Casio G-Shock AWG-M100B-1AER Manual

Casio Ur G-Shock AWG-M100B-1AER

Læs gratis den danske manual til Casio G-Shock AWG-M100B-1AER (10 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Casio G-Shock AWG-M100B-1AER, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/10
Operation Guide 5230
E-9
E-42 Confi guring Home City Settings
E-42 To confi gure Home City settings
E-45 To change the Daylight Saving Time (summer time) setting
E-48 Confi guring Current Time and Date Settings Manually
E-48 To change the current time and date settings manually
E-53 Using the World Time Mode
E-53 To enter the World Time Mode
E-53 To view the time in another time zone
E-54 To specify standard time or daylight saving time (DST) for a city
E-55 To swap your Home Time and World Time Cities
E-57 Using the Stopwatch
E-57 To enter the Stopwatch Mode
E-58 To perform an elapsed time operation
E-58 To pause at a split time
E-58 To measure two fi nishes
E-8
Contents
E-2 About This Manual
E-4 Things to check before using the watch
E-12 Charging the Watch
E-20 To recover from the sleep state
E-21 Radio Controlled Atomic Timekeeping
E-26 To get ready for a receive operation
E-29 To perform manual receive
E-33 To check the latest signal reception results
E-34 To turn auto receive on and off
E-37 Mode Reference Guide
E-41 Timekeeping
E-7
The watch is now ready for use.
For details about the watch’s radio controlled timekeeping feature, see “Radio x
Controlled Atomic Timekeeping” (page E-21).
E-6
2. Check the Home City and the daylight saving time (DST) setting.
Use the procedure under “To confi gure Home City settings” (page E-42) to
confi gure your Home City and daylight saving time settings.
Important!
Proper time calibration signal reception and World Time Mode data depend on
correct Home City, time, and date settings in the Timekeeping Mode. Make sure
you configure these settings correctly.
3. Set the current time.
xTo set the time using a time calibration signal
See “To get ready for a receive operation” (page E-26).
xTo set the time manually
See “Confi guring Current Time and Date Settings Manually” (page E-48).
E-5
Go to step 2.
The watch is charged.
For details about charging, see “Charging the Watch” (page E-12).
Power is low. Charge the watch by placing it in a location where it is exposed to
light. For details, see “Charging the Watch” (page E-12).
NEXT
E-4
Things to check before using the watch
1. Check the battery power level.
Is H or indicated as the battery power indicator (page E-15)?M
Battery power
indicator
YES
NO
E-3E-2
About This Manual
Depending on the model of your watch, display text x
appears either as dark fi gures on a light background,
or light fi gures on a dark background. All examples
in this manual are shown using dark fi gures on a light
background.
Button operations are indicated using the letters shown x
in the illustration.
Note that the product illustrations in this manual are x
intended for reference only, and so the actual product
may appear somewhat different than depicted by an
illustration.
E-1
ENGLISH
Congratulations upon your selection of this CASIO watch.
To ensure that this watch provides you with the years of service for which it is
designed, carefully read and follow the instructions in this manual, especially the
information under “Operating Precautions” and “User Maintenance”.
Be sure to keep all user documentation handy for future reference.
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any
damage or loss suffered by you or any third party arising through the use of this
product or its malfunction.
MA1611-ED
Operation Guide 5230
E-19
For details about the operating time and daily operating conditions, see the “Power x
Supply” (page E-94) section of the Specifi cations.
Power Saving
When turned on, Power Saving enters a sleep state automatically whenever the
watch is left for a certain period in an area where it is dark. The table below shows
how watch functions are affected by Power Saving.
For information about enabling and disabling power saving, see “To turn Power x
Saving on and off” (page E-83).
There actually are two sleep state levels: “display sleep” and “function sleep”. x
Elapsed Time in Dark Digital Dials Operation
60 to 70 minutes (display sleep) Blank Digital dials are off, but all functions
are enabled.
6 or 7 days (function sleep) Blank Hour and minute hands stop at
12 o’clock. All functions are disabled,
but timekeeping is maintained.
E-18
Charging Times
Exposure Level
(Brightness)
Daily
Operation
*1
Level Change *2
Level 5 Level 4 Level 3 Level 2 Level 1
Outdoor sunlight
(50,000 lux) 8 min. 3 hours 22 hours 6 hours
Window sunlight
(10,000 lux) 30 min. 7 hours 83 hours 23 hours
Window sunlight on
cloudy day (5,000 lux) 48 min. 10 hours
134 hours
36 hours
Indoor fl uorescent
lighting (500 lux) 8 hours 128 hours – – – – – –
1 Approximate exposure each day to generate power for normal daily operation. *
2 Approximate exposure time (in hours) required to take power up one level. *
The above exposure times all are for reference only. Actual exposure times depend x
on lighting conditions.
E-17
Power Recovery Mode
Performing multiple illumination, beeper, and/or high-speed hand movement x
operation during a short period may cause all of the battery power indicators (H,
M L, and ) to start fl
ashing in the lower digital dial. This indicates that the watch is in
the power recovery mode. Illumination, alarm, countdown timer alarm, and hourly
time signal operations will be disabled until battery power recovers.
Battery power will recover in about 15 minutes. At this time, the battery power x
indicators ( , , ) will stop flH M L ashing. This indicates that the functions listed above
are enabled again.
If all of the battery power indicators ( xH M L, , ) are fl ashing and the (charge) CHG
message also is fl ashing, it means the battery level is very low. Expose the watch
to bright light as soon as possible.
Frequent fl ashing of all of the battery power indicators ( xH M L, , ) probably means
that remaining battery power is low. Leave the watch in bright light to allow it to
charge.
E-16
At Level 5, all functions are disabled and settings return to their initial factory x
defaults. Once the battery reaches Level 2 ( ) after falling to Level 5, reconfiM gure
the current time, date, and other settings.
Display indicators reappear as soon as the battery is charged from Level 5 to x
Level 2 ( ).M
Leaving the watch exposed to direct sunlight or some other very strong light x
source can cause the battery power indicator to show a reading temporarily that
is higher than the actual battery level. The correct battery level should be indicated
after a few minutes.
The current time and all other settings return to their initial factory defaults x
whenever battery power drops to Level 5 and when you have the battery replaced.
E-15
Level
Battery Power Indicator
Function Status
1
(H) All functions enabled.
2
(M) All functions enabled.
3
(L and
LOW)
Auto and manual receive, illumination, and beeper
disabled.
Except for Timekeeping Mode, all other modes
disabled.
4
(CHG)
All functions and display indicators disabled except
for timekeeping and display of (charge) in the CHG
lower digital dial.
Hour and minute hands stopped at 12 o’clock.
5 All functions disabled.
The fl ashing xLOW message at Level 3 (L) tells you that battery power is very low,
and that exposure to bright light for charging is required as soon as possible.
E-14
Storing the watch for long periods in an area where there is no light or wearing it in x
such a way that it is blocked from exposure to light can cause power to run down.
Expose the watch to bright light whenever possible.
Power Levels
You can get an idea of the watch’s power level by observing the battery power
indicator in the lower digital dial.
Battery power indicator
E-13
Warning!
Leaving the watch in bright light for charging can cause it to become quite
hot. Take care when handling the watch to avoid burn injury. The watch can
become particularly hot when exposed to the following conditions for long
periods.
On the dashboard of a car parked in direct sunlight x
Too close to an incandescent lamp x
Under direct sunlight x
Important!
Allowing the watch to become very hot can cause the digital displays to black out. x
The appearance of the LCD should become normal again when the watch returns
to a lower temperature.
Turn on the watch’s Power Saving function (page E-19) and keep it in an area x
normally exposed to bright light when storing it for long periods. This helps to
ensure that power does not run down.
E-12
Charging the Watch
The face of the watch is a solar panel that generates power from light. The
generated power charges a built-in rechargeable battery, which powers watch
operations. The watch charges whenever it is exposed to light.
Charging Guide
Whenever you are not
wearing the watch, leave
it in a location where it is
exposed to light.
Best charging x
performance is achieved
by exposing the watch
to the strongest light
available.
When wearing the watch,
make sure that its face is
not blocked from light by
the sleeve of your clothing.
The watch may enter a x
sleep state (page E-19) if
its face is blocked by your
sleeve even only partially.
E-11
E-75 Hand Home Position Adjustment
E-75 To adjust home positions manually
E-78 Moving the Hands for Easy Viewing of the Digital Dials
E-79 To move the hands to view a digital dial
E-80 To return the hands to their normal positions
E-81 Other Settings
E-81 To turn the button operation tone on and off
E-83 To turn Power Saving on and off
E-85 Troubleshooting
E-92 Specifi cations
E-95 Operating Precautions
E-104 User Maintenance
E-10
E-60 Using the Countdown Timer
E-60 To enter the Countdown Timer Mode
E-60 To specify the countdown start time
E-62 To perform a countdown timer operation
E-62 To stop the alarm
E-63 Using the Alarm
E-63 To enter the Alarm Mode
E-64 To set an alarm time
E-65 To test the alarm
E-66 To turn an alarm and the Hourly Time Signal on and off
E-66 To stop the alarm
E-68 Illumination
E-68 To turn on illumination manually
E-69 To change the illumination duration
E-72 To turn the auto light switch on and off

Produkt Specifikationer

Mærke: Casio
Kategori: Ur
Model: G-Shock AWG-M100B-1AER

Har du brug for hjælp?

Hvis du har brug for hjælp til Casio G-Shock AWG-M100B-1AER stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ur Casio Manualer

Casio

Casio G-Shock GST-S110 Manual

27 Juli 2025
Casio

Casio Baby-G BGD-570 Manual

27 Juli 2025
Casio

Casio Edifice EFS-S510 Manual

27 Juli 2025
Casio

Casio Vintage A100WE-1AVT Manual

27 Juli 2025
Casio

Casio G-Shock GM-S5640 Manual

27 Juli 2025
Casio

Casio Baby-G MSG-S200 Manual

27 Juli 2025
Casio

Casio G-Shock GA-B001 Manual

27 Juli 2025
Casio

Casio Vintage A100 Manual

27 Juli 2025
Casio

Casio G-Shock GWG-2000 Manual

27 Juli 2025
Casio

Casio Vintage CA-500WEG Manual

27 Juli 2025

Ur Manualer

Nyeste Ur Manualer

Citizen

Citizen Star Wars Darth Vader Tsuno AN3669-52E Manual

27 Juli 2025
Citizen

Citizen Eco-Drive Brycen AW1598-70X Manual

27 Juli 2025
Citizen

Citizen Star Wars Jedi Master BM7498-00W Manual

27 Juli 2025
Citizen

Citizen Ladies' Dress EM0850-80D Manual

27 Juli 2025
Citizen

Citizen Disney Princess Ariel GA1073-63W Manual

27 Juli 2025
Citizen

Citizen Star Wars R2-D2 Tsuno AN3666-51A Manual

27 Juli 2025
Citizen

Citizen Silhouette Chronograph FB1443-08A Manual

27 Juli 2025
Citizen

Citizen Promaster Diver Super Titanium BN0200-56E Manual

27 Juli 2025
Citizen

Citizen Disney Special Edition Mulan GA1057-01W Manual

27 Juli 2025
Citizen

Citizen Eco-Drive Brycen BL556358E Manual

26 Juli 2025