APC SRT001 Manual


Læs gratis den danske manual til APC SRT001 (10 sider) i kategorien Uafbrydelig strømforsyning (UPS). Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om APC SRT001, eller vil du spørge andre brugere om produktet?

Side 1/10
Installation Guide Smart-UPSOn-Line
SRT001/SRT004/SRT005/SRT008
Important Safety Information
Read the instructions carefully to become familiar with the equipment before trying to install, operate,
service or maintain it. The following special messages may appear throughout this manual or on the
equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a
procedure.
The addition of this symbol to a Danger or Warning safety label indicates that an electrical hazard
exists which will result in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid possible injury or death.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is
any damage.
Adhere to all local and national electrical codes.
Recycle the packaging.
Deenergizing safety
The UPS contains internal batteries and may present a shock hazard even when disconnected from the
branch circuit (mains). Before installing or servicing the equipment, check that the internal batteries are
removed, that external extended run batteries are disconnected and the branch circuit (mains) is
disconnected.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in minor or
moderate injury.
CAUTION
CAUTION addresses practices not related to physical injury including certain environmental
hazards, potential damage or loss of data.
Smart-UPS On-Line SRT001/SRT004/SRT005/SRT0082
Hardwire safety
Verify that all branch circuit (mains) and low voltage (control) circuits are deenergized, and locked out
before installing cables or making connections, whether in the junction box or to the UPS.
Wiring by a qualified electrician is required.
Adhere to all national and local codes.
Select wire size and connectors according to national and local codes.
Strain relief is required for all hardwiring.
All openings allowing access to UPS hardwiring terminals must be covered. Failure to do so may
result in personal injury or equipment damage.
Package Contents
The UPS and PDU models may vary in appearance from those depicted in the diagrams. The PDU
installation procedure is similar for SRT001/SRT004/SRT005 models.
SRT001 SRT004 SRT005
1 Output Hardwire Kit
• 4 screws
• 1 PDU
• 4 screws
• 1 PDU
• 4 screws
SRT008
• 1 PDU
• 2 screws
s
u08
74a
su0875
a
su087
6a
suo0857a


Produkt Specifikationer

Mærke: APC
Kategori: Uafbrydelig strømforsyning (UPS)
Model: SRT001

Har du brug for hjælp?

Hvis du har brug for hjælp til APC SRT001 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Uafbrydelig strømforsyning (UPS) APC Manualer

Uafbrydelig strømforsyning (UPS) Manualer

Nyeste Uafbrydelig strømforsyning (UPS) Manualer