Blustream UEX100E-KIT Manual

Blustream Ikke kategoriseret UEX100E-KIT

Læs gratis den danske manual til Blustream UEX100E-KIT (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Blustream UEX100E-KIT, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
UEX100E-KIT QUICK REFERENCE GUIDE
Contact: support@blustream.com.au | support@blustream-us.com support@blustream.co.uk|
UEX100E-KIT
Quick Reference Guide
01
The UEX100E-KIT is a USB extender kit utilising HDBaseT™ technology to extend
USB 2.0, 2CH analogue audio and control signals up to 100m over a single CAT
cable. The UEX100E-KIT allows up to 4 USB devices to be connected to a single
USB host with support for a transmittion data bandwidth up to 480Mbps and is
backwards compatible with USB 1.1 devices. The UEX100E-KIT also provides bi-
directional Power over Cable (PoC), bi-directional IR and RS-232 and 2CH analogue
and Ethernet pass through.
Introduction
FEATURES:
• Extends USB up to a distance of 100m over a single CAT cable using HDBaseT™ Technology
• Supports USB 2.0 signal extension
• Backwards compatible with USB 1.1 devices
• Transmitted data bandwidth up to 480Mbps
• 1x USB-B on Transmitter for connection to host device
• 4x USB-A hub on Receiver for connection to devices
• USB-A ports 1-2 support 5V1A, USB-A ports 3-4 support 5V500mA
• Bi-directional Ethernet pass through (100Mbps)
• Bi-directional IR & RS-232 pass through
• Supports 2CH PCM Analogue Audio pass through (direction selectable)
• Bi-directional PoC (Power over Cable) to power extenders from either transmitter or receiverend
• Simple plug and play, no driver installation or setup required.
*Signal distribution length subject to length of device and host USB cables and CAT cable type
CONFIGUSB HOST RS-232
1
0
TX RX
24V 1.25AETHERNET HDBT IN IR IN IR OUT L/R
AUDIO
IN OUT
500mA CONFIG RS-2321A
1234
1
0
TX RX
24V 1.25AETHERNET HDBT OUT IR IN IR OUT L/R
AUDIO
IN OUT
UEX100E-KIT QUICK REFERENCE GUIDE
www.blustream.com.au | www.blustream-us.com | www.blustream.co.uk02
TX Panel Descriptions
1 Ethernet Port - RJ45 connector. Connect to local
network switch
2 HDBaseT™ Output - RJ45 connector
3 IR Input - Connect to Blustream 5V 3.5mm IR receiver
4 IR Output - Connect to Blustream 5V 3.5mm IR emitter
5 Analogue Audio L/R - 3.5mm stereo jack can be used
as input or output from UEX100E-RX
6 Analogue Audio In/Out Switch - Select if audio is sent
to or received from UEX100E-RX
7 24V DC 1.25A 4-pin power supply connector
8 LED Power Indicator
9 1A USB Device Connection - USB A connection to
connect to high current (up to 1A) USB devices*
q 500mA USB Device Connection - USB A connection to
connect to USB devices up to 500mA*
w Config DIP Switch - DIP 1 sets PoC on or o. DIP 2 sets
RS232 passthrough or update mode
e RS-232 Port - 3-Pin Phoenix connector to pass bi-
directional IR to / from the receiver
*Note: only one USB camera can be connected at a time
1 Ethernet Port - RJ45 connector. Connect to local
ethernet port of network device
2 HDBaseT™ Input - RJ45 connector
3 IR Input - Connect to Blustream 5V 3.5mm IR receiver
4 IR Output - Connect to Blustream 5V 3.5mm IR emitter
5 Analogue Audio L/R - 3.5mm stereo jack can be used
as input or output from UEX100E-RX
6 Analogue Audio In/Out Switch - Select if audio is sent
to or received from UEX100E-TX
7 24V DC 1.25A 4-pin power supply connector
8 LED Power Indicator
9 USB Host Connection - USB B connection to connect
to PC
q Config DIP Switch - DIP 1 sets PoC on or o. DIP 2 sets
RS232 passthrough or update mode
w RS-232 Port - 3-Pin Phoenix connector to pass bi-
directional IR to / from the receiver
4
RX Panel Descriptions
21 53
Device Cabling
It is important that the interconnecting CAT cable between the Transmitter and Receiver is terminated using the
correct RJ45 pin configuration. The CAT cable MUST be a ‘straight’ (pin-to-pin) CAT cable.
Please ensure that the USB cabling used with this product is within specifications for both the distance and maximum
/ expected data rate transfer of the equipment in use. Exceeding distances, or using cabling not suitable for the data
transfer, may stop the UEX100E-KIT from working properly.
It is recommended to keep the USB cabling either side of the UEX100E-KIT to a minimum, using the range of the
equipment to run the distance over the CAT cable infrastructure.
24V 1.25AETHERNET HDBT OUT IR IN IR OUT L/R
AUDIO
IN OUT
24V 1.25AETHERNET HDBT IN IR IN IR OUT L/R
AUDIO
IN OUT
500mA CONFIG RS-2321A
1234
1
0
TX RX
6 7 9 10 11 12
CONFIGUSB HOST RS-232
1
0
TX RX
421 53 6 7 9 10 11
8
8

Produkt Specifikationer

Mærke: Blustream
Kategori: Ikke kategoriseret
Model: UEX100E-KIT

Har du brug for hjælp?

Hvis du har brug for hjælp til Blustream UEX100E-KIT stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Blustream Manualer

Blustream

Blustream AD11AU Manual

11 Juli 2025
Blustream

Blustream DAC13DB Manual

26 Januar 2025
Blustream

Blustream MX44KVM Manual

26 Januar 2025
Blustream

Blustream DA11USB Manual

26 Januar 2025
Blustream

Blustream DA22XLR-WP-US Manual

2 September 2024
Blustream

Blustream UEX50B-KIT Manual

28 August 2024
Blustream

Blustream SC11HD-V2 Manual

28 August 2024
Blustream

Blustream UEX100E-KIT Manual

28 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Rowenta

Rowenta Adagio BV3101 Manual

12 August 2025
Klein Tools

Klein Tools VDV826-705 Manual

12 August 2025
Walrus Audio

Walrus Audio Canvas Clock Manual

12 August 2025
Rowenta

Rowenta Artik Ionic VU9020 Manual

12 August 2025
Slingshot

Slingshot S (2024) Manual

12 August 2025
Discover

Discover D713U Manual

12 August 2025
Tefal

Tefal Virtuo FV1712 Manual

12 August 2025
Mars Gaming

Mars Gaming MF-LINKFINITYKIT2R Manual

12 August 2025
Rowenta

Rowenta City Space Cyclonic RO2544 Manual

12 August 2025
Beverage-Air

Beverage-Air PRT2XTHC-1AS Manual

12 August 2025