APC Back-UPS 750VA Manual

APC Uafbrydelig strømforsyning (UPS) Back-UPS 750VA

Læs gratis den danske manual til APC Back-UPS 750VA (8 sider) i kategorien Uafbrydelig strømforsyning (UPS). Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om APC Back-UPS 750VA, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Installation and Operation

Back-UPS® BE750G Series

Safety

Specifications

This unit is intended for indoor use only.

Do not operate this unit in direct sunlight, in contact with fluids, or where there

is excessive dust or humidity.

Connect the Back-UPS power cord directly to a wall outlet. Do not use a surge

protector or an extension cord.

Input

Voltage 120 Vac Nominal

Frequency 50 Hz/60 Hz auto sensing

Brownout Transfers 92 Vrms Typical

Over-voltage Transfer 139 Vrms Typical

Output

UPS Capacity

(5 battery backup outlets)

750 VA, 450 W

Total Amperage (all outlets) 12 A (including UPS output)

Voltage - On Battery 115 Vrms ± 8% step approximated sine wave

Frequency - On Battery 50 Hz/60 Hz ± 1 Hz

Transfer Time 6 ms Typical, 10 ms maximum

Protection and

Filtering

AC Surge Protection Full time, 354 Joules

Phone/DSL/FAX surge protection Single line (2 wire)

Cable/CAT V/DSS surge protection One coax input/output

Network surge protection 10/100 Base -T ethernet

EMI/RFI Filter Full time

AC Input Resettable circuit breaker

Battery

Type Sealed, maintenance-free, lead acid

Replacement battery cartridge RBC17

Average Life 3 - 5 years depending on the number of discharge cycles and

environmental temperature

Physical

Net Weight 11 lb (5 kg)

Dimensions

Length x Width x Height

14 in x 7 in x 4 in

36 cm x 18 cm x 9 cm

Operating Temperature 32º F to 104º F (0º C to 40º C)

Storage Temperature 5º F to 113º F (–15º C to 45º C)

Operating Relative Humidity 0 to 95% non-condensing humidity

Operating Elevation 0 to 10,000 ft (0 to 3000 m)

EMC

Compliance

This device complies with part 68 and part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must accept any

interference received, including interference that may cause undesired operation.

Back-UPS BE750G Series2

Connect the Battery

The Back-UPS is shipped with one battery cable disconnected. Remove the “Stop! Connect the Battery” label that

covers the outlets. Prior to connecting any equipment to the unit, connect the battery cable to the unused battery

terminal. It is normal for small sparks to be seen when the battery cable is connected to the battery terminal.

Wall Mount Installation

• Horizontal installation, use 2 screws 5.9" (150 mm) apart.

• Vertical installation, use 2 screws 5.5" (140 mm) apart.

• Allow 5/16" (8 mm), of the screw to protrude from the wall.

Connect Equipment

Battery Backup + Surge Protection Outlets

Battery backup outlets provide protection to connected

equipment when the Back-UPS is turned on and

connected to utility power.

Battery backup outlets receive power from the

Back-UPS for a limited period of time when a power

outage, or brownout condition occurs.

Battery backup outlets provide protection from power

surges or spikes.

Connect a computer, monitor and other peripheral devices to the outlets.

Surge Protection Outlets

Surge protection outlets provide protection to connected equipment when the Back-UPS is connected to utility

power, and is switched on or off.

Surge protection outlets provide protection from power surges or spikes.

Connect a printer, scanner or other peripheral devices to the surge protection outlets.

 Press the battery compartment cover

release tab located on the rear side of the

unit. Slide the battery cover off.

 Connect the battery cable securely

to the battery terminal.

 Reinstall the battery compartment

cover. Be sure that the release tab

locks into place.

bu076a

bu077a

bu083a

bu207a

Back-UPS

Ma st er

Enable

Battery Backup + Surge Protection

MASTER

Surge Protection

Controlled By MASTER

Produkt Specifikationer

Mærke:	APC
Kategori:	Uafbrydelig strømforsyning (UPS)
Model:	Back-UPS 750VA
Bredde:	180 mm
Dybde:	343 mm
Højde:	88 mm
Vægt:	4700 g
Produktfarve:	Sort
Batteriteknologi:	Blybatterier (VRLA)
Formfaktor:	Kompakt
Opbevaringstemperatur (T-T):	-15 - 45 °C
Relativ luftfugtighed ved drift (H-H):	5 - 95 %
Relativ luftfugtighed ved opbevaring (H-H):	5 - 95 %
Ethernet LAN-porte (RJ-45):	3
Driftstemperatur (T-T):	0 - 40 °C
Støjniveau:	45 dB
Udgangseffekt:	450 W
Certificering:	FCC, NOM, UL
Filtrering:	Ja
LED-indikatorer:	Erstatningsbatteri
Kabellængde:	1.83 m
Batteritype:	RBC17
Opladningstid for batteri:	16 t
Bæredygtighedscertifikater:	RoHS
Driftshøjde:	0 - 3000 m
Ikke-drift højde:	0 - 15000 m
Indgangsfrekvens:	50/60 Hz
Netværksfunktioner:	Hurtigt ethernet
Nominel udgangsspænding:	120 V
Nominel indgangsspænding:	120 V
AC udgange, antal:	10 AC stikkontakt(er)
AC stikkontakt typer:	NEMA 5–15R
Overspænding energivurdering:	354 J
Indgående driftsspænding (maks.):	- V
Output strømkapacitet (VA):	0.75 kVA
Indgående driftsspænding (min.):	- V
Udgangs driftsspænding (min.):	- V
Udgangs driftsspænding (maks.):	- V
Beskyttelsesfunktioner mod strømstød:	A/V,Coax,Fax,Modem,Network,Telephone
Beskyttelse ved overspænding:	Ja