Byron BY202F Manual
Læs gratis den danske manual til Byron BY202F (4 sider) i kategorien Dørklokke. Denne vejledning er vurderet som hjælpsom af 60 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 30.5 anmeldelser. Har du et spørgsmål om Byron BY202F, eller vil du spørge andre brugere om produktet?
Side 1/4
Beep
31: plug Chime into a UK 3pin
socket, 220 – 240V ~ 50Hz.
2: Switch the socket on.
3: Chime will ‘Beep’ on Start
1: Push Button 5: Portable Chime
2: Melody Selector 6: Speaker
3: Bell Push Battery 7: Volume Control
4: Signal Sent LED 8: Strobe Alert
Strobe Alert:
Strobe Light will flashPress to switch the
Strobe Alert On or Off
Chime will ‘Beep’
3
™Plug-in Strobe Alert
Wire Free Chime Kit
BY202F
1:
2:
4:
:3
1: Place a small flat screwdriver
into the locking clip on the
base of the Bell Push
2: Gently twist
3: The backing plate will unclip
1
6:
7:
5:
:8
To select the Chime Volume level, press the ‘VOL’
button on the chime There are 4 selectable volume
levels, the Door Chime is pre-set to the loudest
volume setting.
Volume
Default
Functions:
6 Selectable Melodies
1: Tubular 3-Note 4: Solo
2: Big Ben 5: Tubular Score
3: Tubular 2-Note 6: Clarinet
To select a melody for the Door Chime
1: Remove the Back Plate from the Bell
Push.
2: Press the Melody Select button.
3:The chime will play the newly selected
sound.
4: Press again to select the next melody.
Note: For Front/Back door setup, select a
different melody in one of the Bell Pushes.
CR2032
4
Beep
Beep
1: Press and hold the ‘VOL’
button on the Door Chime,
until the Chime goes
‘Beep Beep’ (6 Seconds).
2: Press the Bell Push within
60 seconds to learn the
Bell Push to the chime.
3: The Chime will ring to
confirm setup.
Note: Maximum of 6 Bell
Pushes can be learnt to a
single Chime.
4
Additional Chime
To add an additional Chime unit to the Door Chime kit
1: Press and hold the ‘VOL’ button on your New Door Chime, until the
Chime goes ‘Beep Beep’ (6 Seconds)
2: Press the Bell Push within 60 seconds to learn the additional
Chime to the Bell Push.
3: Chime will ring to confirm setup, wait 60 seconds for the Chime to
exit the learn mode before repressing the bell push.
Additional Bell Push
To add an additional Bell Push to the Door
Chime kit.
1: Press and hold the ‘VOL’ button on your
Door Chime, until the Chime goes
‘Beep Beep’ (6 Seconds).
2: Press the Bell Push within 60 seconds
to learn the additional Bell Push to the
Chime.
3: Chime will ring to confirm setup, wait 60 seconds for the Chime
to exit the learn mode before repressing the bell push.
For Front/back door setup, select a different melody in one of
the Bell Pushes - .See Melody Selection
Note: Maximum of 6 Bell Pushes can be learnt to a single Chime
Adding Additional Chime/Bell Push:
Front Door
Back Door
New Chime
Beep
Beep
1: Insert CR2032 battery
(Supplied) into the battery
holder.
2: Make sure the positive side
is facing upwards.
3: Replace back plate.
2
Warning: Make sure that the batteries are
replaced correctly to avoid battery failure.
Only replace with same or equivalent type.
Produkt Specifikationer
| Mærke: | Byron |
| Kategori: | Dørklokke |
| Model: | BY202F |
Har du brug for hjælp?
Hvis du har brug for hjælp til Byron BY202F stil et spørgsmål nedenfor, og andre brugere vil svare dig
Dørklokke Byron Manualer
4 Oktober 2024
4 Oktober 2024
1 Oktober 2024
23 September 2024
23 September 2024
22 September 2024
22 September 2024
21 September 2024
10 September 2024
10 September 2024
Dørklokke Manualer
- Orbegozo
- Cata
- Franke
- EKO
- Techly
- Legrand
- EQ3
- Elektrobock
- Gira
- Bell4U
- Lorex
- Middle Atlantic
- Hama
- KlikaanKlikuit
- Viking
Nyeste Dørklokke Manualer
18 Juni 2025
17 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
14 Juni 2025
9 April 2025