2
Information or useful tip.
Battery.
Magnet.
The product is declared recyclable following an analysis of the life cycle in accordance with standard ISO 14040.
Chauvin Arnoux has adopted an Eco-Design approach in order to design this appliance. Analysis of the complete life-
cycle has enabled us to control and optimize the eects of the product on the environment. In particular this appliance
exceeds regulation requirements with respect to recycling and reuse.
The CE marking certies that the product is in compliance with the requirements applicable in the Union European, in
particular as regards Low Voltage Directive 2014/35/EU, Electromagnetic Compatibility Directive 2014/30/EU, Radio
Equipment Directive 2014/53/EU, and Restriction of Hazardous Substances Directives 2011/65/EU and 2015/863/EU.
The UKCA marking certies that the product is in compliance with the requirements applicable in the United Kingdom
as regards Low Voltage, Electromagnetic Compatibility, and Restriction of Hazardous Substances.
The rubbish bin with a line through it indicates that, in the European Union, the product must undergo selective disposal
in compliance with Directive WEEE 2012/19/EU. This equipment must not be treated as household waste.
PRECAUTIONS FOR USE
This instrument is compliant with safety standard IEC/EN 61010-2-30 or BS EN 61010-2-030, for voltages up to 5V with respect
to ground. Failure to observe the safety instructions may result in electric shock, re, explosion, and destruction of the instrument
and of the installations.
The operator and/or the responsible authority must carefully read and clearly understand the various precautions to be taken in
use. Sound knowledge and a keen awareness of electrical hazards are essential when using this instrument.
Observe the conditions of use, namely the temperature, the relative humidity, the altitude, the degree of pollution, and the place
of use.
Do not use the instrument if it seems to be damaged, incomplete, or poorly close.
Before each use, check the condition of the housing. Any item of which the insulation is deteriorated (even partially) must be set
aside for repair or scrapping.
Always hold the handle of the sensor, and keep your ngers away from the propeller.
All troubleshooting and metrological checks must be done by competent, accredited personnel.
Thank you for purchasing this C.A 1227 thermo-anemometer.
For best results from your instrument:
read these operating instructions carefully,
comply with the precautions for use.
