Canarm PW-9 Manual


Læs gratis den danske manual til Canarm PW-9 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Canarm PW-9, eller vil du spørge andre brugere om produktet?

Side 1/8
Page 1 of 4
M-PW 26_03_25
GENERAL SAFETY
DIMENSIONS & COMPONENTS
The purpose of this manual is to aid in the proper installation and operation of the Canarm PW Series direct drive radial blade pressure
blowers. These instructions are intended to supplement good general practices and are not intended to overwrite local codes and
ordinances.
IT IS THE RESPONSIBILITY OF THE PURCHASER TO ENSURE THAT THE INSTALLATION AND MAINTENANCE OF THIS
EQUIPMENT IS HANDLED BY QUALIFIED PERSONNEL.
Inspect all shipments carefully for damage. THE RECEIVER MUST NOTE ANY DAMAGE ON THE CARRIER’S BILL OF LADING AND
FILE A CLAIM IMMEDIATELY WITH THE FREIGHT COMPANY.
The PW series come prepared from the factory, ready to run when installed and wired. 1.
All electrical work must be done in accordance with all applicable electrical codes by a 2.
qualified electrician.
Prior to wiring the unit, ensure the power supply is locked out in the OFF position and that 3.
the voltage matches the motor’s requirement, located on the motor’s name plate.
Caution: The unit contains rotating parts, & electrical service. Use appropriate caution when 4.
installing and servicing the unit. Install guarding around the intake venturi, or outlet discharge
in applications where it will be not be ducted.
Before starting the unit, ensure all parts are secure & the wheel rotates freely. 5.
Check and tighten where necessary all screws, nuts, bolts, etc. prior to starting the unit. 6.
Some may have loosened during shipping.
NOTE: Check and tighten all hardware after 2 days of initial operation. 7.
Make sure there is no foreign debris in the fan compartment or lodged in the wheel itself. 8.
Blowers should be installed on solid structural foundations. Vibration isolators are 9.
recommended. Work should be done under the supervision of licensed mechanical
contractors.
Always wear appropriate safety equipment when installing or 10.
servicing the unit.
Please follow all applicable national, state/provincial and local 11.
codes. All of them will supersede this manual.
Failure to follow the safety instructions in this manual may 12.
cause serious injury or death due to electrical shock or high
speed rotating parts.
!"#$
!"#$%&'&(")$%)$())*##+!)$(+"#$*%"!$*+"!$*+"!$*),%,"+$**")$()#")$*)(""""
!"#%
-&'&("#$% )$( )(")$* * #")$( #")$( +"+$* ! )$( ,"#$* +"#$% ,"!$* ,"#$% (."#$% + !")$( -"#$* )%"+$* ), """"
!"#&&
)."+$*&'&# +$* )%"#$% - % #")$( ,"!$* !")$* #$% !")$% ,")$( * !"+$* (."#$% , *"+$* ))"#$% )*")$% ), """"
!"#&'
)(")$(&'&#!$*)!*+%*,")$(#$%*")$%!")$(--"+$*(.")$*!).)."+$*)*"#$*)+""""
!"#&(
)#")$(&'&%"#$* &)")$* )!"+$* ))")$% !")$* +"#$% * -"-$), ) ).")$( -"+$* ))"#$* )) (( * ))")$( )("+$* ()")$( )+ !")$%
/0123456789 :;<=
)*+,-.
/*0
"1,,- 2*3, >?@
PW SERIES
DIRECT DRIVE RADIAL
BLADE PRESSURE BLOWERS
OPERATION INSTRUCTIONS AND PARTS MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS






Produkt Specifikationer

Mærke: Canarm
Kategori: Ikke kategoriseret
Model: PW-9

Har du brug for hjælp?

Hvis du har brug for hjælp til Canarm PW-9 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Canarm Manualer

Canarm

Canarm KE-14S Manual

8 Januar 2026
Canarm

Canarm KE-12SX Manual

8 Januar 2026
Canarm

Canarm VKM150 Manual

8 Januar 2026
Canarm

Canarm KE-08SX Manual

8 Januar 2026
Canarm

Canarm 925 Manual

8 Januar 2026
Canarm

Canarm HRE-13 Manual

8 Januar 2026
Canarm

Canarm G10-8DD Manual

8 Januar 2026
Canarm

Canarm VKM-AR 125 Manual

8 Januar 2026
Canarm

Canarm VKM450 Manual

8 Januar 2026
Canarm

Canarm PW-12 Manual

8 Januar 2026

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer