Bauknecht GTE 822 A+++ Manual

Bauknecht Fryser GTE 822 A+++

Læs gratis den danske manual til Bauknecht GTE 822 A+++ (4 sider) i kategorien Fryser. Denne vejledning er vurderet som hjælpsom af 43 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 22 anmeldelser. Har du et spørgsmål om Bauknecht GTE 822 A+++, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

INSTRUCTIONS FOR USE

DIAGRAM OF THE APPLIANCE (Fig. 1)

A. Handle.

B. Safety lock (if provided).

C. Gasket.

D. Separator (if provided).

E. Defrost water drain plug.

F. Control panel.

G. Side motor cooling grille.

DIAGRAM OF THE CONTROL PANEL (Fig. 2)

1. Red light: when flashing it indicates an alarm condition

and the buzzer is also activated (see the section

"TROUBLESHOOTING GUIDE"). To deactivate the

audible alarm press the button (4).

Note: When the product is switched on the first time the

audible alarm is not activated.

2. Blue light: when lit, indicates that the

"Green

Intelligence"

function is active (see paragraph

"Green

Intelligence"

function).

3. Green lights: indicate that the product is running and

the temperature has been set.

4. Set temperature button: to adjust the set

temperature and to activate/deactivate fast freeze

procedures.

BEFORE USING THE APPLIANCE

Your new appliance is designed to be used in the

household and similar applications such as:

- kitchen areas in shops, offices and other working

environments

- farm houses

- by clients in hotels, motels, residences, bed &

breakfasts.

The product must only be used to store frozen food, to

freeze fresh food and to make ice.

Regulations require the appliance to be earthed.

The manufacturer declines all liability for injury to

persons or animals and for damage to property

resulting from failure to observe the above

procedures and reminders.

1. After unpacking, make sure that the appliance is

undamaged and that the door closes perfectly, with the

gasket remaining intact. Any damage must be reported

to your retailer within 24 hours after delivery of the

appliance.

2. Wait at least two hours before switching the appliance

on in order to ensure the refrigerant circuit is fully

efficient.

3. Installation and electrical connection must be carried

out by a qualified technician, according to the

manufacturer's instructions and local safety regulations.

4. Clean the inside of the appliance before using it.

• Before connecting the appliance to the mains supply,

ensure that the voltage corresponds to that given on

the rating plate located on the rear of the appliance.

• Electrical connections must be made in

accordance with local regulations.

INSTALLATION

• Unpack the appliance.

• Remove the 4 spacers inserted between the door

and the appliance. (Fig 3)

•Make sure the defrost water drain plug (if provided) is

correctly positioned (E).

• For optimum operation and to avoid damage when the

lid is opened, maintain a distance of at least 7 cm from

the front wall and 7 cm at the sides. (Fig 4)

• Fit the accessories (if provided).

SWITCHING ON THE APPLIANCE

•Plug in the appliance.

• The green LED lights up (

"Optimum"

• The blu LED lights up (

"Green Intelligence"

• The red LED flashes to indicate that the temperature

inside the appliance is not yet sufficiently low for food

storage. The red LED will normally switch off within

the first six hours after the appliance is switched on.

• Place food inside the product only when the red LED

has switched off.

• The blue LED,

"Green Intelligence"

(2), stays on until

the set temperature is reached.

Note: Thanks to the efficient lid seal, the appliance lid will

not re-open easily immediately after closing. Wait a few

minutes before re-opening the lid of the appliance.

TEMPERATURE ADJUSTMENT

Use the key (4) to select the desired temperature.

To adjust the internal temperature, proceed as follows:

• Repeatedly press the key (4). Each time the key is

pressed, the set temperature is updated, displaying the

"Optimum"

"Min"

and

"Max"

values in succession.

• Select

"Max"

for a colder storage temperature.

• With partial loads

"Min"

is recommended: this setting

will optimize energy consumption.

Note: The settings will be saved in the memory even if a

power cut occurs. The time needed for the temperature

inside the freezer to reach the set value, can vary

depending on climatic conditions and the set temperature

itself.

"GREEN INTELLIGENCE"

FUNCTION

This function will activate automatically in the following

cases:

• door opening

This function activates every time the opening of the

door changes the internal temperature of the appliance.

The function remains active for the time needed to

reinstate optimum operating conditions.

• storing food inside the freezer

This function activates every time significant quantities

of food are introduced. It remains active for the time

needed to reinstate optimum freezing conditions of the

food introduced, ensuring the best compromise

between the quality of the freezing process and energy

consumption.

Note: The duration of the

"Green Intelligence"

function is

set automatically, and may vary depending on the way the

product is used.

Produkt Specifikationer

Mærke:	Bauknecht
Kategori:	Fryser
Model:	GTE 822 A+++
Bredde:	1180 mm
Dybde:	698 mm
Højde:	916 mm
Vægt:	45100 g
Produktfarve:	Hvid
Produkttype:	Kiste
Strøm:	16 A
Ledningslængde:	2.45 m
Pakkevægt:	46500 g
Pakkedybde:	766 mm
Pakkebredde:	1212 mm
Pakkehøjde:	962 mm
Energieffektivitetsklasse (gammel):	A+++
Årligt energiforbrug:	120 kWh
Placering af apparat:	Fritstående
Indikatorlampe:	Ja
Indvendig belysning:	Ja
Dørhængsel:	Op
Tilsluttet belastning:	100 W
Støjniveau:	42 dB
Justerbare fødder:	Ingen
Fryser, netto rumindhold:	215 L
Fryser, brutto rumindhold:	220 L
Frysekapacitet:	20 kg/24t
Opbevaringstid under strømafbrydelse:	60 t
Klimaklasse:	SN-T
Frostfri system:	Ingen
Stjernebedømmelse:	4*
Automatisk afrimning (fryser):	Ingen
Hurtig frys funktion:	Ja
Fryser antal hylder/kurve:	2
Temperaturalarm:	Ja
Låsning:	Ja
Afrimning vandafløb:	Ja
Antal isposer:	1