Whirlpool ADP 2315 Manual


Læs gratis den danske manual til Whirlpool ADP 2315 (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Whirlpool ADP 2315, eller vil du spørge andre brugere om produktet?

Side 1/8
GB -1-
Chart
PROGRAMME
SELECTION BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required programme
lights up (see “Table of
programmes” below).
START/RESUME BUTTON
Push this button to start the selected programme:
the indicator lights up and goes off at the end of the
programme. When the door is opened during a
washing cycle, the cycle is temporarely paused: the
Start indicator blinking. To restart the cycle close
the door and push Start button again.
BUTTON
Push this button to switch on or switch off the control panel.
If pressed when a programme is running it cancels
the programme ongoing.
If the indicator flashes repeatedly, see page 5 -
chapter ”What to do if ...”.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with for Testing Institutes: for EN 50242 regulations. - Note
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Table of programmes Deter-
gent
Consumption
PProgrammes Loading instructions Litres kWh Minutes1)
1Pre-Wash cold Crockery to be washed later. 5.0 0.02 10
2Quickwash 40°C Lightly soiled crockery, with no dried-
on food. X 13.0 0.70 30
3Eco 2) 50°C Normally soiled crockery. X 15.0 1.05 150
4Intensive 70°C Recommended programme for heavily
soiled crockery, especially suitable for
pans and saucepans. X 17.0 1.65 145
5Half Load 50°C Ideal for washing a half load of lightly or
normally soiled crockery. X 13.0 1.00 130
5019 396 01824ADP 2315
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
Quick reference guide
GB -2-
First time use
1- salt reservoir
2- rinse aid dispenser
3- detergent dispenser
4- racks system
5,6,7,8- available functions on the panel
9- filters
10- spray arms
1. Ask your water supply company what the water hardness is... 2. ...enter this value on
your dishwasher Suggestions for detergent use
German
degrees °dH French
degrees °fH English
degrees °eH Water hardness
level
3 first PROGRAM LEDs
lit on the panel
(see table of programmes)
P1 P2 P3
Gel or Powder
(rinse aid and
salt) Ta b le t s
0 - 5 0 - 9 0 - 6.3 Soft 1
go to step 1
(see “Daily
check”)
6 - 10 10 - 18 7 - 12.6 Medium 2
11 - 15 19 - 27 13.3 - 18.9 Average 3
16 - 21 28 - 37 19.6 - 25.9 Medium-hard 4 if water is
HARD extra salt
needs to be
added
(go to step 1,
“Daily check”)
22 - 28 38 - 50 26.6 - 35 Hard 5
29 - 35 51 - 63 35.7 - 44.1 Very hard 6
36 - 60 64 - 107 44.8 - 74.9 Extremely hard 7
Water hardness should be set only
before the first wash or if water
hardness has been changed
1Visual indicator
(depending
on the model).
Unscrew cap.
Fill the salt reservoir with water
before the first wash only.
(depending on the model)
The salt level indicator lamp may remain lit
at the end of several wash cycles. If the
water hardness level falls within category
(soft), no salt is required.
Salt indicator on the control panel Salt indicator on the salt reservoir cap
The indicator lamp lights up when SALT
NEEDS TO BE ADDED. orange:
OK. clear: NEEDS TO
BE ADDED
Daily check
Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!)
- Press and hold together Programs and buttons for minimum 3 seconds.
- Programmes LEDs will indicate the water hardness setting.
- Press the button to increase setting (when the level reaches 7, the next key press will set the level back to 1.Programs
- Wait 30 seconds (control panel switches off) or press START/Resume button to save setting.
Add salt (never add detergent!)
min. 1.5 kg / max. 2 kg
Water hardness level is
factory set for medium-hard
water (level 4).
Even if you use tablets which
include salt, you must still add
regeneration salt since such
detergents are not effective
enough at softening hard
water.
Screw on the cap.
Salt residual
around the cap
need to be
removed. Some
salt reservoir have
a level indicator
integrated in the
cap (see below
how to check).
At first time use, the salt reservoir has to be filled independently from water hardness level (see description below in step 1 “Daily check”).
How to set water hardness in order to always assure the best cleaning results


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Opvaskemaskine
Model: ADP 2315

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool ADP 2315 stil et spørgsmål nedenfor, og andre brugere vil svare dig