Broan 110RDF Manual

Broan Ventilator 110RDF

Læs gratis den danske manual til Broan 110RDF (12 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Broan 110RDF, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

MODEL RDH

Page 1

For Use in 1, 2 or 3 Hour Rated Floor-Ceiling and

Roof-Ceiling Designs.

Horizontal Mount Only.

For use with the following Broan ventilation fan models:

• 80RDF, 110RDF, HD50RDF

The following components are included with this

accessory kit:

(1) Radiation Damper and Fan Housing Assembly

(1) Metal Duct Connector

(4) Support Angles

(1) Housing Mask

Identify the following ventilation fan (purchased

separately) components and discard:

• Plastic Fan Grille Assembly

• Plastic Duct Connector Assembly

ROUGH-IN KIT WITH

RADIATION DAMPER

READ AND SAVE THESE INSTRUCTIONS

METAL DUCT

CONNECTOR

HOUSING

SLIDE

CHANNEL

SUPPORT

ANGLE

RADIATION

DAMPER

ASSEMBLY

Assemble support angles and duct connector to ventilation fan

housing:

1. Snap metal duct connector onto housing. Make sure that tabs on

the duct connector lock into the slots on the housing. Damper flap

hinge should be positioned toward top of housing.

2. Slide channels can be adjusted up or down to accommodate

different ceiling thicknesses.

3. Insert (2) support angles into each slide channel.

MODEL RDH

Page 2

NON-COMBUSTIBLE

FLOOR / CEILING

INSTALLATION

1. Plan installation so that ceiling penetration is located

within ceiling tiles or panels without necessitating cuts

in any ceiling suspension main runners or cross tees.

Ifrequired, a maximum of one runner or cross tee

may be cut to accommodate desired damper location.

Cutends must be supported by a minimum 12 gauge

(3mm) steel, vertical hanger wire.

2. Mount fan/damper assembly to the deck or ceiling

structure above or adjacent to the assembly. If the

assembly is hung from the structure above, a minimum

12 gauge (3mm) steel, hanger wire must be used. There

must be a minimum of two wires on each of two opposite

sides. If the assembly is directly mounted to the adjacent

structure, use #8 (M4) sheet metal screws or 1/4”

(6mm) diameter bolts with nuts (hardware not provided)

to mechanically fasten it to the structure. Position fan/

damper assembly so that the inlet face of the radiation

damper is flush with the finished surface of the ceiling.

Ceiling opening must be no larger than the inlet opening

of the damper.

3. New Construction

A housing mask has been provided to keep construction

dust, drywall spray, paint, etc. from damaging the

radiation damper or blower assembly.

a) Bend up the small tab of the mask.

b) Tuck the opposite side of the mask under one of the

damper’s grille mounting ears and push mask up into

damper housing.

Remove mask before installing grille or operating fan.

4. Attach the metal grille over the inlet face of the radiation

damper using (2) #8-18 x 0.812” sheet metal screws

(provided).

CLASSIFIED

SEE DETAILS ON UL

CLASSIFICATION

MARKING ON

PRODUCT

FAN

GRILLE

WIRE

DAMPER

GRILLE

SCREW

CEILING

MOUNTING

BRACKET

Produkt Specifikationer

Mærke:	Broan
Kategori:	Ventilator
Model:	110RDF

Har du brug for hjælp?

Hvis du har brug for hjælp til Broan 110RDF stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ventilator Broan Manualer

Broan QTXEG110 Manual

7 August 2025

Broan ZB80L1 Manual

8 Juli 2025

Broan LP510R Manual

7 Juli 2025

Broan L500 Manual

7 Juli 2025

Broan Roomside AR80LWH Manual

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

Ventilator Manualer

Nyeste Ventilator Manualer

Grunkel MET-H16 Industrial Manual

14 September 2025

Grunkel SKYWIND-42BT Manual

13 September 2025

Grunkel TF-I45W Manual

13 September 2025

Create Air Mist Manual

13 September 2025

Antari AF-3X Manual

13 September 2025

MPM MWP-32 Manual

13 September 2025

Grunkel BreezeCraft FAN-165R Manual

13 September 2025

Be Cool BC18STTIDC Manual

11 September 2025

NuTone QTXN110HL Manual

10 September 2025

NuTone 744LEDNT Manual

10 September 2025