Bauknecht WATS 5550 Manual

Bauknecht Vaskemaskine WATS 5550

Læs gratis den danske manual til Bauknecht WATS 5550 (17 sider) i kategorien Vaskemaskine. Denne vejledning er vurderet som hjælpsom af 50 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 25.5 anmeldelser. Har du et spørgsmål om Bauknecht WATS 5550, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/17

Contents

Before Using the Washing Machine

First Wash Cycle

Precautions and General

Recommendations

Description of the Washing Machine

Preparation of the Washing

Detergents and Additives

Programme Selection

Cleaning the Foreign Body Trap

Draining Residual Water

Care and Maintenance

Troubleshooting Guide

After-Sales Service

Transport and Handling

Installation

Before Using the Washing Machine

1.Remove the packaging

and check

a. Cut and remove the shrink-

wrap.

b.Remove the top protection

and the protective corners.

c. Remove the bottom protection

by tilting and turning the

appliance on one rear bottom

corner.

d.Open the lid by pressing it

slightly down while raising the

handle. Remove the

polystyrene cushion.

e. Remove the blue protective

film from the panel

(depending on model).

•After unpacking, make sure

that the washing machine is

undamaged. If in doubt, do

not use the washing machine.

Contact After-Sales Service or

your local retailer.

•Keep the packaging materials

(plastic bags, polystyrene

parts, etc.) out of reach of

children; they are potentially

dangerous.

2.Remove the transport

bracket

•The appliance is fitted with

transport screws and a

transport bracket to prevent

damage during transport.

Before using the washing

machine you must remove

the transport bracket

(see “Installation/Remove the

transport bracket”).

3.Install the washing

machine

•Place the appliance on a flat

and stable ﬂoor surface.

• Adjust the feet to ensure

that the machine is stable

and level (see “Installation/

Adjust the feet”).

4.Water supply

•Connect the water supply inlet

hose in accordance with the

regulations of your local water

company (see “Installation/

Connect the water inlet

hose”).

5.Drain hose

•Connect the drain hose to the

siphon or hook it over the

edge of a sink with the “U”

bend (see “Installation/

Connect the water drain

hose”).

•If the washing machine is

connected to a built-in

drainage system, ensure the

latter is equipped with a vent

to avoid simultaneous loading

and draining of water

(siphoning effect).

•Fixed drainage stand pipe.

The internal diameter of the

drain pipe should be 3 cm

minimum. To avoid a syphon

effect, the end of the drain

hose should be 55 cm min.

from the floor.

6.Electrical connection

•Electrical connections must be

carried out by a qualified

technician in compliance with

the manufacturer’s

instructions and the current

standard safety regulations.

•The technical data (voltage,

power and fuses) are given on

the rating plate on the rear of

the appliance.

•The appliance must be

connected exclusively by

means of a socket with an

earth connection in

accordance with current

regulations. The appliance

must be earthed by law. The

manufacturer declines all

liability for damage to persons

or property deriving directly or

indirectly from failure to

observe the directions.

•Do not use extension leads or

multi sockets.

•Before any maintenance on the

washing machine disconnect it

from the mains supply.

•Access to the mains plug or to

disconnection from the mains

supply via a double-pole switch

must be ensured at all times

following the installation.

•Do not operate the washing

machine if it has been

damaged during transport.

Inform the After-Sales Service.

•Mains cable replacement is

only to be carried out by After-

Sales Service.

•The appliance must be

connected to an effective

earthing installation, in

compliance with the regulations

in force. In particular, appliances

installed in premises containing a

shower or a bath must be

protected by a differential

residual current device of at least

30 mA. Earthing the appliance is

obligatory under the law. The

manufacturer declines all liability

for damage to persons or

property deriving either directly

or indirectly from failure to

observe the directions above.

•The washing machine may only

be used in the household for

the prescribed uses.

Dimensions:

Width: 400 mm

Height: 900 mm

Depth: 600 mm

•Water

supply:Cold water only

•Tap: 3/4” threaded

hose connection

•Pressure: 100-1000 kPa

(1-10 bar).

Produkt Specifikationer

Mærke:	Bauknecht
Kategori:	Vaskemaskine
Model:	WATS 5550

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht WATS 5550 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vaskemaskine Bauknecht Manualer

Bauknecht WM BK 10A CH A Manual

15 Juli 2025

Bauknecht Super Eco 845 A Manual

11 Juli 2025

Bauknecht WM Class 8AA Manual

5 Juli 2025

Bauknecht WAT 619 C EX Manual

4 Juli 2025

Bauknecht WT AO 86 43 N Manual

4 Juli 2025

Bauknecht WTL 56313 C Manual

30 Juni 2025

Bauknecht BW 719 Manual

30 Juni 2025

Bauknecht WAT Zen 6B Manual

29 Juni 2025

Bauknecht WAT 6313 C Manual

28 Juni 2025

Bauknecht WMT Eco Smart 6513 Z C Manual

28 Juni 2025

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer

AEG LR7H116BY Manual

31 Juli 2025

AEG LR76XXL Manual

31 Juli 2025

AEG LX6WG74634BI Manual

31 Juli 2025

AEG LR734L94G Manual

31 Juli 2025

Infiniton WM-9ASD Manual

31 Juli 2025

AEG LTR6E60269 Manual

31 Juli 2025

AEG LF2428PBG Manual

31 Juli 2025

Infiniton WM-D82DKE Manual

31 Juli 2025

Koenic KWM 9152 B INV Manual

31 Juli 2025

AEG LTR7A70260 Manual

31 Juli 2025