Westinghouse W24V2DP Manual

Westinghouse Effektmaskine W24V2DP

Læs gratis den danske manual til Westinghouse W24V2DP (2 sider) i kategorien Effektmaskine. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 3.9 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Westinghouse W24V2DP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

SAVE THESE INSTRUCTIONS

mWARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all

instructions listed below may result in electric shock, fire and/or serious personal injury.

mCAUTION! To reduce the risk of injury, charge the 24V lithium-ion battery packs only in

its designated 24V lithium-ion charger. Other types of chargers present risk of fire,

personal injury and damage. Do not wire a battery pack to a power supply plug or car cigarette

lighter. Such misuse will permanently disable or damage the battery packs.

• Avoid dangerous environments – Do not charge the battery packs in rain, snow or in

damp or wet locations. Do not use the battery packs or charger in the presence of explosive

atmospheres (gaseous fumes, dust or ammable materials) because sparks may be

generated when inserting or removing the battery pack, which could lead to a re.

• Charge in a well-ventilated area – Do not block the charger vents. Keep them clear to allow

for proper ventilation. Do not allow smoking or open ames near a charging battery pack.

Vented gases may explode.

NOTE: The safe temperature range for the batteries is 41°F – 105ºF (5°C – 40.5°C). Do not

charge the batteries outside in freezing weather; charge it at room temperature.

• Maintain charger cord – When unplugging the charger, pull the plug, not the cord, from

the receptacle to reduce the risk of damage to the electrical plug and cord. Never carry the

charger by its cord or yank it by the cord to disconnect it from the receptacle. Keep the cord

away from heat, oil and sharp edges. Make sure the cord will not be stepped on, tripped over

or subjected to damage or stress when the charger is in use. Do not use the charger with a

damaged cord or plug. Replace a damaged charger immediately.

• Using the wrong, Do not use an extension cord unless it is absolutely necessary –

damaged or improperly wired extension cord poses a risk of re and electric shock.

• The charger must be plugged into an appropriate Charger is rated for 120 volt AC only –

receptacle.

• Use only recommended attachments – Use of an attachment not recommended or sold by

the battery charger or battery pack manufacturer may result in risk of re, electric shock or

personal injury.

• Make sure to remove the battery packs from Unplug charger when not in use –

unplugged charger.

mWARNING! To reduce the risk of electric shock, always unplug the charger before

performing any cleaning or maintenance. Do not allow water to ow into the charger. Use a

Ground Fault Circuit Interrupter (GFCI) to reduce shock hazards.

• Store your charger in a cool, dry place – Do not store charger where temperatures may

exceed 105ºF (40.5ºC), such as in direct sunlight or inside a vehicle or metal building during

the summer.

Charge times vary. Refer to battery specications.

Charger Input .................................................................................................120V AC, 60 Hz, W160

Charger Output ....................................................................................................... 26V DC, 2 x 2.2A

Battery Charge Level Indicator

Each battery pack is equipped with a push button for checking the charge level. Simply press the

push button to read o the battery charge level from the LEDs of the battery indicator:

When to Charge the Lithium-Ion Batteries

NOTE: The 24V lithium-ion battery packs do not develop a “memory” when charged after only

a partial discharge. Therefore, it is not necessary to run down the battery pack before

connecting it with the charger.

• Use the battery charge indicator lights to determine when to charge your 24V

lithium-ion battery packs.

• You can “top-off” your battery packs’ charge before starting a big job or after a

long day of use.

Charge the Battery

1. Press the push lock buttons on the battery to pull it out of the equipment.

2. Check that the mains voltage is the same as that marked on the rating plate of the battery

charger. Then, insert the charger’s plug into the electrical wall outlet. When you plug in the

charger, the top right green light will illuminate and stay green (Fig. ).1

3. Place the battery packs into the charger by sliding the packs to lock them into position.

When you insert the batteries into the charger, the two green lights will go off, and the red

lights will illuminate to indicate that the batteries are charging (Fig. 3).

SAFETY INSTRUCTION

TECHNICAL DATA

OPERATION

W24V2DP

24V 2x2 .2 AMP

DUAL CHARGER

FOR WESTINGHOUSE 24V BATTERIES

To register your Westinghouse battery pack on-line, visit us at:

wpowereq.com/pages/warranty-registration

•All 3 A, B, C LEDs are lit: Battery charge level is high.

•Light A, B LEDs are lit: Battery charge level is decreasing. Stop work as

soon as possible.

•Light A LED is lit: Battery is flat. Stop work IMMEDIATELY and charge the

battery. Otherwise the battery’s service life will be greatly shortened.

* Generates 48 V max with two 24 V* lithium-ion batteries. Initial no-load voltage, per fully charged battery, peaks at 24 V*.

Nominal voltage under typical load is 21.6 V.

**Not compatible with 24V ystem batteries 8.0 Ah and above. S

4. When the charger lights turn green, the batteries are fully charged (Fig. 3).

NOTE: A fully discharged pack with an internal temperature in the normal range will fully

charge in 1 hrs and 50 mins (between 32°F/0°C and 113°F/45°C).

5. If the light indicators do not come on at all, check that the battery packs are fully seated into

the bay. Remove the battery packs and reinsert. If the problem persists, contact

Westinghouse Outdoor Power Equipment (855) 944-3571.

6. When charging is complete, remove the batteries from the charger by pressing the push

lock buttons and sliding the batteries upward to unlock them from the charger

(Fig. ).3

Charge a Hot or Cold Battery Pack

The green indicator light on the charger base indicates that the battery pack temperature is

outside the charging range. Once the pack is within the acceptable range, normal charging will

take place and the red light will be continuous. Hot or cold battery packs may take longer to

charge.

Battery + Charger O-Season Storage

1. Do not expose your battery pack or charger to water, rain or allow them to get wet. This s

could permanently damage the charger and the battery pack . Do not use oil or solvents to s

clean or lubricate your battery pack as the plastic casing can become brittle and crack, s

causing a serious risk of injury.

2. Store the battery pack and charger at room temperature away from moisture. Do not store s

in damp locations where corrosion of terminals may occur. As with other battery pack

types, permanent capacity loss can result if the battery packs are stored for long periods of

time at high temperatures (over 120ºF/49ºC).

3. 24V lithium-ion battery packs maintain their charge during storage longer than other battery

pack types. As a general practice, it is best to unplug the battery charger and remove the

battery packs when they are not in use. Recharge the battery packs every 6 60% months to

capacity (2 lights on) during off-season storage to maintain optimal battery performance.

If your lithium-ion charger requires service or maintenance, please call the Westinghouse

Westinghouse Outdoor Power Equipment (855) 944-3571.

When contacting the company, or arranging service from an authorized dealer, you will need to

provide the model and serial numbers, which can be found on the decal located on the housing

of the unit.

Federal Communications Commission (FCC)

Class B Device:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment o and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Lithium-Ion Charging Status

Battery Pack

Temperature

Charger Base

Indicator Light

Battery Pack

Indicator Light Charging Status

Too hot Green Light C Flashing Not charging

Normal range Red Flashing one by one Normal charging

Too cold Green Not charging

SERVICE AND SUPPORT

MODEL + SERIAL NUMBER

Light C Flashing

Produkt Specifikationer

Mærke:	Westinghouse
Kategori:	Effektmaskine
Model:	W24V2DP

Har du brug for hjælp?

Hvis du har brug for hjælp til Westinghouse W24V2DP stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Effektmaskine Westinghouse Manualer

Westinghouse WSnow20 Manual

8 November 2024

Westinghouse W24V4AH Manual

8 November 2024

Westinghouse WSnow22 Manual

8 November 2024

Westinghouse WSnow22T Manual

8 November 2024

Westinghouse WSnow13ST Manual

7 November 2024

Westinghouse WSnow18T Manual

7 November 2024

Westinghouse WSnow11SD Manual

7 November 2024

Westinghouse W24V8AH Manual

7 November 2024

Westinghouse W24V2AH Manual

7 November 2024

Westinghouse WSnow11ST Manual

7 November 2024

Effektmaskine Manualer

Nyeste Effektmaskine Manualer

BeamZ LCB400IP Manual

17 Juni 2025

BeamZ BTM250FC Manual

16 Juni 2025

GLP Fusion EXO Spot 30 Manual

16 Juni 2025

BeamZ BAC803 Manual

16 Juni 2025

Light4Me JET 2500 Manual

16 Juni 2025

GLP FUSION Exo Wash 30 Manual

10 Juni 2025

BeamZ BTM100FC Manual

10 Juni 2025

Light4Me FOG 400 LED Manual

9 Juni 2025

Light4Me FOG 1200 LED V2 Manual

9 Juni 2025

Light4Me FOG 400 Manual

9 Juni 2025