PART# BMX-2027
~
llll~i~llJ~I
J
lllJ~l
l
ll
ll
B
Hien
aunt-®
Innovative
Mounting
Solutions
ESCORr
PASSPORT
MAX
LEFT HAND DRIVE VEHICLE
Your rear
view
mirror
has
minimal
clearance between the
back
side
of
the
mirror
and
the
mirror
stem
.
It
is
very
important
that
this
mount
is
installed
correctly
to
ensure
mirror
adjustability
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
BOTTOM OF SPRING CLIP
IS
PARALLEL WITH RD
The RELEASE Button on the radar detector (RD) is NOT used with this mount.
To
release the tension
of
the spring clip, simply squeeze the TRIGGER and the back side of the
mount together. This will lower the bottom portion
of
the spring clip allowing you to slide the
RD on and off. When used properly, the spring clip avoids putting excessive pressure on the
mirror stem when installing and removing the
RD.
The top portion of
me
mount
should
barely move when the two opposing forces are applied. The bottom of the spring clip
must be parallel with the top
of
the RD to slide
in
and
out.
SLIDE THE RD ONTO THE
SPRING CLIP AS FAR AS IT
WILL
GO
. Release the trigger to secure the RD onto the
mount. Before installing the mount onto your rear view mirror, remove and install the RD a
few times so you can observe how the spring clip functions.
With the
RD
adjusted right below the mirror as recom-
mended, you will probably not be able to get your fin-
gers between the RD and mirror to access the buttons.
The
spring
clip
allows
you
to
push
the
front
of
the
RD downward with one finger and press the but-
tons with another finger as shown above.
PPROXIMATELY 1/8" BETWE
ACK
OF
MIRROR AND MOUN
STEP 1 • Loosen the clamp screw so the top section separates
from the mid section. This will provide the necessary clearance to
slide the mount over the mirror stem as shown above.
STEP 2 - Tighten the clamp screw until the Top and Mid Sections are
slightly
snug
around the mirror stem. You should still be able to move the
mount along the stem. Before fully tightening the clamp screw, slide the mount
towards the windshield as far as It will go. There should be approximately 1/8"
between the back
of
the mirror and the mount as shown above.
Innovative Design
And
Precision Manufacturing
PAGE 1 OF 2
BlendMount - US PATENT# D625,580 S, D656,811
S,
D653,980 S
D690,245
S,
D690,246
S,
D690,247
Sand
other patents pending
