Audac MBK106V Manual

Audac Højttaler MBK106V

Læs gratis den danske manual til Audac MBK106V (2 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 6 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 3.5 anmeldelser. Har du et spørgsmål om Audac MBK106V, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
MBK106V installation manual - V1.0 1
Installation manual
MBK106V
Step 2:
Insert the M8 bolts through the rubber and metal washers
and into the center threaded holes (top and bottom).
The U-bracket will be placed between those rubber
washers and speaker should be placed to the desired slots.
The bolts should stay up just high enough so that the
intended slot in the bracket can be hooked in. Place the
speaker in the correct position and tighten both M8 bolts.
Attach the drop safety wire to one of the M10 flying points.
The other end of the wire is attached to a separate mounting
point on the wall.
Place the VEXO106 in your desired pitch angle and tighten
the bolts.
Step 1:
Mount the U-bracket at a designated location on the wall
or ceiling.
The screws are inserted into the holes provided on the
bracket. Use the correct fasteners for the surface on
which the bracket is to be mounted.
Caution:
Choose fasteners that are consistent with all local build
codes and requirements to support the weight of the
loudspeaker.
The MBK106V mounting bracket is specially designed for mounting the VEXO106 speaker. This optional clever
U-brackets allow the easy installation of the VEXO106 both horizontally and vertically. Thanks to the dual slotted
design, the VEXO106 can be mounted two different positions. The rear slot provides an installation closer to the
mounted surface that gives clear and neat impression.
Included hardware:
Installation:
Drop safety wire
x2
M8 screws with
washers
x2
Rubber washer
U-bracket
x2
Metal washer
MBK106V installation manual - V1.0 2
Dimensions:
ALWAYS FOLLOW THE LOCAL REGULATIONS AND
REQUIREMENTS REGARDING INSTALL ATIO N,
SUSPEN SI O N AND CONNEC TION O F THIS
LOUDSPEAKER. EVEN WHEN OTHERWISE SPECIFIED
IN THIS DOCUMENT.
IT’S THE INSTALLERS RESPONSIBILITY TO ENSURE
INSTALLATION OF THE LOUDSPEAKERS AND MOUNTING
SYSTEMS IS PERFORMED IN ACCORDANCE WITH ALL
APPLICABLE CODES
UNSAFE MOUNTING OR OVERHEAD SUSPENSION ON
ANY HEAVY LOAD CAN RESULT IN SERIOUS INJURY OR
DEATH, AND PROPERTY DAMAGE. IT’S THE INSTALLERS
RESPONSIBILITY TO EVALUATE THE RELIABILITY OF ANY
MOUNTING METHOD USED FOR THEIR APPLICATIONS
THE INSTALLATION OF THIS LOUDSPEAKER SHALL BE
DONE BY QUALIFIED PERSONNEL ONLY.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
NEVER THROW THEM AWAY
ALWAYS HANDLE THIS UNIT WITH CARE
CLEAN ONLY WITH DRY CLOTH
HEED ALL WARNINGS AND FOLLOW ALL INSTRUCTIONS
NEVER EXPOSE THIS EQUIPMENT TO RAIN, MOISTURE,
ANY DRIPPING OR SPLASHING LIQUID.
DO NOT PLACE THIS UNIT IN ENVIRONMENTS WITH A
HIGH LEVEL OF DUST, HEAT, MOISTURE OR VIBRATION
DO NOT USE HYDROCARBON BASED SOLVENTS,
LUBRICANTS OR CLEANING AGENTS OF ANY TYPE ON
OR AROUND THE DEVICE AND MOUNTING HARDWARE
DURING THE INSTALLATION. THE USE OF THESE
PRODUCTS ON OR AROUND THE MOUNTING ANCHORS
AND SCREWS CAN LEAD TO DEGRADATION OF THE
PLASTIC MATERIAL, POSSIBLY RESULTING IN CRACKING
AND PREMATURE FAILURE OF THE PRODUCT.
THIS UNIT IS DEVELOPED FOR INDOOR USE ONLY. DO
NOT USE IT OUTDOORS
ONLY USE ATTACHMENTS & ACCESSORIES SPECIFIED BY
THE MANUFACTURER.
ONLY INSTALL THE SPEAKER IN LOCATIONS THAT CAN
STRUCTURALLY SUPPORT THE WEIGHT OF THE SPEAKER.
IGNORING THIS CAN BRING THE SPEAKER DOWN.
DO NOT USE ANY OTHER METHOD THAN SPECIFIED TO
MOUNT THE SPEAKER. IF EXTREME FORCE IS APPLIED
TO THE SPEAKER, IT COULD FALL DOWN
ATTACH A SAFETY WIRE TO THE SPEAKER WHEN IT IS
MOUNTED HIGH UP. ONLY USE INDUSTRYACCEPTED
RIGGING TOOLS AND METHODS
CAREFULLY CHECK THE UNIT’S CONDITION AFTER
UNPACKING.
IF THERE IS ANY DAMAGE TO THE CARTON BOX OR THE
UNIT ITSELF, INFORM YOUR VENDOR IMMEDIATELY.
PRECAUTIONS
This product contains no user serviceable parts. Refer all
servicing to qualified service personnel. Do not perform
any servicing (unless you are qualified to do so).
CAUTION - SERVICING
This product conforms to all the essential requirements
and further relevant specifications described in
following directives: 2011/65/EU (RoHS2) and 1907/2006
(REACH)
EC DECLARATION OF CONFORMITY
DO NOT MAKE UNAUTHORIZED ALTERATIONS TO THE
PRODUCT.
• The MBK106V mounting bracket is for the use with
VEXO106 only.
MBK106V
A
378 mm
B
41 mm / 21 mm
C
205 mm
D
196 mm
E
370 mm
F
150 mm
G
35 mm
H
60 mm
A
B C
D
E
F
G
H

Produkt Specifikationer

Mærke: Audac
Kategori: Højttaler
Model: MBK106V

Har du brug for hjælp?

Hvis du har brug for hjælp til Audac MBK106V stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Audac Manualer

Audac

Audac ARCHI10X Manual

7 Juli 2025
Audac

Audac CIRA530D Manual

6 Juli 2025
Audac

Audac CIRA524 Manual

5 Juli 2025
Audac

Audac CENA706 Manual

4 Juli 2025
Audac

Audac ATEO 6D Manual

29 Juni 2025
Audac

Audac BASSO112 Manual

6 Juni 2025
Audac

Audac BASSO118 Manual

4 Juni 2025
Audac

Audac MBK106V Manual

4 Juni 2025
Audac

Audac BASSO115 Manual

1 Juni 2025
Audac

Audac ARCHI210 Manual

29 Marts 2025

Højttaler Manualer

Nyeste Højttaler Manualer

TOA

TOA SC-615M Manual

27 Juli 2025
TOA

TOA SC-615 Manual

27 Juli 2025
Panasonic

Panasonic SC-TMAX15 Manual

26 Juli 2025
Valcom

Valcom VIP-9831A Manual

26 Juli 2025
Panasonic

Panasonic SoundSlayer SC-GNW10 Manual

26 Juli 2025
Lenco

Lenco BTL-030 Manual

25 Juli 2025
Panasonic

Panasonic SC-NE5GS Manual

25 Juli 2025
Valcom

Valcom VIP-9815A Manual

25 Juli 2025
Fenton

Fenton BoomBox340 Manual

25 Juli 2025
Fenton

Fenton SHF700 Manual

25 Juli 2025