Alecto DVM2043C Manual

Alecto Babyalarm DVM2043C

Læs gratis den danske manual til Alecto DVM2043C (2 sider) i kategorien Babyalarm. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Alecto DVM2043C, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Before use

DVM2043C User’s manual

(For use with DVM2043)

Positioning the baby monitor

Connect and power on the baby unit

Quick start guide

What’s in the box

Pair a new baby unit

Each newly purchased baby unit ( ) must be paired to your system ( ).DVM2043C DVM2043

NOTESNOTE

• You can pair an additional baby unit to your parent unit. New baby unit must be paired to the

parent unit before use.

• Make sure you power on the parent unit before pairing.

1. Turn on your parent unit and baby unit.

2. Press when the parent unit is idle.

3. Go to > , select

If you have more baby units: select , then select

4. Press and hold the PAIR button for 3 seconds until you hear a “beep”.

5. When the baby unit is successfully paired with your parent unit, the parent unit

displays and the live video.

Overview - Baby unit

Declaration of conformity

Hereby, Commaxx declares that the radio equip-

ment type Alecto DVM2043C is in compliance with

directive 2014/53/EU. The full text of the EU dec-

laration of conformity is available at the following

Internet address: https://commaxx-certiﬁcates.com/

doc/DVM2043C_doc

Use of this equipment is allowed in all countries

of the EU. In France, Italy, Russia and Ukraine, only

indoor use is allowed.

Information power adaptor baby unit:

Manufacturers name and address:

Vtech Telecommunications LTD, 23/F.,

Tai Ping Industrial Centre, Block 1, 57 Ting Kok Road,

Tai Po, Hong Kong.

Model Identiﬁer: VT05EEU05100

Input voltage: 100 - 240V~

Input AC frequency: 50/60 Hz

Output voltage: 5.0V DC

Output current: 1A

Output power: 5.0 W

Average active efﬁciency: 74.0 %

Efﬁciency at low 10% load: -

No load power consumption: 0.07 W

ATTENTION

Before you start using the product, please remove any

protective foil from the baby unit.

Specications

Range:

up to 50 meters indoors

up to 300 meters outdoors

Baby unit power:

5V DC 1A power adaptor (incl.)

Model: VT05EEU05100

Frequency: 2405-2475 MHz

Modulation: FSK

RF-power: <20 dBm

Important safety instructions

The applied nameplate is located at the bottom of the baby

unit’s base.

1. CAUTION: Do not install the baby unit at a height above

2 metres.

2. Use and store the product at a temperature between

C and 40

x 2

1Light sensor

2Camera

3Infrared LEDs

4Night light

5Microphone

6Speaker

POWER LED light

• On when the baby unit is turned on

and is paired to the parent unit.

• Flashes when the link to the parent unit

has lost.

Night light on/off key

9Antena

10 Temperature sensor

11 Power jack

12 PAIR key

• Press and hold for 3 seconds to enter

paring mode.

13 Slots for wall mounting

Kabel minimaal 1 meter rwijderd ve

houden van baby.

Garder une distance minimal d’un mètre

du bébé.

Das Kabel ist mindestens 1 Mete von r,

dem Ba , ent t zu halten.by fern

Keep ca e at least 1m from babbl away y.

Mantenga el ca e al menos 1 metro de bl

distancia del bebé

V1.1

Connect the power adaptor to the baby unit and a power supply to power on the unit.

Disconnect the baby unit from the power supply to power off.

NOTESNOTE

• Use only the power adaptor supplied with this product.

• Make sure the the baby unit are not connected to an electronically/timer controlled electric power outlet.

• Connect the power adaptor in a vertical or ﬂoor mount position only. The adaptor prongs are not

designed to hold the weight of the baby unit. Otherwise, the adaptor may not properly connect to the

outlets.

• Make sure the the baby unit and the power adaptor cords are out of reach of children.

Caution

• The manufacturing preset volume

of your parent unit is level , and the 4

maximum volume is level 7. If you

experience feedback noise from your

baby monitor while positioning:

- Make sure your baby unit and parent

unit are more than 1 metre apart, OR

- Lower the volume of your parent unit.

Commaxx B.V., Wiebachstraat 37,

6466 NG Kerkrade, The Netherlands

support.alectobaby.nl

- DVM2043C

Video baby monitor - Baby unit

V 1 . 0

Produkt Specifikationer

Mærke:	Alecto
Kategori:	Babyalarm
Model:	DVM2043C

Har du brug for hjælp?

Hvis du har brug for hjælp til Alecto DVM2043C stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Babyalarm Alecto Manualer

Alecto DVM-71C Manual

16 November 2025

Alecto DB-185 Eco Manual

6 November 2025

Alecto DB-188 LUX Manual

3 November 2025

Alecto DBX135 Manual

15 Juli 2025

Alecto DBX130 Manual

11 Juli 2025

Alecto DBX-72ECO Manual

15 Januar 2025

Alecto DBX-98 Babyfoon Manual

13 Januar 2025

Alecto DVM 97 Babyfoon Manual

13 Januar 2025

Alecto fr 66 Babyfoon Manual

13 Januar 2025

Alecto fr 39 Babyfoon Manual

13 Januar 2025

Babyalarm Manualer

Nyeste Babyalarm Manualer

Jane Eye Pro Manual

8 December 2025

Beaba Zen Nomad Manual

16 November 2025

Vtech Safe & Sound DM112-2 Manual

14 November 2025

Beaba Zen Night Manual

14 November 2025

Vtech Safe & Sound DM111 Manual

13 November 2025

NUK Easy Control 200 Manual

13 November 2025

NUK Eco Control Audio 500 Manual

12 November 2025

Beaba ZEN+ 2 Manual

12 November 2025

NUK DEC Eco Control Manual

11 November 2025

Mx Onda MX-SVB7484 Manual

10 November 2025