Bauknecht WA Sense xl 24 sd Manual

Bauknecht Vaskemaskine WA Sense xl 24 sd

Læs gratis den danske manual til Bauknecht WA Sense xl 24 sd (14 sider) i kategorien Vaskemaskine. Denne vejledning er vurderet som hjælpsom af 57 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 29 anmeldelser. Har du et spørgsmål om Bauknecht WA Sense xl 24 sd, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/14
CONTENTS
DEFINITION OF USE
BEFORE USING THE WASHING MACHINE
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
DOOR
CHILD SAFETY
BEFORE THE FIRST WASH CYCLE
PREPARATION OF THE WASHING
DETERGENTS AND ADDITIVES
REMOVING THE FILTER/DRAINING
RESIDUAL WATER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
ACCESSORIES
TRANSPORT/HANDLING
ELECTRICAL CONNECTION
GB 2
DEFINITION OF USE
This washing machine is exclusively destined to
wash machine washable laundry in quantities which
are usual for private households.
•Observe the instructions given in these
Instructions for Use and the Programme Chart
when using the washing machine.
•Keep these Instructions for Use and the
Programme Chart; if you pass on the washing
machine to another person, also give him/her
Instructions for Use and Programme Chart.
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and inspection
•After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer.
•Check that the accessories and supplied parts are
all present.
•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
•If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2.Remove the transport bolts
•The washing machine is fitted with transport
bolts to avoid any possible damage to the interior
during transport. Before using the machine, it is
imperative that the transport bolts are removed.
•After their removal, cover the openings with the
4 enclosed plastic caps.
3.Install the washing machine
•Remove the protective film from the control panel
(if available on your model).
•Move the appliance without lifting it by the worktop.
•Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•Make sure that all four feet are stable and resting
on the floor and then check that the washing
machine is perfectly level (use a spirit level).
•In case of wooden or so-called “floating floors”
(for instance certain parquet or laminate floors),
place the appliance on a 60 x 60 cm sheet of
plywood at least 3 cm in thickness which is
secured to the floor.
4.Water inlet
•Connect the water supply inlet hose in
accordance with the regulations of your local
water company.
• Water inlet: Cold water only
(if no other information on
your programme chart)
• Water tap: 3/4” threaded hose
connector
•Water pressure
(flow pressure): 100-1000 kPa (1-10 bar).
•Use only new hoses to connect the washing
machine to the water supply. Used hoses must
not be used and should be discarded.
5.Drain
•Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the “U” bend
supplied.
•If the washing machine is connected to an
integrated drainage system, ensure the latter is
equipped with a vent to avoid simultaneous
loading and draining of water (siphoning effect).
6.Electrical connection
•Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and current standard
safety regulations.
•Data regarding voltage, power consumption and
protection requirements is given on the inside of
the door.
•The appliance must be connected to the mains by
means of a socket with an earth connection in
accordance with current regulations. The
washing machine must be earthed by law. The
manufacturer declines all liability for damage to
property or injury to persons or animals due to
non-compliance with the directions given above.
•Do not use extension leads or multiple sockets.
•Before any maintenance on the washing machine
disconnect it from the mains supply.
•After installation, access to the mains plug or to
disconnection from mains supply must be
ensured at all times via a double-pole switch.
•Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
•Mains cable replacement is only to be carried out
by After-Sales Service.
•The appliance must only be used in the
household for the prescribed uses.
Minimum housing dimensions:
Width: 600 mm
Height: 850 mm
Depth: 600 mm

Produkt Specifikationer

Mærke: Bauknecht
Kategori: Vaskemaskine
Model: WA Sense xl 24 sd

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht WA Sense xl 24 sd stil et spørgsmål nedenfor, og andre brugere vil svare dig


Vaskemaskine Bauknecht Manualer

Bauknecht

Bauknecht WM BK 10A CH A Manual

15 Juli 2025
Bauknecht

Bauknecht Super Eco 845 A Manual

11 Juli 2025
Bauknecht

Bauknecht WM Class 8AA Manual

5 Juli 2025
Bauknecht

Bauknecht WAT 619 C EX Manual

4 Juli 2025
Bauknecht

Bauknecht WT AO 86 43 N Manual

4 Juli 2025
Bauknecht

Bauknecht WTL 56313 C Manual

30 Juni 2025
Bauknecht

Bauknecht BW 719 Manual

30 Juni 2025
Bauknecht

Bauknecht WAT Zen 6B Manual

29 Juni 2025
Bauknecht

Bauknecht WAT 6313 C Manual

28 Juni 2025
Bauknecht

Bauknecht WMT Eco Smart 6513 Z C Manual

28 Juni 2025

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer

AEG

AEG LWR954P16H Manual

30 Juli 2025
Wascomat

Wascomat EXSM665cl Manual

29 Juli 2025
Wascomat

Wascomat H7-75 Manual

29 Juli 2025
Wascomat

Wascomat W 124 Manual

29 Juli 2025
Wascomat

Wascomat H7-1100 Manual

29 Juli 2025
Wascomat

Wascomat SU675cl Manual

29 Juli 2025
Wascomat

Wascomat H7–130 Manual

29 Juli 2025
Wascomat

Wascomat W 244 Manual

29 Juli 2025
Wascomat

Wascomat H7-180 Manual

29 Juli 2025
Wascomat

Wascomat Super Junior W 105 Manual

29 Juli 2025