Celly MAGPB5000 Manual

Celly power bank MAGPB5000

Læs gratis den danske manual til Celly MAGPB5000 (30 sider) i kategorien power bank. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Celly MAGPB5000, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/30

Please read this manual and

pay attention to the safety

warnings before using the

product Keep the manual to

have the possibility to consult it at a later

time, or in case of passing the product to

a third party.

Esprinet S.p.A. can not in any way be

held responsible for injury or damage

caused to people or things resulting from

improper use of the product.

Safety notes

To avoid malfunction or damage to the

product, avoid accidental falls, do not

crush, puncture or exert a high level

of pressure on the product. is could

cause an internal short circuit and / or

overheating.

Keep away from moisture, water or other

liquids. If the product comes into contact

with water, moisture or other liquids,

do not use the product to avoid electric

shock, explosion or damage.

If the product gets wet, even if it dries

and operates normally, the battery

contacts and circuitry may slowly corrode

and pose a safety hazard.

Do not store or expose the product to

any heat source, direct sunlight, radiators,

stoves or other heat sources such as the

dashboard of your car in the summertime.

is could cause the battery to explode

or aﬀect performance. Never use the

product unsupervised.

During operation, the casing will become

hot. Allow adequate ventilation. e

casing must never be covered.

Never use the product when moving

from a cold to a warm environment.

Condensation may occur which, in some

cases, could damage the product.

Allow the product to reach room

temperature before plugging it back in

and using it again. is could take several

hours. Usage temperature: 0-40 ° C.

Do not attempt to modify, repair

or disassemble the product. Risk of

explosion!

Do not leave the product in contact with

metal objects.

Metallic objects can interfere with

the electrical connections causing the

protection circuit to malfunction.

Stop using the product immediately if you

notice any swelling, dispersion or other

abnormality.

Do not use a damaged product.

Make sure the cable provided for charging

the product is intact and does not short

circuit the charging ports.

A non-replaceable rechargeable battery

is built into the product, never open or

disassemble the product. Do not short-

circuit the battery contacts / terminals.

Do not dispose of the product in open

ﬂames. Danger of explosion and ﬁre!

Charge the battery regularly, even when

the product is not in use. is will extend

its life (at least once every 2 months)

Never charge the product when

unattended. While charging, place the

product on a heat-resistant surface. Heat

build-up is normal during charging.

Under no circumstances use aggressive

cleaning agents, alcohol or other chemical

solutions for cleaning as they could

damage the housing or even compromise

the functionality of the product.

Disconnect all connected cables before

starting cleaning. Do not immerse the

product in water or other liquids.

Do not press too hard on the housing

to avoid scratches and damage. Keep

the product out of the reach of children.

Never allow children or people with

disabilities to use electrical products

unsupervised.

Make sure children do not play with

the plastic wrap. ey could swallow

fragments and choke.

Charging the power bank

1. Plug the smaller end of the supplied

USB-C cable into the USB-C port on the

power bank.

2. Plug the larger end of the cable

(USB-A) into the USB port of a charging

socket or computer (DC 5V, 2A), and the

smaller end (USB-C) into the charging

socket (IN). Charging of the power bank

will start. It is recommended to charge

12 hours for the ﬁrst charge cycle. During

charging, the LEDs on the product will

ﬂash. At the end of the charge, the LEDs

will stop ﬂashing and remain on. e time

required for recharging is approximately

3 hours.

3. Disconnect the USB-C cable from the

charging input port (IN) of the powerbank

after charging.

Loading devices

1. Make sure the power bank is

suﬃciently charged.

2. Before charging the device, make sure

that the technical characteristics of your

device (voltage, amperage) are compatible

with the power bank.

Charging with USB cable

Connect the device to the USB port of

the powerbank using the original cable

supplied with your device. Charging of the

device will start.

Once charging is complete, disconnect

the cable from the device and the power

bank.

Wireless charging

Magnetically align the power bank to

the phone and press the button charging

start button on the right side of the

product, wireless charging will start.

Once charging is complete, unplug the

power bank from the phone.

Cleaning

Disconnect all cables before cleaning.

If necessary, clean the power bank with a

damp cloth and allow it to dry completely

before use.

Use a clean brush with soft, long bristles

to remove dust from the connectors.

Do not use solvents, corrosive agents or

gaseous cleaners.

Make sure that water or other liquids do

not enter the housing.

Storage

Store the power bank in a clean and dry

area. Keep away from direct sunlight.

CUSTOMER’S INFORMATION

FOR RIGHT WASTE OF THIS

PRODUCT (Directive 2013/56/

EU)

e crossed-out bin symbol shown on the

equipment or on its packaging indicates

that the product at the end of its useful

life, including the non-removable battery,

must be collected separately from other

waste to allow for proper treatment and

recycling. e safe use of this product

is guaranteed in compliance with the

following instructions, therefore it is

necessary to keep them and follow

them scrupulously throughout the life

of the product. e product does not

require technical maintenance, NEVER

DISASSEMBLE IT. e battery inside is

integrated and not replaceable. Do not

attempt to remove the built-in Lithium

Ion / Polymer battery by yourself as it

may cause overheating, ﬁre and injury.

e battery should only be removed by

independent qualiﬁed professionals who

are able to remove it safely and disposed

of in accordance with applicable laws. e

user must, therefore, give the equipment

at the end of its life free of charge to

the appropriate municipal centers for

the separate collection of electrical and

electronic waste, or return it to the

retailer, on a one-by-one basis, or free

of charge for appliances with smaller

external dimensions. to 25 cm. Adequate

separate collection for the subsequent

sending of the decommissioned

equipment for recycling, treatment and

environmentally compatible disposal

helps to avoid possible negative eﬀects

on the environment and health and

favors the reuse and / or recycling of the

materials of which it is composed the

equipment. Illegal disposal of equipment,

batteries and accumulators by the user

involves the application of the penalties

provided for by the current legislation.

Technical speciﬁcations

Input: DC 5V / 2A

Output 1: DC 5V / 2A

Output 2: DC 5V / 2A

Total output: DC 5V / 2A

Wireless output: DC 5V / 1A, 9V / 1.1A

Max output power: 10W

Maximum radiated power: <20 mW

Frequency: 110-205KHz

Charging time: 3 hours

Capacity: 5000mAh / 18.5Wh

Software: SW6201

Battery type: Li-ion battery

Weight: 135g

Size: 96 * 63 * 12mm

Usage temperature: 0 - 40 °

is product complies with

RoHS 2011/65 / EU-2015/863

/ EU. e product is marked

with the CE mark and complies with the

safety standards established by the

European Union.

Esprinet SpA declares that the product

complies with directive 2014/53 / EU.

e full text of the EU declaration of

conformity is available at the following

Internet address: www.celly.com/

exchange/CELLY-SPA/Dichiarazioni_di_

conformita/MAGPB5000/DOC.pdf

Celly® is a trademark owned by CELLY

S.p.A.

All brands are registered trademarks of

their respective owners.

Esprinet S.p.A., via Energy

Park 20, 20871 Vimercate

(MB) - Italy

Made in China.

Instruction manual

PORTABLE WIRELESS CHARGER

Model: MAGPB5000

Rev00 - 30.09.2021

Produkt Specifikationer

Mærke:	Celly
Kategori:	power bank
Model:	MAGPB5000
Bredde:	63 mm
Dybde:	15 mm
Højde:	95 mm
Vægt:	135 g
Antal pr. pakke:	1 stk
Produktfarve:	Hvid
Batterikapacitet:	5000 mAh
Kabler inkluderet:	USB Type-A til USB Type-C
Udgangsspænding:	5 V
Udgangsstrøm:	2 A
Indgangsspænding:	5 V
Opladningskilde:	USB
Antal enheder der er tilsluttet samtidigt (maks.):	1
Oplader, kompabilitet:	Mobiltelefon/Smartphone
Inputgrænseflade:	USB Type-A
USB A udgangsporte:	1
Antal USB type-C-porte:	1
Indgangsstrøm:	2 A
Form:	Rektandel
Trådløs opladning:	Ja
USB Type-C stik:	Ja
Total udgangseffekt:	10 W
Batteri, opladningstid (USB):	3 t
Power bank & enhed oplades på en gang:	Ja
USB Type-A-stik:	Ja