Whirlpool AFG 8254 NF Manual

Whirlpool Frysere AFG 8254 NF

Læs gratis den danske manual til Whirlpool AFG 8254 NF (2 sider) i kategorien Frysere. Denne vejledning er vurderet som hjælpsom af 51 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 26 anmeldelser. Har du et spørgsmål om Whirlpool AFG 8254 NF, eller vil du spørge andre brugere om produktet?

Side 1/2
GB
PRODUCT SHEET
1. Compartment for freezing
2. Control unit
3. Area for drawers and pull-out baskets
4. Rating plate (inside
the appliance)
5. Ice packs (inside - if provided)
Note: the design of drawers and accessories may vary, depending on the model.
Controls (depending on model)
ADigital temperature display.
BYellow LED: indicates that the fast freeze
function is in operation.
CRed LED: blinks to indicate that the temperature
in the freezer compartment is too high.
DFreezer on/off button.
EInternal temperature control.
FFast freeze button.
GAcoustic alarm mute button.
H“6th Sense” activation LED (blue), (if provided).
Indicates that the “6th Sense” function is active
(see paragraph “6th Sense function”).
Switching on
Storage compartment
Area for freezing
1. Plug in the appliance.
Attention
If the digital display shows only
an illuminated dot, press the
freezer on/off button D.
Six horizontal lines appear on the digital
display.
After about 3 seconds, when the appliance is
warm, (internal temperature above 10°C)
only the two lines in the middle remain
illuminated; The acoustic alarm and red LED
C are activated.
2. Press button G to mute the
acoustic alarm.
The acoustic alarm stops while the red LED
continues to blink.
3. Wait until the temperature
indicated on the digital display
reaches -12°C.
When the temperature reaches -12°C, the
red LED automatically stops blinking.
4. Place food to be frozen and/or
already frozen food in the
freezer.
60301011GB.fm Page 1 Friday, May 12, 2006 11:23 AM
5019 603 01011 D F E PNL GR DKS N FIN
IGB
PRODUCT SHEET
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C.
To alter the internal temperature between -16°C and -24°C, proceed as follows:
Press button E once to adjust the internal temperature: the digital display shows the temperature previously
set.
Each time the button is pressed, the temperature setting is changed by C: the value (between -16°C and
-24°C) blinks cyclically on the display.
Approximately 5 seconds after the button has been pressed for the last time, the set temperature is stored,
the display stops blinking and the current internal temperature is shown on the display.
The 6th Sense function (blue LED) is automatically activated due to door opening and when small amounts
of fresh food are placed in the freezer. The duration of the 6th Sense function varies depending on the
quantity of food loaded in the freezer and ambient temperature. When optimal operating conditions have
been restored the function deactivates automatically and no operation is required.
Note:
The digital display shows internal temperature values between +10°C and -24°C.
In the event of a power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function switches off automatically when freezing is complete.
Alarm signals
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following the
introduction of fresh food in the freezer compartment; this temporary rise in temperature does not affect the
storage of already frozen food in any way.
Defrosting (for No Frost models no operation is required)
This appliance defrosts automatically according to usage and ambient humidity conditions.
Follow the steps detailed in “Switching on the appliance”.
For not No Frost models, follow step 1-6:
Signal Cause Solution
Door open alarm The acoustic alarm is activated The door has been left open
for more than 1 minute
Close the door
Temperature alarm The acoustic alarm and red LED C
are activated
The internal temperature is
above -12°C
Press button G; wait for
the temperature to fall
below -12°C again
Temperature sensor
alarm
The acoustic alarm is activated and
the display shows SF”
Temperature sensor fault Contact After-sales
service
Prolonged power failure
alarm
The acoustic alarm and red LED C
are activated; the display blinks,
indicating the highest temperature
reached following the power failure
Prolonged lack of power
supply, causing the internal
temperature to rise to very
high values at which correct
food storage cannot be
guaranteed
Press button G; the
display now indicates the
current internal
temperture
1. Press the freezer on/off button D. An illuminated dot appears on the digital display.
2. Unplug the appliance or switch off at the main
switch.
3. Fit the drain in place (see figure).
4. Follow the instructions given in the
instructions booklet.
5. Plug in the appliance once again.
6. Press the freezer on/off button D. Follow the steps detailed in “Switching on the
appliance”.
60301011GB.fm Page 2 Friday, May 12, 2006 11:23 AM


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Frysere
Model: AFG 8254 NF

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool AFG 8254 NF stil et spørgsmål nedenfor, og andre brugere vil svare dig




Frysere Whirlpool Manualer

Frysere Manualer

Nyeste Frysere Manualer

Amana

Amana AUF150KW Manual

15 Januar 2025
WLA

WLA VF5000 Manual

14 Januar 2025
Summit

Summit SCFM92 Manual

14 Januar 2025
Balay

Balay 3GFF563XE Manual

14 Januar 2025
Zanker

Zanker ZKG120 Manual

14 Januar 2025
Benavent

Benavent CBHM150 Manual

14 Januar 2025
Summit

Summit FS21L Manual

13 Januar 2025
Kenmore

Kenmore 253.22052 Manual

12 Januar 2025
Proline

Proline UFZ168 Manual

12 Januar 2025