor, og andre brugere vil svare dig