Broan L900L Manual

Broan Ventilator L900L

Læs gratis den danske manual til Broan L900L (12 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Broan L900L, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

MODELS • L900L • L1500L

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-

JURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the address

or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service

panel and lock the service disconnecting means to prevent

power from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten a promi-

nent warning device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a quali-

fied person(s) in accordance with all applicable codes and stan-

dards, including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment to

prevent backdrafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those

published by the National Fire Protection Association (NFPA),

and the American Society for Heating, Refrigeration and Air Con-

ditioning Engineers (ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not damage elec-

trical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. To reduce the risk of fire, use only metal ductwork.

8. If this unit is to be installed over a tub or shower, it must be

marked as appropriate for the application and be connected to a

GFCI (Ground Fault Interrupter) - protected branch circuit.

9. Never place a switch where it can be reached from a tub or

shower.

10. This unit must be grounded.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazard-

ous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

3. If ventilator is installed in an unconditioned space (such as

an attic): Surround the ventilator with thermal insulation - to

minimize possible condensation.

4. Please read specification label on product for further informa-

tion and requirements.

LOSONE SELECT

VENTILATORS

In-Line • 120V

READ AND SAVE THESE INSTRUCTIONS

TABLE OF CONTENTS

This manual is divided into sections as follows:

• “TYPICAL INSTALLATION”

This section shows a common installation in new and existing,

frame construction.

- Mounting (new construction)

- Mounting (existing construction)

- Wiring

- Ducting (straight-through blower discharge)

• “MOUNTING OPTIONS”

• “WIRING OPTIONS”

-Wiring Plate Position

• “DUCTING OPTIONS”

- Blower Discharge Positions

- Ducting (right-angle blower discharge)

• “USE AND CARE”

• “SERVICE PARTS”

• “WARRANTY”

Installer: Leave this manual with the homeowner.

Homeowner: Use and Care information on page 3.

Page 1

MODELS • L900L • L1500L

Page 2

TYPICAL INSTALLATION

MOUNTING

(New Frame Construction)

CEILING

JOIST

(24”

centers

shown)

12” ROUND

DUCT

(OUTLET)

ACCESS

PANEL

Factory-shipped unit installed in new construction.

MOUNTING

SCREWS

ACCESS

PANEL SCREW

Ventilator factory-shipped

in straight-through

discharge position.

MOUNTING

BRACKETS

MOUNTING

(Existing Frame Construction)

Factory-shipped unit installed in existing construction.

TYPICAL INSTALLATION

WIRING

PLATE

WHITE

BLACK

BLACK EDGE

OF HOUSING

120 VAC LINE IN

GROUND TO

WIRING PLATE

ACCESS

PANEL

SCREW

DUCTING

(Straight-through blower discharge)

Two ways to connect ductwork to a factory-shipped unit.

Ventilator can be wired from outside of housing.

Use UL approved connectors to wire per local codes.

ROOF CAP

12” ROUND

ELBOW

12”

ROUND

DUCT

WALL

CAP

IMPORTANT:

Remove shipping tape from damper

Remove the shipping tape from the damper flap and make sure

that damper flap opens and closes freely inside the ductwork. Use

duct tape to make ductwork connections secure and air-tight.

8” X 12”

12” ROUND

TRANSITIONS

8” X 12” TO 12” ROUND

TRANSITIONS

12” ROUND DUCT

(OUTLET)

FINISHED

CEILING

MATERIAL

Ventilator

factory-shipped

in straight-through

discharge position.

MOUNTING

BRACKETS

8” X 12” TO

12” ROUND

TRANSITIONS

CEILING

JOIST

(24” centers

shown)

ACCESS PANEL

12” ROUND

DUCT

(INTAKE)

12” ROUND

DUCT (INTAKE)

12”

ROUND

DUCT

GRILLE NUT

(Install into square

holes in housing)

GRILLE NUT

(Install into

square holes in

housing)

Produkt Specifikationer

Mærke:	Broan
Kategori:	Ventilator
Model:	L900L

Har du brug for hjælp?

Hvis du har brug for hjælp til Broan L900L stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ventilator Broan Manualer

Broan Roomside AR80LWH Manual

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

Ventilator Manualer

Nyeste Ventilator Manualer

DeepCool UF120 Manual

7 Juli 2025

Soler & Palau CBM Manual

7 Juli 2025

Ideal ID6501 Manual

7 Juli 2025

Soler & Palau CTB ECOWATT Manual

7 Juli 2025

Soler & Palau CRHB/T N ECOWATT Manual

7 Juli 2025

Soler & Palau ILHT Manual

7 Juli 2025

Soler & Palau ILHB-ILHT ECOWATT Manual

7 Juli 2025

Soler & Palau EC-N Manual

7 Juli 2025

PAX Levante 30 Manual

7 Juli 2025

Soler & Palau CVAB/T-ECOWATT Manual

7 Juli 2025