Whirlpool FFT M22 9X2B EE Manual

Whirlpool Tørretumblere FFT M22 9X2B EE

Læs gratis den danske manual til Whirlpool FFT M22 9X2B EE (60 sider) i kategorien Tørretumblere. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Whirlpool FFT M22 9X2B EE, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/60

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.

In order to receive a more complete assistance, please

Policies, standard documentation, ordering of spare parts and additional product information can be

found by:

• Visiting our website docs.whirlpool.eu and parts-selfservice.whirlpool.com

• Using QR Code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When

contacting our After-sales Service, please state the codes provided on your product’s identi cation plate.

Quick guide

Before using the appliance carefully read the Safety

Instruction.

xxxxxxxxxxxx

xxxx

OPENING OF THE DOOR DURING THE CYCLE

Laundry can be checked while the drying cycle runs and any

garments already dry can be removed, while drying continues for

the remaining items. After closing the door, press the "Start/Pause"

button to resume machine operation.

Keep the door closed until the cycle end to save time and energy.

DAILY USE

Doing this will keep your machine working at its BEST:

- remember to empty your water tank after each drying cycle.

- remember to clean your lters after each drying cycle.

Refer to the Care & Maintenance section.

1. Plug the dryer into the power supply socket.

2. Open the door and load garments; always refer to instructions on

clothing labels and the max loads indicated in the programme

section. Empty pockets. Make sure garments do not get caught

between the door and/or the door lter. Do not load items that

are dripping wet. Do not tumble dry large, very bulky items.

3. Close the door.

4. Press the "On/O" button.

5. Select the most suitable programme

for the type of fabric in that

load.

6. Select the options, if necessary.

7. Press the "

Start/Pause"

button to begin drying.

8. At the end of the drying cycle, a buzzer will beep. An indicator on

the control panel signals the end of the cycle. Pull the load out

immediately to prevent the formation of creases on laundry.

9. Turn the machine o by pressing the "On/O" button, open the

door and pull the clothing out. If the machine is not switched o

manually, after about a quarter of an hour from the end of the

cycle , the appliance turns o automatically to save energy.

Note that some programme/option accords with "Crease Care"

system. This means that for some hours, after the end of the

drying cycle, the drum rotates at regular intervals to prevent the

formation of creases.

In case of power failure, it is necessary to press the "Start/Pause"

button to restart the cycle.

CARE LABEL

Always check the care labels, especially when placing garments in

the tumble dryer for the  rst time. Below are the most commonly

used symbols:

May be tumble dried.

Do not tumble dry.

Tumble dry – high heat.

Tumble dry – low heat.

FIRST TIME USE

Make sure that the water tank is correctly inserted. Make sure

that the drain hose on the back of the dryer is xed correctly,

either to the dryer’s water tank, or to your domestic drainage

system.

The dryer must be installed in a room with a temperature

ranging between 5°C and 35°C to ensure proper operation.

Before you use your dryer ensure that it has been in a upright

position for at least 6 hours.

CONTROL PANEL

1 ON/OFF button (hold for Reset)

2 Programme selection Knob

3 Start/Pause

Options Buttons*

4 Cycle end

5 High heat

6 Anti tangle (hold for Mute)

7 Dryness level

8 Start lelay

9 Timed drying

10 Rapid (hold for Key lock)

11 Gentle

12 FreshCare+

*Note: some models may have the wording in full instead of the icons.

INDICATORS

Dryness level: Iron dry - Hanger dry - Cupboard dry - Extra dry

Cycle phase: Drying - Cool down - End of cycle

Empty water tank - Clean door lter - Clean bottom lter

Refer to troubleshooting section: Failure: Call after sales service -

DEMO

Demo mode.

78 9

3“

78 9

3“

Produkt Specifikationer

Mærke:	Whirlpool
Kategori:	Tørretumblere
Model:	FFT M22 9X2B EE
Vekselstrømsindgangsspænding:	220 - 240 V
Vekselstrømsindgangsfrekvens:	50 Hz
Bredde:	595 mm
Dybde:	649 mm
Højde:	849 mm
Vægt:	44000 g
Produktfarve:	Hvid
Kontroltype:	Buttons, Rotary
Indbygget skærm:	Ja
Skærmtype:	LED
Strøm:	10 A
Ledningslængde:	1.5 m
Pakkevægt:	46500 g
Pakkedybde:	693 mm
Pakkebredde:	655 mm
Pakkehøjde:	872 mm
Årligt energiforbrug:	258 kWh
Strømforbrug (standby):	1 W
Strømforbrug (slukket):	0.5 W
Placering af apparat:	Fritstående
Inverter-teknologi:	Ja
Støjniveau:	64 dB
Ilægningstype:	Front-læsning
Tromlekapacitet:	9 kg
Forsinket start-timer:	Ja
Near Field Communication (NFC):	Ingen
Børnesikring:	Ja
Justerbare fødder:	Ja
Døråbningsvinkel:	130 °
Tromlemateriale:	Rustfrit stål
Tromle volumen:	120 L
Dør farve:	Sort
Cyklustid:	211 min.
Energieffektivitetsskala:	A++ til D
Filterrengøringsindikator:	Ja
Indikator for resterende tid:	Ja
Indikator for fuld vandtank:	Ja
Wi-Fi kontrolleret:	Ingen
Vendbare døre:	Ingen
Tørreprogrammer:	Blanket, Eco, Jeans/denim, Mix, Sport, Synthetics, Cotton, Iron dry
Tørresystem:	Varmepumpe
Ekstra tørt:	Ja
Antal tørreprogrammer:	15
Energiforbrug:	2.07 kWh
Varmekilde:	Elektrisk