Aquatic AV AQ-RFDM-4F Manual

Aquatic AV Joystick AQ-RFDM-4F

Læs nedenfor 📖 manual på dansk for Aquatic AV AQ-RFDM-4F (1 sider) i kategorien Joystick. Denne guide var nyttig for 23 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Mounting Instructions for Flush Mount, Fixed Waterproof Remotes
AQ-WR-4F / AQ-RFDM-4F
Aquatic AV recommends the “measure twice, cut once” method!
1. Measure and trace the required mounting hole (52.5 mm diameter) in the desired location.
2. Use a Hole Saw to cut out the hole.
3. Make sure the remote ts snuggly into the hole before proceeding any further.
4. For AQ-WR-4F model - install the required length of Aquatic AV extension cable* from the source unit to the remote
mounting position, making sure the cable is not stretched or compromised at any point.
5. Insert and secure the two mounting screws into the rear of the remote control (see ‘A below).
6. Attach the U-shaped bracket (see ‘B’ below) over the two mounting screws and secure the into the desired location, making
sure to leave enough clearance to secure the mounting screws tightly.
Note: the U-shaped bracket can be shortened to achieve the ideal mounting on surfaces of different thickness/depth.
A
B
*AQ-WR-4F model only will require an extension cable (sold seperately):
AQ-EXT-3 (3ft length), AQ-EXT-12 (12ft), AQ-EXT-24 (24ft)


Produkt Specifikationer

Mærke: Aquatic AV
Kategori: Joystick
Model: AQ-RFDM-4F

Har du brug for hjælp?

Hvis du har brug for hjælp til Aquatic AV AQ-RFDM-4F stil et spørgsmål nedenfor, og andre brugere vil svare dig




Joystick Aquatic AV Manualer

Joystick Manualer

Nyeste Joystick Manualer