Chief SLB6500 Manual

Chief Flad panel støtte SLB6500

Læs gratis den danske manual til Chief SLB6500 (1 sider) i kategorien Flad panel støtte. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Chief SLB6500, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

8850-000194 Rev01

a Duchossois Group Company

05/09

I N S T A L L A T I O N I N S T R U C T I O N S

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use

of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or

implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

SLB-6500 and SLM-6500 Interface Brackets

SLB and SLM series Interface brackets are designed for use with Chief RPA, RPM, and Smart-Lift series projector mounts. See the specific

installation instructions provided with the mount for additional installation information.

Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!

Installation:

WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE

TO EQUIPMENT! DO NOT over tighten screws when installing Interface bracket.

NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.

1. Screw six thumb screws onto six 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2. Turn projector upside down.

3. Place Interface bracket onto bottom of projector and align four threaded inserts with mounting holes.

4. Secure Interface bracket to projector using four M6 x 12mm Phillips pan head screws and four M6 flat washers.

NOTE: If there is interference when installing the bracket due to the design of certain projector models, use the nylon spacers and longer

M6 x 16mm screws instead of the M6 x 12mm screws and M6 flat washers.

NOTE: Security Screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the

All- Points Security Kit.

(1) Interface Bracket (4) Screw, Phillips Pan Head, Machine, M6 x 12mm

(6) 10 - 24 Thumb Nuts** (4) Washer, Flat, M6

(1) All-Points Security Kit (4) Screw, Phillips Pan Head, Machine, M6 x 16mm

(1) 5/32" Hex Key (4) Spacer, Nylon, .320 x .500 x .250

**Only used when installing SLB Interface brackets.

Towards front

of projector

Towards front

of projector

Produkt Specifikationer

Mærke:	Chief
Kategori:	Flad panel støtte
Model:	SLB6500

Har du brug for hjælp?

Hvis du har brug for hjælp til Chief SLB6500 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Flad panel støtte Chief Manualer

Chief MWCU Manual

3 April 2025

Chief KITXWXSM1U Manual

3 April 2025

3 April 2025

2 April 2025

9 Marts 2025

30 Januar 2025

30 Januar 2025

15 Januar 2025

15 Januar 2025

Chief TILD1X5NE1-M Manual

15 Januar 2025

Flad panel støtte Manualer

Nyeste Flad panel støtte Manualer

Anywhere Cart AC-GO-16 Manual

2 April 2025

Proaim P-DMC Manual

2 April 2025

Proaim CT-VNGD-CS Manual

2 April 2025

Mount-It! MI-7919 Manual

2 April 2025

Mount-It! MI-384 Manual

2 April 2025

Proaim CT-VNGD-UC5 Manual

2 April 2025

Premier Mounts 7170-0977 Manual

2 April 2025

Mount-It! MI-766 Manual

2 April 2025

Erard FLAK 800+ Manual

2 April 2025

Metronic 451060 Manual

28 Marts 2025