Calorex DH 15AX Manual

Calorex Affugter DH 15AX

Læs gratis den danske manual til Calorex DH 15AX (2 sider) i kategorien Affugter. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Calorex DH 15AX, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

SD462450 ISSUE 5

Installation instructions

MODELS DH 15AX - DH TTW 15AX

Heal & safety warnings

INSTALLATION - MODEL DH 15AX - DH TTW 15AX

1. Remove machine from packaging and locate ﬁxing bracket.

2. Locate bracket on wall in required position. Drill hole Ø6.0mm (no.10)

by 60mm deep as shown at ‘A’. Insert wall plug and screw bracket in

place.

3. Set bracket level wi spirit level as shown, drill rough and ﬁx it at ‘B’

wi wall plug and screw.

4. Ensure bracket still level, tighten screws ‘A’ and ‘B’, ﬁnally drill andﬁx

as above at position(s) ‘C’ & ‘D’.

5. Check all screws are tight.

6. Remove machine cover, retaining all ﬁxings.

7. Li dehumidiﬁer on to wall bracket and mark ﬁxing holes.

8. Drill holes and ﬁt wall plugs as stage 2.

9. Fit dehumidiﬁer to wall.

10. The electrical supply to e unit must be sized according to e data

on e serial number label paying special attention to I.E.E. regulations

latest edition regarding e special conditions governing electrical

supply to machines in potentially damp areas.

11. The electrical supply should be connected to e terminal block

mounted on e bracket supporting e compressor. Brown/red to

‘live’, blue/black to neutral and ear to e stud provided.

12. Whilst not mandatory, e Danerm Group recommend at an

R.C.C.B. is always ﬁtted or at e supply is to local electricity auority

recommendations, and at all ducting is bonded in accordance wi

ese regulations.

13. The supply to e machine should incorporate fuses or motor

rated circuit breakers (Type C) to speciﬁed rating, H.R.C. fuses are

recommended. An isolator must be ﬁtted wiin clear view and not

more an 2 metres away. The isolator must have a minimum 3mm air

gap in e oﬀ position.

14. Locate pipe from drip tray and run it away to waste.

A short leng of 10mm pipe is provided which should be led into a

ﬁxed waste pipe.

15. Set Humidistat to, “drier”, point on knob provided.

Please leave e instructions for e user.

As e Heat Pump contains electrical and rotational equipment, it is recommended at ONLY competent persons carry out any work on is type of

machine (see warranty).

ISOLATE ELECTRICALLY BEFORE ENTERING MACHINE OR REMOVING PANELS.

This appliance is not intended for use by persons (including children) wi reduced physical,sensory or mental capabilities, or lack of experience and

knowledge, unless ey have been given supervision or instruction concerning use of e appliance by a person responsible for eir safety. Children

should be supervised to ensure at ey do not play wi e appliance.

The Calorex TTW units are designed for installation in a heated room, adjacent to e pool room.

MACHINE OPERATION

MAINTENANCE

a. Ensure air inlet/outlets are kept clear and clean.

b. Wipe clean wi damp clo.

TTW MACHINES

Fit grilles, supplied wi e Heat Pump, in position required. Self-

adhesive base supplied wi e unit to be ﬁtted to e grill frame

as shown in e diagram below. Filters to be ﬁtted to grille. Isolate

machine electrically before entering machine or removing panels.

MACHINE NOT RUNNING AT ALL

CHECK THE FOLLOWING:

1. Is supply switched on.

2. Is supply fuse healy.

3. Check air inlet and outlet for obstructions.

4. If, aer carrying out e above and waiting 1 hour, e machine does

not start, phone for service.

MACHINE FAN ONLY RUNNING

5. Check air inlet and outlet for obstructions, if aer 30 mins e machine

has not restarted phone for service.

WATER LEAKING FROM BASE OF UNIT

6. Check connection from machine to drain for blockages and

clear accordingly. Check fall is adequate.

7. Check at machine is level bo vertically and horizontally.

The user check list should be carried out before initiating a service

call.

Do not attempt to interfere wi any internal control settings as ese

have been factory calibrated and sealed.

If in doubt or if advice is required, contact e Danerm group UK

Service Department. by calling (01621) 856611 (option 4) or

email service.department@danerm.com.

Produkt Specifikationer

Mærke:	Calorex
Kategori:	Affugter
Model:	DH 15AX

Har du brug for hjælp?

Hvis du har brug for hjælp til Calorex DH 15AX stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Affugter Calorex Manualer

Calorex DH 150AX Manual

13 August 2025

Calorex DH 75AX Manual

21 Juni 2025

Calorex DH 110 Manual

17 Juni 2025

Calorex AW 600 Manual

17 Juni 2025

Calorex Variheat AW1200 Manual

3 Januar 2025

Calorex DH 150 Manual

5 November 2024

Calorex Variheat AA1200 Manual

5 November 2024

Calorex DH 75 Manual

5 November 2024

Calorex DH 15AX Manual

5 November 2024

Calorex Variheat AA600 Manual

5 November 2024

Affugter Manualer

Nyeste Affugter Manualer

Klarstein AireLux Manual

8 December 2025

7 December 2025

6 December 2025

4 December 2025

3 December 2025

3 December 2025

3 December 2025

3 December 2025

3 December 2025

2 December 2025