APC Smart-UPS Ultra SRTL5KTF Manual

APC Uafbrydelig strømforsyning (UPS) Smart-UPS Ultra SRTL5KTF

Læs gratis den danske manual til APC Smart-UPS Ultra SRTL5KTF (12 sider) i kategorien Uafbrydelig strømforsyning (UPS). Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om APC Smart-UPS Ultra SRTL5KTF, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

Installation Guide

APC™ Smart-UPS™ Ultra Isolation and

Step-Down Transformer SRTL5KTF

Important Safety Instructions

SAVE THESE INSTRUCTIONS - This manual contains important instructions that should be followed during

installation and maintenance of the Smart-UPS Industrial UPS and batteries.

Read the user documentation to become familiar with the equipment before trying to install or operate it.

Read these instructions carefully and look at the equipment to become familiar with the device before trying to install,

operate, service or maintain it. The following special messages may appear throughout this bulletin or on the equipment

to warn of potential hazards or to call attention to information that clarifies or simplifies a procedure.

The addition of this symbol either to a “Danger” or “Warning” safety label indicates that an electrical

hazard exists which will result in personal injury if the instructions are not followed.

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety

messages that follow this symbol to avoid possible injury or death.

Product Handling Guidelines

DANGER

DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.

WARNING

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious

injury.

CAUTION

CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate

injury.

NOTICE

NOTICE is used to address practices not related to physical injury.

<18 kg

<40 lb

18-32 kg

40-70 lb

32-55 kg

70-120 lb

>55 kg

>120 lb

Isolation and Step-Down Transformer SRTL5KTF2

Safety Information

• Adhere to all national and local electrical codes.

• All wiring must be performed by a qualified electrician.

• Changes and modifications to this unit not expressly approved by Schneider Electric could void the

warranty.

• This transformer is intended for indoor use only.

• Do not operate this transformer in direct sunlight, in contact with fluids, or where there is excessive dust or

humidity.

• Be sure the air vents on the transformer are not blocked. Allow adequate space for proper ventilation.

• For a transformer with a factory installed power cord, connect the transformer power cable directly to an

output receptacle of the UPS. Do not use surge protectors or extension cords.

• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.

• For rack mount transformers, always install the transformer directly above the UPS in rack-mount

configuration. The UPS must be installed below the transformer.

• Always install peripheral equipment above the transformer in rack-mount configuration.

• Additional safety information can be found in the Safety Guide supplied with this unit.

Electrical safety

• The protective earth conductor for the transformer carries the leakage current from the load devices

(computer equipment). An insulated ground conductor is to be installed as part of the branch circuit that

supplies the transformer. The conductor must have the same size and insulation material as the grounded

and ungrounded branch circuit supply conductors. The conductor will typically be green and with or

without a yellow stripe.

• The UPS input ground conductor must be properly bonded to protective earth at the service panel.

• If the UPS input power is supplied by a separately derived system, the ground conductor must be properly

bonded at the supply transformer or motor generator set.

• Be sure that all the covers and panels are installed before operating the transformer.

• Do not insert any metal object through the ventilation openings.

• Be sure to turn off the input to the transformer and check the voltage at the output terminals is zero before

attempting to service or maintain the transformer.

Hardwire safety

• Verify that all branch circuit (mains) and low voltage (control) circuits are deenergized, and locked out

before installing cables or making connections, whether in the junction box or to the transformer.

• Wiring by a qualified electrician is required.

• Check national and local codes before wiring.

• All openings that allow access to transformer hardwire terminals must be covered. Failure to do so may

result in personal injury or equipment damage.

• Select wire size and connectors according to national and local codes.

General information

• The model and serial numbers are located on a small, rear panel label.

• Recycle the package materials or save them for reuse.

FCC Class A Radio Frequency Warning

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15

of the FCC Rules. These limits are intended to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

Produkt Specifikationer

Mærke:	APC
Kategori:	Uafbrydelig strømforsyning (UPS)
Model:	Smart-UPS Ultra SRTL5KTF

Har du brug for hjælp?

Hvis du har brug for hjælp til APC Smart-UPS Ultra SRTL5KTF stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Uafbrydelig strømforsyning (UPS) APC Manualer

APC E3MCBC10B Manual

6 August 2025

APC Back-UPS BE700G3 Manual

5 August 2025

APC GVSBPIT75 Manual

5 August 2025

APC GVLMBCA200K500H Manual

4 August 2025

APC E3SBPAR10K40F Manual

4 August 2025

APC BE650G2-GR Manual

4 August 2025

4 August 2025

4 August 2025

4 August 2025

4 August 2025

Uafbrydelig strømforsyning (UPS) Manualer

Nyeste Uafbrydelig strømforsyning (UPS) Manualer

ATen EC1000 Manual

28 September 2025

Riello SEP 1500 Manual

20 September 2025

Riello Dialog Vision Manual

20 September 2025

Panamax MB1000 Manual

4 September 2025

Panamax MB1500 Manual

4 September 2025

Akyga AK-ND-41 Manual

30 August 2025

CyberPower HSTP3T30KEBCWOB Manual

20 August 2025

Vorago UPS-400 Manual

20 August 2025

CyberPower RT33020KE Manual

20 August 2025

CyberPower Value2200EILCD Manual

20 August 2025