APC GM6 Manual

APC Ikke kategoriseret GM6

Læs gratis den danske manual til APC GM6 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om APC GM6, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/1
Microsoft, Xbox and the Xbox logo are either registered trademarks or trademarks of Microsoft Corporation in the U.S. and/or other countries and are used under license from Microsoft. Copyright © 2002 American Power Conversion. All rights reserved. Patent pending.
This is an APC product that is not endorsed, manufactured or distributed by Microsoft Corporation. 990-0573 8/02 Game Manager is a registered trademark of American Power Conversion
Thank you for purchasing the Xbox Game Manager by APC!
Please read and retain this manual as it provides information on safety, installation, use, storage, product warranty
and more.
Safety
-Do not install this device during a lightning storm.
-For indoor use only.
-Do not install or store this product in a hot or excessively moist location.
and other information.
Indicators and Switches
Protection Working – When the power switch is turned ON (moved to the up position), the green Protection
Working indicator illuminates to show the surge protector is protecting connected equipment from harmful
electrical surges. The equipment is protected even when the Game Manager’s power switch is turned OFF (moved
to the down position). If the Protection Working indicator does not illuminate when the power switch is turned ON
(up position), the unit has sustained damage and is no longer capable of protecting the connected equipment. The
Game Manager should be returned according to the instructions provided (see Limited Warranty).
Site Wiring Fault – This red indicator, when lit, shows that the building wiring presents a potential shock hazard.
If this indicator is lit, contact a qualified electrician to correct the building wiring.
Power Switch/Circuit Breaker – The front panel combination Power switch/circuit breaker applies power to the
surge protector receptacles and acts as a circuit breaker to protect against overload conditions. If the circuit breaker
has tripped due to an overload, unplug one or more pieces of equipment and reset the circuit breaker by turning the
switch OFF (down position) and then back ON (up position).
Connecting equipment to the surge protected outlets:
1. Place the Game Manager Power switch to the OFF (down) position.
2. Plug the Game Manager power cord into a 3-prong, grounded outlet only.
3. Ensure power switches for equipment to be plugged into the Game Manager are in the OFF position. Plug the
power cord from the game console, TV, and other devices into the outlets on the back of the Game Manager (a
separate outlet is provided for one device that uses a transformer block plug).
4. Connect cables to Network and Video Protection Jacks (GMX6VN only):
a. If you are protecting a cable modem or your cable TV box, connect the coaxial cable from the cable wall
jack to the Game Manager jack marked COAX IN. Using the supplied coaxial cable, connect from the
Game Manager jack marked COAX OUT to the cable modem or cable TV box.
b. If using a Local Area Network (LAN) 10-BaseT or 100-BaseT cable to access the Internet or other network,
connect the cable from the wall jack to the Game Manager RJ-45 jack marked NET IN. Using the supplied
network cable, connect from the Game Manager RJ-45 jack marked NET OUT to the equipment.
5. Turn ON the Power switch to supply power (up position) to the connected equipment.
To store games outside of the case – Push the numbered tray release tab to the side to eject a disc tray. Note: There
is only one numbered tab associated with each tray. With the tray open, place a game disc directly on the tray face.
Push the tray back in until it snaps into place. The Game Manager can safely store up to 20 game discs outside of
their original case.
To store up to four Xbox memory cards – Push tab #11 to the side to eject the memory card storage tray. With the
tray open, insert a memory card into a slot. Note: In order to store Xbox memory cards, you must remove tray #9
which is directly above tray #11.
To store games in their original case – The travel modules can be removed to accommodate the storage of up to
eight games in their original cases. To remove each travel module, pull on the exposed edges on the side of the
module until it is removed. Install the supplied guide rails by angling each guide rail slightly outward; insert each
rail until the rail tab aligns with the tab hole in the bottom of the Game Manager bay. Straighten the guide rail until
it snaps into place. This will form the slots to hold games kept in their original cases. Note: There is a left and right
guide rail; the guide rail tab must be down.
(Models GMX6 / GMX6VN)
Game Manager
w
w
w
.apc.com
®
by
!
Protection Working
Indicator
Site Wiring Fault
Indicator
Power Switch/Circuit
Breaker
On/Off
Switch Guard
Game Manager
w
w
w
.apc.com
®
COAX IN COAX OUT
NET IN
NET OUT
NET IN
NET OUT
COAX IN COAX OUT
From Wall
Jack (RJ-45)
To Equipment
(RJ-45)
From Wall
Cable Connector
To Cable Modem
or Cable TV Box
Game Manager
(Rear View)
To Wall
Power Outlet
Transformer Block
Outlet (1)
Equipment
Outlets (5)
(GMX6VN only)
(GMX6VN only)
Optional Storage Bay Labels - Labels have been provided to clearly note where a particular game is located in
the trays. The clear plastic strips on the top allow you to view the labels without opening storage trays. To use the
labels, pull the travel module out of the Game Manager far enough to fold the module cover all the way up or
forward. Slide the travel module back into the Game Manager and apply the label as shown. List the games on the
numbered line that corresponds with the number on the tray release tab.
To store 2 controllers – Snap-on hooks provide storage for up to two controllers while keeping their cords from
getting tangled. Attach the hooks to the sides of the Xbox Game Manager as shown, wrap controller cords around
the hook chassis and position the controller in the hook.
ON/OFF Switch Guard – The Game Manager
comes with a removable switch guard that helps to prevent
accidental turn offs. To remove the switch guard, grasp the edge with your fingernail and pull straight back. To
install the switch guard, position it so that the right mounting tab is inserted into the slot at the right edge of the
On/Off switch. Place your finger through the hole in the center of the switch guard and insert the left mounting
tab into the slot at the left edge of the On/Off switch.
Optional Mounting Feet – The Game Manager
also comes with mounting feet which allow you to safely and
securely place the game console directly on top of the Game Manager. Peel off the backing on each piece and
position onto top of unit as shown.
Technical Specifications
Nominal Operating Voltage 120Vac, 50-60 Hz
Operating Temperature 0
o
to 40
o
C (32
o
to 104
o
F)
Operating Relative Humidity 0 to 95%, non-condensing
Let-through Voltage Rating <330V
Safety Approval UL1449 Second Edition, CSA
Please note: The Warranty and Equipment Protection Policy are contained on a separate page.
Storage Bay
Label
Travel
Module
Clear Plastic
Strip
Module Cover
Game Controller
(1 each side)
Snap-on Hook
(1 each side)
ON/OFF Switch
Guard
Optional
Mounting Feet
Guide
Rail
(2 each bay)
CD-ROM / DVD
Case
Travel
Module
Guide
Rail Tab
Tab
Hole
USA/Canada 1.800.800.4272
Mexico 292.0253 / 292.0255
Worldwide 1.401.789.5735
Internet www.apc.com
Tech Support http:\\www.apc.com/support
Memory
Card
Memory Card
Tray (1)
CD-ROM / DVD
CD-ROM / DVD
Tray (20)
Tray Release
Tab (one per tray)
(up to 4)
Tray Release
Tab #11

Produkt Specifikationer

Mærke: APC
Kategori: Ikke kategoriseret
Model: GM6

Har du brug for hjælp?

Hvis du har brug for hjælp til APC GM6 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret APC Manualer

APC

APC NetShelter AP7900B Manual

30 Oktober 2025
APC

APC NetBotz Sensor Pod AP9335TH Manual

9 September 2025
APC

APC AR7752W Manual

30 August 2025
APC

APC E3SXR7 Manual

5 August 2025
APC

APC E3MCBC7D Manual

4 August 2025
APC

APC Galaxy VS GVSOPT004 Manual

4 August 2025
APC

APC PME5B-GR Manual

4 August 2025
APC

APC SRT192RMBPM Manual

15 Juli 2025
APC

APC EPDU1216B Manual

15 Juli 2025
APC

APC APV9602 Manual

15 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Duravit

Duravit L-Cube LC614302222 Manual

21 December 2025
Delta

Delta RP36498 Manual

21 December 2025
WAC Lighting

WAC Lighting LTK-764 Manual

21 December 2025
WAC Lighting

WAC Lighting BA-ACLED24 Manual

21 December 2025
AEG

AEG OT350WB1 Manual

21 December 2025
Wine-Mate

Wine-Mate WM-2500SSR Manual

21 December 2025
Vaxcel

Vaxcel T0774 Manual

21 December 2025
Signature Hardware

Signature Hardware Eaton 480901 Manual

21 December 2025
Delta

Delta 23C644 Manual

21 December 2025
Akasa

Akasa Pascal A-NUC24-A1B Manual

21 December 2025