Casio DQR-100U Manual

Casio Ur DQR-100U

Læs gratis den danske manual til Casio DQR-100U (5 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Casio DQR-100U, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

Operation Guide DQR-100U

MA0402-EB

Main unit

SNZ

OFF

SET

UP(+)

WAVE

E- SYNC

°C / °F

DOWN(

–)

RESET

TEMP.

MAX/MIN

CLEAR

ALM

SNZ

OFF

ALM

SET

UP(+)

WAVE

RE-SYNC

° °C / F

DOWN(

–)

RESET

TEMP.

MAX/MIN

CLEAR

° °C/ F RESET

CA B

Sub-unit

•A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the

clock.

• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the

illustration.

Alarm Off Alarm On

•In locations subject to radio frequency interference, the product may malfunction and require you to reset the

product.

Alarm on

indicator

PM indicator

Wave OK indicator

Antenna Icon

Current Temperature

(OUTDOOR)

Current time

(Hour, minutes, seconds)

Day of the week

DATE (month – date)

Snooze on indicator

Alarm time

Current Temperature

(INDOOR)

Operation Guide DQR-100U

GENERAL GUIDE

Main unit

1SNOOZE/LIGHT button

•Press this button to illuminate the display for about four seconds.

•Pressing this button while the alarm is sounding stops the alarm.

2Alarm Time Set buttons

Use these buttons to change the alarm time or current time setting.

3SET button

Use this button when setting the current time.

4WAVE button

Press this button to receive the time calibration signal and adjust timekeeping.

5Alarm Mode selector

SNZ: Snooze alarm on

ON: Alarm on

OFF: Alarm off

6RESET button

Press this button to reset the clock after replacing its batteries.

7MAX/MIN TEMP. button

Press this button to display the high and low temperature values.

8CLEAR button

Press this button to clear the currently displayed high/low temperature.

9°C/

°F button

Press this button to toggle the temperature units between Celsius and Fahrenheit.

0RE-SYNC button

Press this button to re-synchronize the timing of the main unit and the sub-unit.

Sub-unit

A°C/

°F button

Press this button to toggle the temperature units between Celsius and Fahrenheit.

BRESET button

Press this button to reset the sub-unit after replacing its batteries.

CTEST button

This button is for testing the unit. Normally, you should not press it. If you do, be sure to press the RESET

button (B) next.

TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS

•This clock is able to receive the time calibration signal transmitted from

Rugby, England. Signal reception is possible within approximately

1,000 km of the transmitter.

•Even when the clock is within the reception range, signal reception is

impossible if the signal is blocked by mountains or other geological

formations between the clock and signal source.

•Signal reception is affected by weather, atmospheric conditions, and

seasonal changes.

•The time calibration signal is bounced off the ionosphere. Because of

this, such factors as changes in the reflectivity of the ionosphere, as well

as movement of the ionosphere to higher altitudes due to seasonal

atmosaheric changes or the time of day may change the reception

range of the signal and make reception temporarily impossible.

•Reception is best when the back of the clock is facing toward Rugby.

Note, however, that moving the clock while the time calibration signal

receive operation is taking place will make stable reception impossible.

•Think of the clock as acting like a TV or radio when it is receiving the calibration signal.When receiving indoors,

move to a location as near as possible to a window. Proper signal reception can be difficult or even impossible

under the conditions listed below.

Inside, among

buildings, or near

neon signs

Inside a vehicle Near refrigerators

or other household

appliances, near

office equipment,

mobile phones or

wireless LAN

devices.

Near a

construction site,

airport, or other

sources of

electrical noise,

underground or in

tunnels, near

railroads,

highways, or radio

stations with

interfering

frequencies.

Near high-tension

power lines

Among or behind

mountains

Rugby1,000 kilometers

500 kilometers

•Signal reception is normally better at night than during the day.

•Radio interference can make signal reception impossible.

•Strong electrostatic charge can result in the wrong time being set.

•The alarm does not operate during signal reception.

Produkt Specifikationer

Mærke:	Casio
Kategori:	Ur
Model:	DQR-100U

Har du brug for hjælp?

Hvis du har brug for hjælp til Casio DQR-100U stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ur Casio Manualer

Casio TMR-200 Manual

18 Juni 2025

Casio PDM-30B Manual

18 Juni 2025

Casio AEQ-120W Manual

18 Juni 2025

18 Juni 2025

18 Juni 2025

18 Juni 2025

18 Juni 2025

18 Juni 2025

18 Juni 2025

Casio AMW-870A Manual

18 Juni 2025

Ur Manualer

Nyeste Ur Manualer

ELYSEE Vintage Master 80546S Manual

18 Juni 2025

Ice Watch Boliday Prestige Manual

18 Juni 2025

ELYSEE Rally Timer I 80537 Manual

18 Juni 2025

ELYSEE Start-Up 18011L Manual

18 Juni 2025

Ice Watch Smart Junior 3.0 Find My Manual

18 Juni 2025

ELYSEE Minos 83821M Manual

18 Juni 2025

ELYSEE Picus 77013 Manual

18 Juni 2025

ELYSEE Heritage Chrono 11010 Manual

18 Juni 2025

ELYSEE The Race I 80523 Manual

18 Juni 2025

ELYSEE Nestor 15100 Manual

18 Juni 2025