Cisco Aironet 1042N Manual

Cisco Adgangspunkt Aironet 1042N

Læs gratis den danske manual til Cisco Aironet 1042N (34 sider) i kategorien Adgangspunkt. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Cisco Aironet 1042N, eller vil du spørge andre brugere om produktet?

Side 1/34
G ETTING S GTARTED UIDE
Cisco Aironet 1040 Series Access Points
1About this Guide
2Safety Instructions
3Unpacking
4Overview
5Configuring the Access Point
6Additional Configuration for the Access Point in Autonomous Mode
7Mounting the Access Point
8Deploying the Access Point on the Wireless Network
9Troubleshooting
10 Declarations of Conformity and Regulatory Information
11 Configuring DHCP Option 43 and DHCP Option 60
12 Access Point Specifications
2
1 About this Guide
This Guide provides instructions on how to install and configure your Cisco Aironet 1040 Series
Access Point. This guide also provides mounting instructions and limited troubleshooting procedures.
2 Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings
document that is shipped with your access point. The translated warnings are also in the Translated
Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury.
Before you work on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the
translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004
Warning
This product must be connected to a Power-over-Ethernet (PoE) IEEE 802.3af compliant
power source or an IEC60950 compliant limited power source.
Statement 353
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
This product relies on the buildings installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than:
20A.
Statement 1005


Produkt Specifikationer

Mærke: Cisco
Kategori: Adgangspunkt
Model: Aironet 1042N

Har du brug for hjælp?

Hvis du har brug for hjælp til Cisco Aironet 1042N stil et spørgsmål nedenfor, og andre brugere vil svare dig




Adgangspunkt Cisco Manualer

Cisco

Cisco 541N Manual

9 Oktober 2024
Cisco

Cisco Aironet 1142N Manual

27 September 2024
Cisco

Cisco Meraki MR72 Manual

19 September 2024
Cisco

Cisco Meraki MR74 Manual

1 September 2024

Adgangspunkt Manualer

Nyeste Adgangspunkt Manualer