Black Box LE180A Manual


Læs gratis den danske manual til Black Box LE180A (7 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Black Box LE180A, eller vil du spørge andre brugere om produktet?

Side 1/7
LE180A 10Base-T Transceiver
Stand-Alone model
Attached Unit Interface (AUI) to
Ethernet RJ-45 connectors
No external power requirement
NETWORK SERVICES
General Description . . . . . . .2
Connectors & Cables . . . . . . .3
Installation . . . . . . . . . . . . . .6
Operations . . . . . . . . . . . . . .8
Technical Specifications . . . .9
Cable Specifications . . . . . .10
Troubleshooting . . . . . . . . .10
Contact Us . . . . . . . . . . . . .11
The LE180A transceiver is a media access unit
(MAU) that connects the AUI port of data
terminal equipment, repeaters, or other
network devices either directly or through an
AUI cable to an Ethernet 10BASE-T device. The Ethernet device is connected to the
transceiver through an unshielded or shielded twisted-pair copper cable with RJ-45
connector ends.
Workstation
Black Box
Transceiver
Black Box
Transceiver
Workstation
10-Base-T Hub
Black Box
Transceiver
HUB with AUI Port
Or
Or
Various System Configurations
Figure 1 shows various examples of transceiver system configurations.
Figure 1: Transceiver System Configurations
LE180A
2Black Box Network Services, 724-746-550, www.blackbox.com
General Description
The LE180A IEEE802.3 compliant Ethernet transceiver uses 10Mbps Ethernet
CSMA/CD protocol to provide a connection interface to 10Base-T Ethernet unshielded
twisted-pair (UTP) cables. The transceiver connects to the AUI connector of an
Ethernet device via standard AUI cable.
Figure 2: shows the front and rear panels of the LE180A transceiver.
Figure 2: LE180A Transceiver Front and Rear Panels
Dimensions
Figure 3 shows the LE180A dimensions.
Figure 3: LE180A Dimensions
3-Positio
n
Switch
AUI Connector
Rear
RJ-45 Connector
Front
4 LEDs
3.141
1.757"
0.812"
Black Box Network Services, 724-746-550, www.blackbox.com 3
!
!
LE180A
LE180A Features
Provides a complete interface of the AUI to Ethernet UTP cable.
Supports 10Mbps data transfer rates.
Supports Carrier Sense Multiple Access/Collision Detection contention(CSMA/CD)
protocol.
Drives UTP cable segments up to 100 meters (328ft).
Supports selectable link and SQE test functions.
Supports direct connections to host AUI ports.
Detects and corrects reverse polarity on the receiving pair of UTP cables.
Provides four LEDs: Transmit (TX), Receive (RX), Collision, and Status.
Connectors and Cables
LE180A AUI male connector
AUI D-sub 15-pin male connector accommodates AUI drop cables .(50 meters max.)
The AUI connector is used to connect the transceiver to the AUI port of an Ethernet
device such as an Ethernet MAC controller, a repeater, or a hub via an AUI drop cable.
The AUI connector is shown in Figure 4. The AUI male connector pin assignments are
show in Table 1.
Figure 4: LE180A AUI Male Connector Pin Assignments
D-Sub 15-pin Male AUI Connector
18
915


Produkt Specifikationer

Mærke: Black Box
Kategori: Ikke kategoriseret
Model: LE180A

Har du brug for hjælp?

Hvis du har brug for hjælp til Black Box LE180A stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Black Box Manualer

Black Box

Black Box SW1040A Manual

13 December 2024
Black Box

Black Box LB621C Manual

10 Oktober 2024
Black Box

Black Box PG-VGA Manual

13 September 2024
Black Box

Black Box EMD100USB Manual

2 September 2024
Black Box

Black Box KV9702A Manual

1 September 2024
Black Box

Black Box SW1041A Manual

1 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer