2
ENGLISH HS 40, HS 50, HS 60, HS 70
You demand the best and buy quality – quality provided by Atlas Copco.
We have built for you a reliable and lasting tool. Working effectively and without
endangering your health is only possible if these instructions for use are being read
carefully before first using this tool. We want to satisfy our customers and would like
you to buy again AEG Electric Power Tools from Atlas Copco.
HS 40 HS 50 HS 60 HS 70
Nominal power 500 W 500 W 500 W 500 W. . . . . . . . . . . . . . . . . . . . . . . .
No–load spead 2600 min-1 2600 min-1 2600 min-1 2600 min-1
. . . . . . . . . . .
Cutting length 40 cm 50 cm 60 cm 70 cm. . . . . . . . . . . . . . . . . . . . . . . . . . .
Cutting capacity max. dia. 20 mm 20 mm 20 mm 20 mm. . . . . . . . . . . . . .
Distance between teeth 26 mm 26 mm 26 mm 26 mm. . . . . . . . . . . . . . . .
Weight 3,6 kg 3,7 kg 3,8 kg 3,9 kg. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Please pay attention to the safety instructions in the attached leaflet!
Always disconnect the plug from the socket before carrying out any work on the
machine.
Appliances used at many different locations including open air must be connected
via a current surge preventing switch.
Always wear goggles when using the machine. It is recommended to wear gloves,
sturdy non slipping shoes and apron.
Sawdust and splinters must not be removed while the machine is running.
Before use check machine, cable, and plug for any damages or material fatigue.
Repairs should only be carried out by authorised Service Agents.
Only use splash proof extension cables approved for outdoor purposes.
Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
No person under 16 years of age is allowed to operate the machine.
Do not pierce the motor housing as this could damage the double insulation (use
adhesives).
Never hold the machine by the blades. It should be transported and kept in the
storage sheath.
During operation the machine must be guided with both hands while keeping a safe
footage.
Should blades be blocked (for instance by big branches), disconnect machine by
pulling the plug and remove the obstacle.
Use trimmer only for cutting hedges and shrubs.
Do not use trimmer in rain or on wet hedges.
Typically the A-weighted sound pressure level of the tool is 85 dB (A).
The noise level when working can exceed 85 dB (A).
Wear ear protectors!
Typically the hand-arm vibration is below 2.5 m/s2.
The hedgetrimmer is suitable for trimming and shaping of hedges, bushes and
shrubs. It can also shred garden refuse for composting.
Do not use this product in another way as stated for normal use.
Introduction
Technical Data
Advice for your
safety
Measured sound
value
Measured
vibration value
Use
