Baumatic BT98SS Manual


Læs gratis den danske manual til Baumatic BT98SS (28 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Baumatic BT98SS, eller vil du spørge andre brugere om produktet?

Side 1/28
i
BT98SS
Cooker Hood
User Manual for your Baumatic
BT98SS
Cooker Hood
43cm Cooker Hood in Stainless Steel
NOTE: This User Instruction Manual contains important
information, including safety & installation points, which will
enable you to get the most out of your appliance. Please keep it
in a safe place so that it is easily available for future reference; for
you or any person not familiar with the operation of the appliance.
DD 20/06/07
2
3
Contents
Environmental note 4
Important safety information 5 – 7
Specifications of your cooker hood 8
Using your Baumatic cooker hood 9
Special functions 10
Grease filters cleaning required warning 10
Carbon filters replacement warning 10
Cleaning and maintenance of your Baumatic 11
cooker hood
The grease filter 11
Removing and cleaning the grease filter 12
Changing a light bulb 13
Fitting the carbon filter 14
Installation 15
Electrical connection 15 – 16
Before beginning installation 16 – 17
Installing your cooker hood 17 – 20
Connecting to external ducting 21
Fitting the chimney section 22 – 23
Extraction mode or recirculation mode? 24
Troubleshooting 25
Baumatic Ltd. conditions of guarantee 26
Contact details 27
ENVIRONMENTAL NOTE
Note: Before discarding an old appliance, switch off and
disconnect it from the power supply. Cut off and render any
plug useless. Cut the cable off directly behind the appliance to
prevent misuse. This should be undertaken by a competent
person.
CONFORMITY TO W.E.E.E. DIRECTIVE
4
IMPORTANT SAFETY INFORMATION
Your safety is of the utmost importance to Baumatic.
Please make sure that you read this instruction booklet
before attempting to install or use the appliance. If
you are unsure of any of information contained in this
booklet, please contact the Baumatic Technical
Department.
IMPORTANT: Any installation work must be
carried out by a qualified electrician or
competent person.
o The hood must be installed in accordance with the installation
instructions and all measurements followed.
o If the cooker hood is installed for use above a gas appliance then
the provision for ventilation must be in accordance with the Gas
Safety Codes of Practice BS.6172, BS.5440 & BS.6891 (Natural
Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation &
Use) Regulations, the Building Regulations issued by the
Department of the Environment, the Building Standards
(Scotland) (Consolidated) Regulations issued by the Scottish
Development Department.
o It is dangerous to alter the specifications or to modify this
product in any way. Do not tamper with it or attempt to modify
the appliance in any way.
o When installing the hood, ensure that the following
recommended distances are observed between the highest point
on the hob top (including the burners) and the bottom of the
cooker hood:
¾ Electric cookers: 700 mm
¾ Gas cookers: 700 mm
¾ Coal/ oil cookers: 800 mm
IMPORTANT: DO NOT SET YOUR COOKER HOOD LESS
THAN 700mm ABOVE YOUR COOKER.
o When installed between adjoining wall cabinets, the cabinets
must not overhang the hob.
5
o The edges of the cooker hood are sharp – be mindful of this as
you handle your appliance, especially during installation and
cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS!
o If the room where the cooker hood is to be used contains a fuel
burning appliance such as a central heating boiler then its flue
must be of the sealed or balanced flue type.
o If other types of flue or appliances are fitted, ensure that there is
an adequate supply of air in the room.
o When the hood is being used in its extractor function, ensure
that the ducting is fire retardant and that there are no bends
sharper than 90 degrees as this will reduce the efficiency of the
hood.
o Ensure the ducting for the extractor function has the same
diameter as the outlet hole all the way through.
o Keep young children from using, playing with
or tampering with the cooker hood. Older
children and infirm persons should be
supervised if they are using the cooker hood.
o Your cooker hood is for domestic use only.
o Please dispose of the packing material carefully – children are
especially vulnerable to it.
o Dirty oil is an even greater fire risk.
o Always put lids on pots and pans when cooking
on a gas cooker.
o The manufacturer refuses to accept any responsibility for
damages arising to the hood or it catching on fire from failure to
observe fire safety advice in these instructions.
6
o Remember that when in extraction mode, your cooker hood is
removing air from your room. Ensure that proper ventilation
measures are being observed. Note that it removes odours
from your room, not steam.
o Warning - Always ensure that the cooker
hood has been disconnected from the
power supply before carrying out any work
on the hood, including replacing light bulbs.
o Do not connect the ducting system of this appliance to any
existing ventilation system which is being used for any other
purpose.
o Do not install above a cooker with a high level grill.
o Never leave frying pans unattended during use
as overheated fats and oils might catch fire.
o Do not leave naked flames under the cooker hood.
o Do not attempt to use the cooker hood if it is damaged in any
way. Never attempt to use it without the grease filters fitted or
if the filters are excessively greasy!
o Never flambé cook under this cooker hood.
THE MANUFACTURER DECLINES ALL
RESPONSIBILITY IN THE EVENT OF FAILURE TO
OBSERVE THE INSTRUCTIONS GIVEN HERE, FOR
INSTALLATION, MAINTENANCE AND SUITABLE
USE OF THE HOOD.
7
8
Specifications of your cooker hood
Congratulations on purchasing a Baumatic Cooker
Hood!
DIMENSIONS:
Width (canopy): 430 mm
Depth (canopy): 430 mm
Height (with chimney) 710 mm – 1100 mm
DIMENSIONS OF CHIMNEY SECTION:
430 mm x 430 mm
Your stainless steel Cooker Hood is fitted with:
o Superior extraction tangential motor
o Touch control operation
o 5 Speeds and booster
o 1 Metallic grease filters
o 2 halogen lights
Extraction capacity: 750 m³/hr
Noise level min/max: 49 – 62 dB
Optional Extra: 1 x SCF11 carbon filter for air
recirculation mode (available from
the Baumatic Spares Department).
Using your Baumatic cooker hood
IMPORTANT: THE ELECTRONIC CONTROLS ON YOUR
OOKER HOOD HAVE MULTIPLE FUNCTIONS.
tart and Increase Speed (6 speeds)
The hood
utomatically sets itself to speed Level 1 when activated.
tton 1 for less than one second; the
isplay indicates the speed level.
utton 1 pressed longer than one second top speed is
elected.
otor stopping and decreasing speed
2 for less
an one second; the display indicates the speed level.
eeping button 1 pressed longer than one second turns the hood off.
imer Function
s after
ou have activated this function. To program: press button 3.
tion is activated you will see the number displayed
ulsing on and off.
ight on-off function
n and off by pressing button 4.
C
S
The Cooker hood motor is turned on by pressing button 1.
a
Speed is increased by pressing bu
d
Keeping b
s
M
The fan operating speed is decreased by pressing button
th
K
T
This function allows you to program the cooker hood’s motor and lights
in order to have them automatically switched off fifteen minute
y
When the timer func
p
L
The light is turned o
9
11
leaning your Baumatic cooker hood C
IMPORTANT: BEFORE CLEANING, ALWAYS
ENSURE THAT YOU HAVE SWITCHED YOUR
COOKER HOOD OFF AT THE OMNI-POLAR
SWITCH, SET AT THE WALL FROM THE CABLE.
le n
oker hood with mild liquid
o ase filter grill with mild liquid
o
carbon filter”). A build up of grease
o Never attempt to clean the area above the grease filters.
he grease filter
C a ing
Clean the external parts of your coo
detergent and a new damp cloth.
o Never use abrasive powder, corrosive solvents or brushes.
o Never insert pointed objects into the motor’s protective grid.
Only clean the control panel and gre
detergents and a new damp cloth.
If you are using the appliance in recirculation mode, then be
sure to replace the carbon filter at the recommended interval
(see section on “Fitting the
could cause a fire hazard.
T
o
ticles to protect your kitchen & furniture from greasy
o mmable if it becomes
o .
t
month, using hot water and normal washing-up
o DO NOT WASH THE GREASE FILTER IN A DISHWASHER.
Your cooker hood includes a grease filter which helps to absorb
grease par
residues.
This metallic filter may become infla
saturated with this greasy residue.
To prevent this fire hazard, the filter should be cleaned regularly
Depending on use, this should be done every 10-15 days or a
least once a
detergent.
Maintenance
Removing and cleaning the grease filter
o Undo the side catches.
Soak the grease filter in hot water and washing up liquid for
se filters dry thoroughly before
refitting them in the cooker hood.
o First remove the grease filter by
pulling down on it.
o
about an hour.
o Rinse them off thoroughly with hot water.
o Repeat the process if required.
12
o Refit the grease filters once they have dried.
o IMPORTANT: Let the grea
13
TING TO CHANGE
A LIGHT BULB, YOU MUST ENSURE THAT YOU
HAVE DISCONNECTED THE COOKER HOOD FROM
NS S P
o Remove the grease filters (as
described on page 11).
o n.
o Find the bulb that r ement, you will find it located in
the light fi on of the
canopy.
new G4 20W (max) bulb.
o iately.
If the lights still do not work, make sure that the lamps are fitted
before you call for technical
o Refit the grease filters.
Changing a light bulb
IMPORTANT: BEFORE ATTEMP
U PLY. YOUR MAI
Prior to touching the light bulbs ensure they are cooled dow
equires replac
xture which is inside the exposed secti
o Unscrew the light bulb that needs to be replaced and insert a
IMPORTANT: Defective bulbs should be replaced immed
o
properly into their housings
assistance.
16
ou will only find two wires in the main’s lead (blue and
br
o mains lead may not
spond with the coloured markings identifying the terminals
ox, p a
o e wire must be connected to the
terminal marked “N” (neutral), or coloured
o The brown wire must be connected to the
terminal marked “L” (live), or coloured red.
Be r
o
If the product is going to be used in extraction mode,
then there should also be space to connect a ducting hose to the
o Carry out all necessary masonry work prior to the fitting of the
o Ensure that all electrical connections are carried out by a suitably
o Before commencing installation of the cooker hood the grease
o
ging or any other materials, such as packets of screws,
guarantees etc. These should be removed and kept for future
o
ering
should be placed over the worktop, hob top or cooker. This will
o assembling the cooker hood. Cover that
surface with a protective covering and place all cooker hood
Y
own), neither must be connected to the earth terminal.
As the colours of the wires in the appliance’s
corre
in your spur b le se proceed as follows:
The blu
black.
fo e beginning installation
Check that the product purchased is of a suitable size for the
chosen installation area. In addition check whether there is an
electrical socket available that will be accessible once the hood is
mounted.
outside.
cooker hood.
qualified person.
filter should be removed.
Check inside the product and insure that there is no transit
packa
use.
If possible, disconnect and move freestanding or slot-in cookers
from their position, to provide easier access to the rear wall and
ceiling. If this is not possible, then a thick, protective cov
help to protect these surfaces from damage and debris.
Select a flat surface for
parts and fittings on it.
17
o
essible after the hood is mounted. If you are
going to use the appliance in extractor mode, you should also
ce
o
er a qualified technician must verify the
suitability of the materials, in accordance with the type of wall
ke
o Do not tile, grout or silicone this appliance to the wall. This
e surface mounted only.
y
EFORE
E
ION MODE OR RECIRCULATION
MODE. PLEASE TURN TO PAGE 24 NOW TO
o ker hood should not be exposed to a direct heat source
from the cooking device underneath it, i.e. naked flame from a
n
them.
o
o The lights on this appliance should only be used during operation
of the cooker hood. They should not be left on permanently and
MPORTANT: YOUR COOKER HOOD SHOULD BE CONNECTED TO
In addition check whether there is an electrical socket available,
which will be acc
ensure that there is space to connect a fumes discharge devi
to the outside.
Raw plugs are provided to secure the hood to most types of
walls and ceilings. Howev
and ceiling. The wall and ceiling must be strong enough to ta
the weight of the hood.
appliance is designed to b
our cooker hood
IMPORTANT: YOU WILL HAVE TO DECIDE B
INSTALLING YOUR COOKER HOOD WHETHER TO US
IT IN EXTRACT
Installing
UNDERSTAND THE DIFFERENCES BETWEEN THESE
TWO MODES.
The coo
gas burner or heat from electric hob zones without a pan o
We recommend that at least two people install this hood.
used as a lighting source.
I
YOUR MAINS SUPPLY AFTER THE REST OF THE INSTALLATION
PROCESS HAS BEEN COMPLETED.
1) Remove the metal grease filters.


Produkt Specifikationer

Mærke: Baumatic
Kategori: Emhætte
Model: BT98SS

Har du brug for hjælp?

Hvis du har brug for hjælp til Baumatic BT98SS stil et spørgsmål nedenfor, og andre brugere vil svare dig




Emhætte Baumatic Manualer

Baumatic

Baumatic BT82.1GL Manual

14 Januar 2025
Baumatic

Baumatic PI1 Manual

14 Januar 2025
Baumatic

Baumatic BECH90GL/1 Manual

31 December 2025
Baumatic

Baumatic STD61SSB Manual

2 Oktober 2024
Baumatic

Baumatic GEH6018 Manual

24 September 2024
Baumatic

Baumatic F110.2SS Manual

21 September 2024
Baumatic

Baumatic BE939SS Manual

17 September 2024
Baumatic

Baumatic TG3 Manual

17 September 2024
Baumatic

Baumatic ISL92.1SS Manual

16 September 2024
Baumatic

Baumatic BU976GL Manual

12 September 2024

Emhætte Manualer

Nyeste Emhætte Manualer