Citizen CAL 4610 Manual

Citizen Ur CAL 4610

Læs gratis den danske manual til Citizen CAL 4610 (3 sider) i kategorien Ur. Denne vejledning er vurderet som hjælpsom af 25 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 13 anmeldelser. Har du et spørgsmål om Citizen CAL 4610, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

Caution

Before using the watch, READ this instruction

manual carefully for safe and correct use. After

reading this manual, keep it properly for your future

reference.

SAFETY PRECAUTIONS (Please observe at all

times)

In order to prevent injury to yourself or other persons

and damage to property, this manual describes the

instructions that you should strictly follow as follows.

■ Injuries and damages which might be caused by

using the watch improperly, neglecting any of the

instructions or precautions in this manual are

classiﬁed with the following symbols.

Warning Can cause serious injury or death

Caution Can or will cause minor or moderate

injury or damage

SPECIFICATIONS

1. Quartz oscillation frequency: 32,768Hz (Hz =

number of vibrations per second)

2. Converter: Step motor

3. Additional functions: Calendar quick setting

function (applies to watches equipped with day as

well as day and month calendar functions)

4. IC (integrated circuit): 1C/MOS-LSI

5. Accuracy: refer to model list: (within ±◊seconds

per month at normal temperature

(+5°C≈+35°C))

6. Battery: One silver oxide

7. Battery life duration (life of battery from time of

installation) for your watch, refer to model list,

The model number of the watch you have purchased

is engraved on the back cover of the watch as shown

in the ﬁgure below.

The above speciﬁcations are subject to change

without prior notiﬁcation.

SETTING INSTRUCTIONS

1. Setting the Time and Date

(1) Stop the second hand in the “0 seconds” position

by pulling out the crown to 2 then turn crown to

set watch hands to the correct time. In case of a

screw lock-type crown, place in position 2 after

unlocking the screw.

(2) After setting watch to the correct time and

returning crown to the 0 position, the second

hand will be activated and the watch will

commence to keep accurate time.

Due to the mechanical structure of the watch, the

step position of the second hand is not aligned

with the scale on the face. This does not have an

effect on the accuracy, however.

Note:

a. To achieve optimal precision when setting the

minute hand, move the minute hand four to ﬁve

minutes past and then back to the desired setting.

b. For calendar-equipped watches, do not confuse

AM and PM settings.

c. For watches equipped with locking screw-type

crowns, do not forget to return the crown to the

locked position after setting watch.

2. Setting the calendar

(1) Pull out crown to position 1

(2) Set date by turning crown to the left.

(3) Set day by turning crown to the right.

*For watches equipped with date display only,

date is set by turning crown to the right.

(4) Return crown to 0 position.

Note:

Avoid performing the calendar quick setting operation

between the below listed times:

For watches equipped with date display...9.00 PM-

1:00 AM

For watches equipped with both date and day

display...9:00 PM-4:30 AM

If the calendar quick setting operation is performed

between these times the calendar could be

incorrectly set to the date of the previous day.

After setting watch hands during these times, set

time, day and date accordingly.

CAL 1010 1020 1030 1110 3220 4520 461* 4633 464*

Accuracy 20 20 20 20 20 15 20 20 20

Battery

Life 3 5 3 3 3 2 2 2 2

CAL 4713 477* 5421 5431 5500 5510 5530 5920 5930

Accuracy 20 20 20 20 20 20 20 20 20

Battery

Life 3 2 3 2 5 5 5 2 2

CAL 6010 6020 6031 604* 6115 6790 7630 9620 9630

Accuracy 20 20 20 20 20 20 30 20 20

Battery

Life 3 3 3 3 3 3 2 2 2

Regular Analog Setting Instructions

Note: Your model may not feature

a second hand or day/day-date feature

Marking Marking Water-resistant

on the Dial on the characteristics

Caseback

Face washing, Swimming Skin diving Scuba diving

splashes, (diving (diving with

sweat, without air tanks)

raindrops, etc. air tanks)

Non water-resistant

NONE NONE NO NO NO NO watch and must be kept

away from water.

An ordinary water-resistant

NONE WATER OK NO NO NO watch and can withstand

RESIST splashes, sweat, rain-drops

and etc. for daily life use.

WR100M WATER For frequent use with

WR10bar RESIST OK OK OK NO water. It is not specially

WR150M designed for scuba diving.

For skin and scuba diving.

WR200M WATER Usable up to the respectiveOK OK OK OK

RESIST indicated depths.

See instruction book for further information

TEMPERATURE CARE

Avoid temperature extremes. Exposing your watch to high

temperatures, such as placing it on the dashboard of a vehicle

or use in a hot tub, may cause the watch to malfunction,

shorten battery life or damage certain components. Leaving

the watch in extreme cold temperatures may cause irregular

timekeeping until the watch returns to normal operating

temperature.

SHOCK-RESISTANT

The watch may be worn while playing golf or other activities,

but avoid severe shocks such as dropping it on a hard surface.

MAGNETIC-RESISTANT

No problem should occur from using the watch around

ordinary household electric appliances such as TV sets or

stereos. Keep away from magnets.

CHEMICAL/GAS RESISTANT

Do not expose the watch to chemicals or gases for long

periods.

WATCH CLEANING

Stains, waterspots and accumulated dirt on the case, crystal

or band should be removed with a soft cloth to prevent

damage and premature wear.

HANDLING OF WATER-RESISTANT WATCHES

Although water-resistant watches are warranted, steps should

be taken to avoid damage that may result from

accidents or mishandling:

■Do not operate the crown or push-button in the water or

while the watch is wet. Tighten screw lock crown completely.

■Should the watch become immersed in water, dry it off

right away. If the watch comes in contact with salt water, be

sure to rinse it thoroughly in warm fresh water to remove any

trace of salt.

■If a watch is wet from cleaning or by accident, never store it

in a closed container. It should be dried immediately or taken

to a watchmaker or jeweler if moisture is inside the case to

prevent damage from rust.

■Vital components necessary to resist the entrance of

moisture deteriorate with time and use. Gaskets, crowns and

other materials should be replaced every year or two to ensure

PRECAUTIONS ABOUT CARE AND

HANDLING OF WATCHES

that water resistant quality remains at factory specifications.

CARE FOR METAL BRACELETS

To extend the life and maintain the good appearance of the

metal watch bracelet, the following recommendations are

given:

■Be aware that since the watch and bracelet is worn next to

the skin, it collects dust and perspiration and becomes soiled if

not cleaned regularly. This is particularly true of the inner parts

of the links or mesh of the bracelet.

■Soil and rust, when present in a bracelet, are dissolved by

perspiration and can cause staining of cuffs and

irritation of the skin in some instances.

■Heavy perspiration should be wiped off the watch and

bracelet with a soft dry cloth. The bracelet should be cleaned

occasionally by using an old toothbrush and warm soapy

water after which the soap is thoroughly rinsed with clear water

and the bracelet dried completely. The foregoing manner of

cleaning should not be done if the watch is not water-resistant

but should instead be done by your jeweler.

CARE FOR STRAPS

LEATHER

■Heavy perspiration, if not removed from a leather strap, can

wash out the natural oils and cause the leather to become dry

and deteriorate. Any moisture should be blotted with a soft dry

cloth or paper towel and the strap allowed to dry naturally.

■Salt residue and soil can be removed from the leather by

cleaning with a dampened soft cloth and mild soap or saddle

soap.

■Occasionally, the inside surface of the strap should be

cleaned by using a soft cloth dampened with alcohol.

■The strap should always be worn a little loosely (one finger

space between wrist and strap) to allow air to circulate thus

causing any moisture to evaporate.

RUBBER

■Rubber straps should be washed frequently with mild soap

and warm water using a soft brush.

■Thorough cleaning, using the same method, should

especially be done after use in salt water.

■Solvents, oils, perspiration, tanning lotion and salt can cause

rubber to deteriorate if not removed.

Produkt Specifikationer

Mærke:	Citizen
Kategori:	Ur
Model:	CAL 4610

Har du brug for hjælp?

Hvis du har brug for hjælp til Citizen CAL 4610 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ur Citizen Manualer

Citizen Cal 411X Manual

6 Oktober 2024

Citizen CAL B800 Manual

4 Oktober 2024

Citizen CAL U700 Manual

4 Oktober 2024

Citizen CAL 4633 Manual

4 Oktober 2024

Citizen CAL 9510 Manual

23 September 2024

Citizen CAL H461 Manual

22 September 2024

Citizen CAL H360 Manual

20 September 2024

Citizen CAL F900 Manual

19 September 2024

Citizen CAL A660 Manual

15 September 2024

Citizen CAL E00X Manual

14 September 2024

Ur Manualer

Nyeste Ur Manualer

Orient Contemporary ER1U002B Manual

9 Juni 2025

Orient Sports UG1X007B Manual

8 Juni 2025

Orient Sports UY07001D Manual

8 Juni 2025

Orient Classic RA-KA0007L Manual

7 Juni 2025

Orient Contemporary ER2G002B Manual

7 Juni 2025

Orient Contemporary UNA1003B Manual

6 Juni 2025

Orient Contemporary ER1Y001W Manual

6 Juni 2025

Orient Contemporary SZ3N009W Manual

6 Juni 2025

Swatch Climber SFK300G Manual

6 Juni 2025

Orient Contemporary UNG8003W Manual

6 Juni 2025