Bauknecht GTE 255 A++ Manual

Bauknecht Fryser GTE 255 A++

Læs nedenfor 📖 manual på dansk for Bauknecht GTE 255 A++ (4 sider) i kategorien Fryser. Denne guide var nyttig for 56 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
1. Lid handle.
2. Lock (if provided).
3. Seal.
4. Defrost water drain plug (depending on model).
5. Control panel.
6. Basket (depending on model).
7. Condenser (located at the rear).
INSTALLATION
Refer to chapter “Before using the appliance”.
Unpack the appliance.
Remove the 4 protection pieces inserted between
lid and appliance.
Warning: two of the four protection pieces must
be fitted in the seat of the condenser plastic
supports, located at the rear of the product.
This is necessary to ensure the correct distance from the
wall.
Ensure that the defrosting water drainage plug
(if provided) is correctly positioned (4).
For best operation of the appliance and in order to avoid
damage when the lid is opened, leave a space of at least
7 cm from the rear wall and 7 cm at the sides.
Fit the accessories (if provided).
1. Red LED: when flashing, it indicates that an alarm
condition is present (see "TROUBLESHOOTING
GUIDE"
2. Yellow LED: indicates that the fast freeze function is
active.
3. Green LEDS: they indicate that the appliance is in
operation, and the temperature has been set.
4. Temperature setting button: to adjust the set
temperature and to activate/deactivate the fast freezing
operations.
Switching on the appliance
Plug in the appliance.
The green LED lights up ("Min").
The red LED (if present) flashes to indicate that the
temperature inside the appliance is not yet sufficiently
low for food storage. The red LED will normally switch
off within the first six hours after the appliance is
switched on.
Place food inside the product only when the red LED
has switched off.
Note:
Thanks to the efficient lid seal, the appliance lid will not re-
open easily immediately after closing. Wait a few minutes
before re-opening the lid of the appliance.
Temperature adjustment
Use the key (4) to select the desired temperature.
To adjust the internal temperature, proceed as follows:
Repeatedly press the key (4). Each time the key is
pressed, the set temperature is updated, displaying the
"Min", "Optimum" and "Max" values in succession.
Select "Max" for a colder storage temperature.
With partial loads "Optimum" is recommended: this
setting will optimize energy consumption.
Note:
The settings will be saved in the memory even if a power
cut occurs. The time needed for the temperature inside
the freezer to reach the set value, can vary depending on
climatic conditions and the set temperature itself.
Climatic Class Amb. T. (°C) Amb. T. (°F)
SN From 10 to 32 From 50 to 90
N From 16 to 32 From 61 to 90
ST From 16 to 38 From 61 to 100
T From 16 to 43 From 61 to 110
INSTRUCTIONS FOR USE
GB


Produkt Specifikationer

Mærke: Bauknecht
Kategori: Fryser
Model: GTE 255 A++
Vekselstrømsindgangsspænding: 220 - 240 V
Vekselstrømsindgangsfrekvens: 50 Hz
Bredde: 1120 mm
Dybde: 660 mm
Højde: 885 mm
Vægt: 50000 g
Produktfarve: Hvid
Produkttype: Kummefryser
Ledningslængde: 2 m
Energieffektivitetsklasse (gammel): A++
Årligt energiforbrug: 164.25 kWh
Placering af apparat: Fritstående
Tilsluttet belastning: 90 W
Støjniveau: 40 dB
Fryser, netto rumindhold: 225 L
Fryser, brutto rumindhold: 230 L
Frysekapacitet: 23 kg/24t
Opbevaringstid under strømafbrydelse: 50 t
Hurtig frys funktion: Ja
Fryser antal hylder/kurve: 2
Åben dør alarm: Ingen
Energiforbrug: 0.45 kWh/24t

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GTE 255 A++ stil et spørgsmål nedenfor, og andre brugere vil svare dig




Fryser Bauknecht Manualer

Fryser Manualer

Nyeste Fryser Manualer