Casio G-Shock DW-5610 Manual

Casio Ur G-Shock DW-5610

Læs gratis den danske manual til Casio G-Shock DW-5610 (4 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 6 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 3.5 anmeldelser. Har du et spørgsmål om Casio G-Shock DW-5610, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
Operation Guide 3229/3421/3489
E-9
To enable or disable Flash Alert
In the Timekeeping Mode, hold down for about two seconds to toggle Flash B
Alert between enabled and disabled. An indicator on the display shows when Flash
Alert is enabled.
Flash Alert indicator
x The Flash Alert indicator is shown in all modes until you disable Flash Alert.
audible tones and signals.
E-8
Backlight
The backlight illuminates the display. Enabling Flash Alert causes the backlight to
flash while the alarm (page E-10), countdown timer alarm, or hourly time signal is
sounding.
x Pressing D at any time illuminates the display regardless of the Flash Alert
enabled/disabled setting.
x The backlight uses an electro-luminescent (EL) light, which loses illuminating power
after very long use.
x Frequent use of the backlight shortens battery life.
x The watch will emit an audible sound whenever the display is illuminated. This is
caused by a transistor that vibrates while the EL panel is lit, and does not indicate
malfunction.
x Illumination provided by the backlight may be hard to see when viewed under
direct sunlight.
x Display illumination will automatically turn off if an alarm starts to sound.
E-7
3. While the seconds digits are selected (flashing), press to reset the seconds B
to “00”. If you press while the seconds count is in the range of 30 to 59, the B
seconds are reset to “00” and 1 is added to the minutes. If the seconds count is
in the range of 00 to 29, the minutes count is unchanged.
4. While any other digits (besides seconds) are selected (flashing), press to B
increase the number. Holding down changes the number at high speed.B
x To switch between the 12-hour and 24-hour formats, press D
D
D
D
D
while
some digits are flashing.
5. After you set the time and date, press to return to the Timekeeping Mode.A
x The day of the week is automatically set in accordance with the date.
x The date can be set within the range of January 1, 2000 to December 31, 2099.
x If you do not operate any button for a few minutes while a selection is flashing,
the flashing stops and the watch goes back to the Timekeeping Mode
automatically.
E-6
Timekeeping
To set the time and date
1. Press while in the Timekeeping Mode. The A
seconds digits flash on the display because they
are selected.
2. Press to change the selection in the following C
sequence.
Minutes
HourSeconds
Month
Day
C
C
C C
C
Year
C
Minutes
Day of week
Month
Day
PM indicator
Hour Seconds
E-5
C
Stopwatch Mode Countdown Timer Mode
C
x After you perform an operation in any mode, pressing C returns to the
Timekeeping Mode.
x Press D in any mode to illuminate the display. Illumination turns off about two
seconds after you release D.
E-4
General Guide
x Press C to change from mode to mode.
Timekeeping Mode Alarm Mode
CC
E-3
Countdown Timer............................................................................................. E-14
To set the countdown time ........................................................................... E-14
To use the countdown timer ......................................................................... E-15
To switch auto repeat timing on and off ....................................................... E-16
Stopwatch ......................................................................................................... E-18
To measure elapsed time.............................................................................. E-18
To record split times .................................................................................... E-19
To time first and second place finishes......................................................... E-19
Specifications ................................................................................................... E-20
Operating Precautions ..................................................................................... E-22
User Maintenance ............................................................................................ E-32
E-2
Contents
About This Manual ............................................................................................. E-1
General Guide ..................................................................................................... E-4
Timekeeping ....................................................................................................... E-6
To set the time and date ................................................................................. E-6
To enable or disable Flash Alert...................................................................... E-9
Alarm ................................................................................................................. E-10
To set the alarm time .................................................................................... E-11
To stop the alarm ......................................................................................... E-13
To switch an alarm and Hourly Time Signal on and off ................................. E-13
E-1
About This Manual
x Depending on the model of your watch, display text
appears either as dark figures on a light background or
light figures on a dark background. All sample displays
in this manual are shown using dark figures on a light
background.
x Button operations are indicated using the letters shown
in the illustration.
x Note that the product illustrations in this manual are
intended for reference only, and so the actual product
may appear somewhat different than depicted by an
illustration.
E
ENGLISH
Congratulations upon your selection of this CASIO watch.
To ensure that this watch provides you with the years of service for which it is
designed, carefully read and follow the instructions in this manual, especially the
information under “Operating Precautions” and “User Maintenance”.
MA2003-EA
Ú
#!3)/#/-054%2#/,4$
Operation Guide 3229/3421/3489
E-19
To record split times
1. Press to start the stopwatch.B
2. Press to display the timing up to that point. Stopwatch timing continues A
internally.
3. Press A to clear the split time and to continue time measurement on the display.
x You can repeat steps 2 and 3 as many times as you want.
4. Press to stop the time measurement.B
5. Press to clear the stopwatch to all zeros.A
To time first and second place finishes
1. Press to start the stopwatch.B
2. Press when the first finisher crosses the line, and record the time.A
3. Press when the second finisher crosses the line.B
4. Press to display the finishing time of the second finisher.A
5. Press again to clear the stopwatch to all zeros.A
E-18
Stopwatch
The Stopwatch Mode lets you measure elapsed
time, split times, and two finishes. The range of the
stopwatch is 23 hours, 59 minutes, 59 seconds.
To measure elapsed time
1. Press to start the stopwatch.B
2. Press to stop the stopwatch.B
x You can resume the measurement operation by
pressing again. B
3. Press to clear the stopwatch to all zeros.A
x For the first 60 minutes, the display shows
minutes, seconds, and 1/100 second. After
60minutes, the display format changes to show
hours, minutes, and seconds.
Minutes
1/100 second
Current time
Mode indicator
Seconds
E-17
3. Press to return to the Countdown Timer Mode.A
x When the end of the countdown is reached while auto repeat is on, the alarm
again automatically whenever the countdown reaches zero. You can stop timing
by pressing B, and manually reset to the starting countdown time by pressing
A.
E-16
3. Stop the timer and then press until the countdown time is reset to its starting A
value.
x When the end of the countdown is reached and auto repeat timing is off, the
alarm sounds for 10 seconds or until you stop the alarm by pressing any button.
Countdown timing stops, and the countdown time is automatically reset to its
starting value after the alarm stops.
To switch auto repeat timing on and off
1. Press while in the Countdown Timer Mode. A
The hours digit flashes on the display because it
is selected.
2. Press to switch auto repeat on and off.D
Auto repeat on indicator
E-15
3. Press to increase the selected number. Holding down changes the B B
number at high speed.
x To set the starting value of the countdown time to 24 hours, set 0:00' 00.
4. After you set the countdown time, press to return to the Countdown Timer A
Mode.
x If you do not operate any button for a few minutes while a selection is flashing,
the flashing stops and the watch goes back to the Countdown Timer Mode
automatically.
To use the countdown timer
1. Press while in the Countdown Timer Mode to start the countdown timer.B
2. Press again to stop the countdown timer.B
x You can continue countdown timer operation by pressing B.
E-14
Countdown Timer
The countdown timer can be set within a range of
1second to 24 hours. When the countdown reaches
zero, an alarm sounds for 10 seconds or until you
press any button.
To set the countdown time
1. Press while in the Countdown Timer Mode. A
The hours digit flashes on the display because it
is selected.
2. Press to change the selection in the following C
sequence.
Minutes
Hours Seconds
C C
C
Minutes
Current time
Mode indicator
Hours Seconds
E-13
To stop the alarm
Press any button to stop the alarm after it starts to sound.
To switch an alarm and Hourly Time Signal on and off
Press while in the Alarm Mode to change the status of an alarm (see “Alarm B
Types” on page E-10) and Hourly Time Signal in the following sequence.
Both on
Both off Alarm only
B
Hourly Time
Signal only
B
B B
Alarm on indicator
Hourly time signal on indicator
E-12
2. Press to change the selection in the following sequence.C
Minutes
Hour
Day
C
Month
CC
C
3. Press to increase the selected digits. Holding down changes the number B B
at high speed.
x The format (12-hour and 24-hour) of the alarm time matches the format you
select for normal timekeeping.
x When setting the alarm time using the 12-hour format, take care to set the time
correctly as morning or afternoon.
4. After you set the alarm time, press to return to the Alarm Mode. A
x If you do not operate any button for a few minutes while a selection is flashing,
the flashing stops and the watch goes back to the Alarm Mode automatically.
E-11
x To set a date alarm
Set the month, day, hour and minutes for the alarm time. This type of setting
causes the alarm to sound at the specific time, on the specific date you set.
x To set a 1-month alarm
Set the month, hour and minutes for the alarm time. Set “– –” for the day (see step
3 under “To set the alarm time”). This type of setting causes the alarm to sound
every day at the time you set, only during the month you set.
x To set a monthly alarm
Set the day, hour and minutes for the alarm time. Set “–” for the month (see step 3
under “To set the alarm time”). This type of setting causes the alarm to sound every
month at the time you set, on the day you set.
To set the alarm time
1. Press while in the Alarm Mode until the hour digits start to flash on the A
display. The hour digits flash because they are selected.
x At this time, the alarm is automatically switched on.
E-10
Alarm
You can set an alarm with hour, minutes, month,
and day. When the alarm is on, the alarm sounds
for 20 seconds at the preset time. When the Hourly
Time Signal is on, the watch beeps every hour on
the hour.
Alarm Types
The types of alarm you get depends on the
information you set.
x To set a daily alarm
Set the hour and minutes for the alarm time. Set
“–” for the month and “– –” for the day (see step 3
under “To set the alarm time”). This type of setting
causes the alarm to sound every day at the time
you set.
Alarm on
indicator
Mode
indicator
Month
MinutesHour
Hourly time signal on indicator
Day

Produkt Specifikationer

Mærke: Casio
Kategori: Ur
Model: G-Shock DW-5610

Har du brug for hjælp?

Hvis du har brug for hjælp til Casio G-Shock DW-5610 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ur Casio Manualer

Casio

Casio AE2000W-1AV Manual

5 September 2025
Casio

Casio AEQ-110 Manual

4 September 2025
Casio

Casio G-Shock GA-700UC-3A Manual

28 Juli 2025
Casio

Casio Baby-G BSA-B100 Manual

27 Juli 2025
Casio

Casio G-Shock GM-110 Manual

27 Juli 2025
Casio

Casio G-Shock GM-S5600 Manual

27 Juli 2025
Casio

Casio Edifice EF-527D-1A Manual

27 Juli 2025
Casio

Casio Edifice EFR-571 Manual

27 Juli 2025
Casio

Casio G-Shock GST-S110 Manual

27 Juli 2025
Casio

Casio Baby-G BGD-570 Manual

27 Juli 2025

Ur Manualer

Nyeste Ur Manualer

Grand Seiko

Grand Seiko 9F85 Manual

12 September 2025
Grand Seiko

Grand Seiko 9R01 Manual

11 September 2025
Grand Seiko

Grand Seiko 9R65 Manual

11 September 2025
Grand Seiko

Grand Seiko 9R02 Manual

11 September 2025
Grand Seiko

Grand Seiko 9R15 Manual

11 September 2025
Citizen

Citizen Attesa Satellite Wave GPS Layers of Time CC4057-60E Manual

3 September 2025
Citizen

Citizen L Mae EM1060-52N Manual

3 September 2025
Citizen

Citizen Corso Diamond EW2712-55E Manual

3 September 2025
Citizen

Citizen Attesa Radio Controlled Layers of Time AT8286-65E Manual

3 September 2025
Breitling

Breitling AVI Ref. 765 1964 Re-Edition Manual

28 August 2025